- FD roll cage in FC
- Mazda just called... My new S5 seatbelts are in... So how do I remove the interior?
- Apexi ws2 exhaust/mufflers?
- FD Intake manifold on fc questions...
- Save the Rotary Engine!
- GXL Headrest removal
- electrical problem: starter not getting enough power
- gilmer drive with a/c? is it possible
- Anyone know the Size of the 3 screws to fit ACV block off plate?
- Interior Experts
- Fuel system recommendations for GT35R?
- Smooth idle out of gear, rough in gear
- Members who HAVE DONE this swap (S4 N/A to S4 Turbo)
- Remote mount turbo FC3S
- need new powersteering pressure lines
- wire purpose
- oil leak...from transmission case...scratches head????
- Exten manifold removal
- Reverse and 5th gear detents
- Front coil wiring
- Does anyone make 50mm front FENDERS?
- Idle 90 Rx7 gtu
- S4 TII to S5 N/A chassis, feasible?
- Car bogs out after 12 minutes with check engine light
- start up problems, then surging/lunging when giving it gas in gear
- typical starts and dies issue
- partial throttle stumble?
- t2 question is this possible
- Rotary Housing warpage
- Automatic transmission options
- 10th anniversary badges
- Searched: Weak Heater
- Dash Swap Shift Up Light and Buzzer Stay On
- How to remove the headrest
- gxl and turbo 2 rear end
- T2 intake O-ring dimensions
- E 85 Fuel
- Tried to use a cig tire pump, now cig/clock/rear view mirrors won't work
- Can I still use this side housing?
- ls1 coils
- Best Budget Clutch?
- Noob Needs help , 90' s5 GXL
- moister in my crank case?
- Do they make REW to FC engine mounts..anywhere?
- Grounds? Rx7 FC
- Mazda Speed Coilovers Rx7 FC
- Bearing press tool
- Ebay light weight flywheel
- Check Engine Light
- Lose bolt on Exhaust hanger C. Stripped? PIC
- I crushed my heater core inlet!
- Check engine light
- stripped lim bolt hole
- am i screwing up coolant flow?
- 1988' Rx7 FC Problems
- Air Temp Sensor Thread Size
- Bushing Kit
- cable speedometer to digital
- Won't start-no nothin when turn the key
- Porting template suggestions?
- Quick question on Fluid for 88 base open diff. Redline 75W90NS vs 75W90
- JHB Performance?
- Quick electrical Q... before I actually proceed
- Trunk lid struts
- Value of my car? 1987 FC3S T2
- how to tell the difference between low imped harness and high imped harness?
- 13B build
- Whats this vert worth?
- NEW DIFF Recommendations.. HELP
- New ignition key and locks
- 88 N/A No start, ONLY headlights and interior lights come on
- Rebuild or replacement hatch struts
- so i had this random idea
- rebuilt turbo - working , now its seized?!
- Would this be a dumb setup... na s4 RB Road race true dual header to single exit?
- Bilstein Shocks
- JDM S5 13bTurbo: Whats the best port/nipple for vacuum/boost reference???
- 2 rear housings 13b t2
- Powder coating CAS
- What Wheels Fit?
- bac/idle adjustment s4 t2
- Door panel pins broken. Where can I get new ones?
- pulley questions s5 t2
- Added some BG 44K into tank and after full tnak of fuel hard to start?
- ~6500rpm hesitation - S5 NA - done lots of searching
- My appreciation story for this website!
- Slow/difficult starting 88 NA
- Steering: Not returning to center
- Housing sleeve separation?!?
- What struts/bushings to buy?
- 2 quick questions.
- Unseizing a 2 year sitting motor?
- t2 starting issues
- removing old caked on gaskets
- Mazdatrix Stainless Steel Brake Lines
- oil catch can hose size
- So a couple questions
- power loss. just curious
- rotor housing wear?
- OEM dummy light lens on fc front bumper
- Water Injection Pic Request
- Anyone have any idea what BOV/BPV this is?
- Confusing hesitation
- boosting issues? PLEASE HELP.
- sad day yesterday
- Bolt that goes through DTSS need answer asap!
- Back to Square 1
- M.I.S.S.I.N.G P.A.R.T of my suspension!
- Wiring Harness Help
- Rear lateral links; where to buy?
- rear sub-frame nut/bolt size?
- How do I get to rear coolant fitting on turbo (to water pump)
- 2.5 vs 3 inch downpipe
- Convertible Brace
- DTSS bolt size/thread pitch?
- Writing off my second FC...
- heat shields/heat wrap/turbo insulation
- reuse coolant rings
- 2800-3k sputter and hesitation
- Things not lining up with BNR
- Buzzing??
- Really need some help on boost creep (external gated)
- Horn blows tail light fuse
- Complete S5 parts into S4 Shell
- hot start issues, another possibility
- Stock FC exhaust piping
- Time for a rebuild, engine parts help.
- Is this a HKS MAP sensor?
- Tial 44mm MVR Spring Question
- atf
- Failing leading coil?
- Rebuild wont unflood / stop flooding on first start attempt
- fresh rebuild wont start
- So I did her in
- WTF is my Crank angle sensor connector. And guess this wire.
- How much does a turbo hood weigh?
- New addition to the family
- Wiring mess with pics
- what is this sensor?
- Compatibility of Renesis parts in FC?
- looking for thread... Dude did "ghetto" rebuild with free parts from club members....
- Boost and RPM gauges not working
- autometer water temp gauge prob locations
- Bicycle in the trunk?
- Unusually long rotor break in period
- Transmission out, need advice
- Modifying stock RPM buzzer?
- Quick question on fpr routing
- Do I need a new tps?
- vacuum leak? (videos)
- Front Wheel bearing dustcap??
- Extra long steering rack boots
- s5 scattershield?
- stupid no start issue
- Gas Tank Pressurizing - Check & Cut Valve?
- A/M Stock turbo manifold? S5t2
- Alternator Wiring From Scratch
- have to rev past 4k rpm to charge battery
- no spark/battery ground wire is hot
- loud warping noise
- For those of you that removed abs...
- s4 na to s5 t2 swap question.
- Need help hole in housing
- Which one of you bought this RX7 ??
- memo on the S4 T2 throttle cable?
- S5 Anti theft CPU
- Exhaust help asap
- How to test tps s5 tII
- Oil Pressure Sensor thread type/size
- FD UIM for my S4 turbo, with rising rpm adapter questions
- What S5 model is this?
- S4 Twin Scroll BNR Stage 3.
- Problems Building Boost.
- Razo Shift Knob Install Question
- FD rear calipers on FC brackets?
- aluminum headlight covers?
- make your own Turbo gaskets? cheaper alternative?
- koyo radiator and aws temp switch?
- Powersteering is beeping but I dont want to realign the wheel. What can I do?
- injector o rings
- fpr fuel hose question
- Help with fuel pump
- Sensor that does not swap by oil filter
- Plastic vert headliner fasteners
- Would doing this with my CAI be more effective than the stock air box?
- How to: BAC Valve Removal
- Wiring FFE hall trigger kit into stock CAS wiring? And side mount alt belt?
- 1991 Rx7 vs. 1979 280zx
- battery relocation
- strength of turbo II diff and transmission?
- Power steering issue
- For those that had problems installing Corksport Oil cooler lines.
- Fluid leaking in driverside footwell
- Swap runs, won't rev
- Compressor surge (The bad kind)
- checking injectors
- diff application question
- 87 t2 newly found compression confusion
- tps led light connector?
- Speedo correction
- just a quick question about clutch sets.
- OMP line question
- s4t2 vert runnin lean
- wiring question
- wiring question
- Car cranks for a long time before finally starting up? Any help with this?
- Brake fluid leak question
- turns on. stumbles and dies when it gets hot.
- Stupid Alignment shop.
- easiest s4 6pi actuation ever...
- foresight replica wing?
- FD Twin Turbos on an FC
- anyone make their own dump tube?
- Code 20 and Code 26.....huge clouds of smoke on start up. videos inside
- problems with my oxygen sensor
- Gear/LSD swap
- S4 T2 Axle CV rebuild kit?
- Tach acting up, searched
- Water thermo sensor
- Anyone with a Holley carb on fc
- traction control
- Am I missing something?
- Who made the OEM struts?
- IDLE falls from 2k rpm to 1500rpm issue
- [S4 NA] Exhaust Strap
- capping off coolant lines
- Why no S5 LCA ball joint replacement DIY?
- Broken exhaust stud
- reviving dormant 13b
- "Rising RPM" IAC Mani
- s4 na missing idle mixture screw and water temp switch wires!! help please..
- ECU Ground and Chassis Ground, car wont start.
- 2 cycle oil? Synthetic or non synthetic?
- 1988 mazda rx7 n/a vacuum lines
- All the warning lights are on, but nobody is home.
- All the warning lights are on and nobody is home
- Coolant filler neck over the T-stat question
- anyone get bad rebuilds from BNR?
- white smoke....smells like fuel.No coolant loss.
- Exhaust questions
- what does this plug into?
- Coolant Buzzer
- Now what?
- Transmission wire?
- is it bad to remove the exaust heat sheilds?
- Seat repair shop near 626 area?
- FC3S computer
- Clutch pedal won't return
- Best fix for a brass filler neck crack.
- HKS EVC IV help!