Exten manifold removal
#1
Senior Member
Thread Starter
Exten manifold removal
1989 Convertible N/A. I'm trying to remove the injectors for servicing and installing Atkins sleeved in the 5 & 6 ports. I removed the throttle body and the upper intake manifold. I removed the four fasteners that the FSM show, along with all the hoses and wires (in spite of labeling, I hope I can get this thing back together), but try as I might, I cannot get the exten manifold to come off. Any suggestions are welcome.
Doug
Doug
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,826
Received 2,594 Likes
on
1,842 Posts
on the S5 there are 3 pieces, the lower, middle and upper.
i usually don't take the upper and middle sections apart, its a lot of work (as you may have noticed), and it doesn't get you where you need to be.
i take the upper and middle off as one piece, and in this case all you remove are the 4 nuts and one center bolt that hides under the BAC or fuel rail or something.
once you have the thing off the car, taking the upper and middle apart is easier
hope that helps
i usually don't take the upper and middle sections apart, its a lot of work (as you may have noticed), and it doesn't get you where you need to be.
i take the upper and middle off as one piece, and in this case all you remove are the 4 nuts and one center bolt that hides under the BAC or fuel rail or something.
once you have the thing off the car, taking the upper and middle apart is easier
hope that helps
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM