rear sub-frame nut/bolt size?
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
the Big nut that holds the subframe to the car?..it sits on a stud attached to the car?
That nut is 21mm.
The subframe gets installed on that Big "body pin"(hanging under the car) and then bracket goes on and holds the Subframe assembly along with that 21mm nut.The bracket is also held up by a 14mm nut on the Underside of the rocker panel.
That nut also attached to a small stud.
That nut is 21mm.
The subframe gets installed on that Big "body pin"(hanging under the car) and then bracket goes on and holds the Subframe assembly along with that 21mm nut.The bracket is also held up by a 14mm nut on the Underside of the rocker panel.
That nut also attached to a small stud.
#5
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I tried to get thread pitch but must have missed it looking at the threads on Subframe.
BUT I did find this "Just in case"..
Link: https://www.rx7club.com/2nd-generati...ctures-518052/
BUT I did find this "Just in case"..
Link: https://www.rx7club.com/2nd-generati...ctures-518052/
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM