Hey all,
Searched and couldn't find anything, I bought a pineapple racing block off plate for the ACV but it did not come with shorter screws, so right now I have it held on by 8 washers on the screws and 6 on the stud, and it is also leaking i believe. I am curious if anyone who has installed one found the correct screw size and pitch and remembers what it is, so I can pick up the correct ones?

Thanks,
David

 

pretty sure its an m6x1.0 and probably around 10mm long for a block off plate

 

They're probably M6 bolts...

 

If your original bolts have a 10mm head, they're M6 x 1.0.
If they have a 12mm head, they're M8 x 1.25.

Those two sizes account for about 90% of the hardware in the whole car.

 

Thanks IIRC they are 10mm, appreciate the insight guys, I'll stop by my local hardware store this week and pick some up

 

M6 x 1.0

 

Three oil pan bolts can work, unless the block off plate is too thick, in which case never mind.

 

Just to update anyone, They are indeed m6 x 1.0. I cant remember what length I got but slightly longer than 10mm with locking washers(Don't know if I needed them or not but I got them anyways) Also made a gasket out of a cut your own gasket sheet, paper/rubber mix and everything appears to be sealed up good now. Bolts fit great also.

Thanks!!