- Venting CRV to air good or bad?
- Heat Wrapping the Downpipe
- Replaced rear wheel bearing!
- Radiator Upgrade question
- Door lock timer??
- Voltage Stablizer + Grounding kit
- What is it gonna Take?!
- FD idle AFR?
- Can Someone Please Help - Vids Inside
- Loss of power at 4500rpm
- boost problems:
- Cooland buzzer on all the time. (help please!)
- Newbie question...
- found this..good deal?
- 1st problem
- 3rd gear 14-8-14-8-14 ect. boost pattern?
- just pulled the turbos
- I was so proud! But now denial,lol
- Rad cap question
- twin turbo specs
- Water temp Gauge question
- Stock bypass valve needed?
- Testing A/C Compressor
- Pettit ECU
- non-seq vacuum line question
- RX7 Security System
- Got the Downpipe on WOW!
- Fitting size - oil feed line
- Coil Packs
- coolant temp guage - aftermarket
- How can I make sure it's a FD engine harness
- Removing Coolant overflow reservoir
- A message from Ray Crowe......
- Boost problem, Please help!!!!!!
- help with spirit R mods
- no clutch pedal
- clutch question
- Sorry TPS issues....need insight please
- a little help with my fd
- $1750 '93 rx7 project
- fuel pump max pressure troubleshooting
- Greddy Ti Exhaust
- 320 hp a' stage??
- so all roads lead back to the FD
- Is this tune safe?
- My overhaul story
- Coolant lost + some minor splashes on engine surface...
- Special picture thread for 2007_0707
- My Tri-Power center gauge pod melted (PICS)
- 96 nipple
- Oil Usage
- Brand New AEM UEGO Melted in the sun!!!!
- Modification Problems
- **In the process of t2 diff swap** axle stuck in the hub
- Looking at buying this??
- Grounding Kit
- Generic winshield seals?
- Heater control issues
- Mid pipe question
- wierd boost pattern..... something new
- Repairing cracked intake manifold
- about 2 get a tune: need some help with Profec B II
- Help No Start
- Speed limiter cut
- CEL codes inside...
- How to tell if your cat is becomming clogged
- I want in..
- Is primairy turbo blown?
- Finally started up my FD!!!!!!!!
- door handle
- New Here
- Replacement rotors for +'99 RZ front brakes?
- Rebuilding motor
- I need help please!!!
- inter cooler
- I'm getting a SMB 4" to 3 1/2" DP and 3 1/2" resonated metal cat MP with PICS!
- O2 sensor
- Teh 7 never loses!But it DOES crash
- center console switches
- Electrical Help
- fd wire harness problem
- Buying an FD
- Thermoswitch default position?
- Possible? Boost controller is reading the BEFORE pressure drop
- Instrument cluster question
- exhaust leak sound, only when 2nd turbo kicks in....EGR?
- DP exhaust leak
- is it possible?
- my fd
- Got into an accident - need advice
- A/C lines w SINGLE TURBO??
- JDM Auto Engine installed, USDM ECU throwing codes.
- Help! Need info on AEM Tru Boost install
- Cat Question
- Need info on install of KS v-mmic.
- Key doesn't lock car (battery disconnected)
- removing the passenger door, How to tell the Gnome to let go
- Anyone have any pics of back seats?
- ARGGHH High idle! HELP
- Kudos to Ray Crowe
- Clutch or Trans??
- What oil??
- Help installing spark plugs/Brake pads info
- How Many Series 8's?
- MAP/MOP Sensor
- Vacuum lines, Where to start?
- ?'s w/ o2 sensor, closed loop, fouled plugs
- Front relay box
- Disabling the EGR valve?
- Sold the 240.....now I'm here
- AIR pump belt
- Mileage Meter Dead!
- I made the most stupid mistake and it popped.
- I know I shouldn't complain but...(MPG issue)
- cold air intake
- Help! Short shift installation.
- HELP!! Key broke in Ignition!
- Stock Intake piping vs aftermarket
- Advice on buying this singleturbo rx7. PIC
- Upgraded Apexi intake with mooing sound?
- FD Garage Door Mod
- Cigarette lighter fuse?
- Its Sooooo Hot!!!
- FD: What can you do w/ bad rotor/housings?
- Vented Hoods, Could They Increase Performance By Extracting Air?
- Intake temps..hot weather
- A few questions/opinions (and a pic)
- *SIGH* What would you do?
- Another "What do you have waiting to be installed" Thread.... damn laziness
- oil leak....
- Help me get my car running!!!
- Weird. whats going on?
- Progress Report
- Water found inside the car - passenger side floor
- To Buy or Not to buy, that is the question
- ADD WATER light and BEEEEEEEEEP!
- Engine wire harness picture w/connectors labled
- Help - what's the noise?
- Pipe coming out of cat?
- need R1 oil cooler line diameter..
- Gotham Racing vs. b&m short shift
- Time to upgrade IC
- Ebrake = high idle?
- fd ignition problems?
- Can you ID this connector?
- FD Alternator question
- weird air intake temperature readings
- engine wire harness connector identification
- A/C removal?
- X-14 question. is this a jumper harness?
- OMP, problem. Safe to drive?
- Engine response problem w/ VIDEO
- single turbo or twin turbos ???
- Blew my motor...
- beeping driving me crazy and running battery flat
- ignition switch removal
- AWS question
- Bad Brakes or Bad Bushings?
- Never over
- Block off plates install help
- Defi guages
- just started engine for first time....
- Who thinks this downpipe is better...
- GT35R A-Spec Single Turbo kit and Motor Build - Short Write Up
- HELP! oil catch can in FD?
- harness question...
- 2 broken wires
- is it the clutch???
- what rear end can you run???
- itermitent starts
- Idle problem
- new enginge wont run
- Auto vs Manual and diagnostics
- Where to get a aftermarket AST?
- 95-98 pfc work with 93-95?
- Over flow tank leak?
- Weird engine problem...
- Post price of your FD!
- Oil smoke questions (help needed, please).
- Christmas in July...kinda
- RotaryResurrection powder coating work pictures
- what do you guys think? buy or no
- Profec Install
- ceramic coated turbo housing pics
- Who has a/c
- Wiring Connector Question
- Need a little wiring help
- picture of harness request
- knock sensor question
- Turbo, Wheels And Bushing Woes [help Needed]
- Removed Air Pump
- something wrong with fd?
- A/c Problems
- Different RE Amemiya light kits
- RX-7 and 300ZX - Help?
- Speedometer Trouble
- Manual to Automatic Conversion
- R1/2 Seat Cover Replacement
- Car at Dealership - NEED HELP
- looking for bushing for the rear - not semi solid
- Stock Turbo Question
- pulled my airpump relay, car runs better now. Qs???
- Buying a 1997 Bathurst RX-7, just have a few small questions (pictures inside)
- Could my coils be bad????
- engine idle and coils question
- rx7 ? which model
- starting the new motor...advice..
- carbon doorhandles? any good
- maybe fix that incessant add coolant problem
- 5th gear syncro replacement cost
- Looking for a stocking sounding Catback system to replace my RB Catback
- HELP!! 28mi on rebuild+streetport BLEW oil seal!
- Pettit steering column gauge pod. Rip off?
- Heat wrap/turbo blanket for twins?
- Power problem window switch fixed.
- FMIC owners - Check your Power Steering Hose!!
- Cant find BOV part numbers
- Unorthodox pulley kit question
- water temperature sensor
- WBO2 TEST Article
- water in engine bay
- IC Endtanks (V-Mount)
- Oil pressure gauge.
- ---Any Info on Radiator World Race or Medium Sized Radiators----
- Best place to get 1" Diameter Hoses
- Custom Intake. Now getting low vacuum readings
- Are FD Oil Injectors easy to change?
- Clutch line fitting sizes
- Idle problems
- new gauges
- Engine condition question
- Best $200 I spent on my FD...
- Where to find fender liners.
- Engine Code 9 : Thermosensor
- serpentine belt lengths?
- New member
- Is buying a rebuilt 13B that has sat for 1 year a good idea?
- good old doorhandles
- So my mechanic says i need a new ECM...
- Car wont start up again when warmed.
- Downpipe Comparisons
- can't find these 2 hoses in the vacuum hose diagram
- Downpipe Difference?
- Midpipe/downpipe Support
- Synthetic or no Synthetic?
- Downpipe mid pipe install??
- Mahjik, rynberg, dgeesaman, anyone?
- Need Info On Front Mount For Fd
- Car stalls when compressor comes on.
- Interesting MIL