- Smog - idle is too rich
- 13BREW shipping from US into Canada
- Electrical problem, seat belt light, windows, - may be the cold?
- What temperature will my car run at with this set up?
- Clutch hp rating ?
- Thermostat Issues
- Electronic boost controller solve?
- Signals Don't Work
- Belt size for underdrive crank pulley?
- Abs
- How much would it cost to fix this interior
- reliability build
- does my motor have large streetport?
- ok ive almost had enough of this garbage
- single turbo reliability
- ** Intake temp list with M2/ASP/PFS SMICs! **
- Who has reinstalled a cat after running full exhaust
- question about dynos
- New Rx-7
- metal LIM gasket blown??
- Dealer screwed up my car after clutch job
- name that part
- coolant burn on start up!!! HELP
- Group buy thread deleted?
- OMP Repair Leak? :scared:
- Air Pump
- Trans input shaft play
- Vaccum question
- How to check if OMP is working
- twin turbo question?
- my general knowlege thread
- ABS out
- I need the 93 FD Alarm Wiring Diagram
- unrelated issues: Lots of ?'s for you smart guys! Smog, electrical, interior, airbag
- Help! coolant leak!
- where can i find these splash guards?
- Fuel vapor separator
- FC coil an upgrade? Stock mounting holes?
- Twin turbo upgrade
- Eliminated coolant flow through TB and now my idle isnt right
- Problems after Poor mans conversion no boost
- Why does it smell pig rich?
- DP bolt size
- Fuel injector help
- R1 Strut Bar Dimensions
- Kumho Ecsta MX----feedback from guys with experience running them
- Exhaust Burn Shield
- Plugs keep fouling on recent rebuild...
- 99 spec oem rear spoiler
- Blank Odometer
- Spark plug help
- engine porting where to get a good job
- Any difference on interior panels between year 1993-1995?
- Stock 13B Rebuild w/Sequential Twins
- hesitation at 1900 rpm
- Can't decide
- Anybody ever done this?
- fuel guage
- Installed New radiator. now I'm running hot?
- Pealing Satin Finish Remedy
- What hole do you guys use to run wires through the firewall???
- 99 Spec foglights
- difference between 13b & 20b
- Knock sensor leak?
- Electric Supercharger?
- How do you remove the handbrake handle?
- Need Wiring Help JDM --> USDM
- fuel additives Q
- oil filter brand Q
- Turbo to intercooler coupler
- seq boost controllers?
- street port
- odd hesitation at 3000+ rpms (not the usual one)
- Quick answer walbro 255
- WTB ---13 stud kit for my rebuild
- Just Bought A 94 Red Fd
- Rebuild kit- Atkins vs. Rotary Aviation
- Look what happen to my turbo's!!
- Fmic vs smic
- rtv?
- Wiring Harness Guru's Help Please
- TT vs. Seq. on aftermarket ecu??
- How do to remove the driver side door pocket?
- How bad is this? cracked turbo flange
- Things to look for when buying a blown 7 (yes I searched)
- shops in cali
- Test pipe fabricator
- bumper fitment question
- RX7 help ... WHEEL INFO
- Is this something I should worry about (possible scam?)
- Installing some DRL's in my RHD, need a little bit of advise...
- How much would a complete.......
- V-Mount IC sizes
- Looking for a specific wing...
- Want to keep your FD cool?
- 2nd Turbo -- Does it Hurt Anything?
- Interesting Intercooler Piping Set-up
- headlight cover on 93' rx7
- Some backfiring problems.
- Will new bushings solve the problem?
- Battery relocation questions
- 99 spec - Series 8 suspension
- 200km/h vibration
- Total weight savings from removing A/C and P/S completely
- Making spark plug wires with the MSD kit
- Intake Setup
- Disassembled my engine...
- To sell or not to sell?
- Very confused need help removing P/S.
- The Shop OVERHEATED my engine!
- what is a good apex seals to get
- Help, car won't start.
- another quick question
- any suggestion please
- WOW! HKS Service two thumps up!!
- turbo timer with fan controll?
- Broken door handle question/fix
- How to adjust the handbrake?
- Break in question
- 2001 rx7 rz
- custom diffuser
- my fuel gauge is not working?
- Engine gone south?
- 200MPH Club
- Massive blue smoke on startup, PCV valve hopefully?
- Rotary Extreme v-mount bolt up
- Going To Pick Up My FD From The Ports Tommorow... Advise?
- Im starting to hate my FD
- Radiator World radiator oppinion
- trying to pick a new clutch HELP
- Missing hose?
- porting wastegate now BUT
- Lights stuck up! FD
- Boost Problem:Found problem but need help
- high flow exhaust, PFC retune?
- ok, possible turbo issue......thought?
- boost controller and power fc?
- Can Mazda dealer cut new keys with just the VIN #
- FEED style front fenders
- Armor All + Dash = Not a pretty sight.
- OEM Skirts?
- Ebay parts warning - inexpensive hatch shocks
- Factory Ignition Timing?
- What should gauges be reading
- Apex Seal ?
- Rebuild ?
- Top Speed ?
- Does the A/C compressor have a connector on the wire harness?
- how do I get idle back to stock spec, also vacuum question
- About to change oil...how about Greddy 10w60?
- Engine rough idle, black smoke. Common problems.
- couple of noob questions.
- Wastegate and electronic boost controller?
- engine heating up!!
- Nice & Cheap PFC Commander Holder
- A/C not working after steering wheel replacement
- little boost issue.
- effini y pipe part number
- Which intercoolers use stock piping?
- tie rod bushing clunk
- Help installing Twin Power
- rough idle
- For those with the Rotary Extreme sleek lights
- stumbling after warm up
- Sleepy eye headlight kit
- 2500rpm. Idle
- Leatherseat.com install help
- Fuel Door does not open
- posible boost spike?
- Race Videos
- Buddy Club Spec II- need a little more info.
- looks like I need a new radiator...any suggestions?
- 99+ Bumper/Signal Light question
- 3inch intercooler piping, too big?
- strange squeak
- Most suitable model for use as a race car?
- Anyone know where to get a floor pan?
- Pressure chamber in way installing KGparts sec rail
- HKS Rs intakes
- Removing UIM for upgrades
- 99 spec foglights and oil cooler ducts
- VIN info and history
- 4 wheel balance/weight?
- Missed 4th today
- Car is running hot...90c-100c...why?
- Smoke on decel??
- Rebuild Time
- Help, boost issue!
- 4 sensors on t-stat housing??? 93 fd
- Can anyone identify this sound correctly?
- Cant find the leak...
- FD Dropped... One side lower still seeding?
- Coolant Freezing point
- Quick question about hose sizes
- my Power FC, LC-1, datalogit wiring diagram
- New Mazda logo question?
- vac pipe configuration????
- Yes another "please confirm my worst fears have come true" thread
- EBay Oil Coolers
- urgent need of wiring diagram
- aftermarket oil pressure gauge
- Maximun Ignition Advance.
- What is this bracket for
- Good Defi coolant temp spot
- Removing ABS to install (Garfinkle) torque brace???
- anybody with a picture of RB exhaust installed??
- Mazda Reman Lasting
- keyless entry system
- Fuel Line Question
- Fuel starvation on tuning pull....
- Looks like I need a rebuild?
- bringing a jspec fd to the states?
- radiator hose size??
- custom brake resevoir?
- Boost Lag Issue
- Power Fc VS Aem Ems
- what 's that parts call (re upload photo)
- Wastegate porting with a Dremel
- Braided Fuel Line
- R1 Oil Line Routing Pictures
- Installed new tein hood dampers, Greddy IC piping and Type S BOV
- Question (water treatment)?
- Pics --What is this Connector??
- Differences: JDM vs. USDM main engine harness
- check engine light on..... OMP
- opnions while waiting for dinner to be served!!
- How To Do This?
- 3-bar Map Sensor Needed?
- PFS Race SMIC vs. ASP Large
- Bose Speaker Output @ Harness?
- Is the FD suitable for a daily driver?
- Pics of Wiring Harness: Pin Question
- what 's that parts call (with photo)
- weird idle after rebuild
- ebay catback system??
- Second Turbo not kicking in!???
- Greddy profec spec 2 not working
- Fuel Cover GB Interest Almost Complete! GET IN NOW! Limited Time Offer!
- Can you use a non-turbo exhaust on the FD?
- Simplified turbo system - worth the trouble?
- Pineapple Racing, still in business?
- eastbear or RE
- intercooler kit **WEIGHT**
- Custom Vmounts!
- Anyone use turboimport.com?
- question about harness
- part number right or wrong?
- Tanabe Medallion Trouring vs. RB Dual Tip
- Radio Headunit Switch -- No Sound?
- PFC Negative Air Temp.....WTF