Rad cap question
#1
Full Member
Thread Starter
Join Date: Apr 2007
Location: saskatoon sask
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
Rad cap question
My OEM rad filler cap rubbers seal was looking rotten so I went to a local shop to pick one up and I noticed that the new cap has a relief spring on it like the ast Cap. I been driving on it for two days and everything is ok but I was wondering if I should go back with one without the relief spring? Will this harm anything? The cap also shows 16Lbs. The guy from the local shop said that was the correct one.
#2
Boosted
iTrader: (8)
Join Date: Apr 2006
Location: BC, Canada
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
I can tell you right now the guy at the shop you went to is wrong. Go here and you'll know.
https://www.rx7club.com/showthread.p...t=fd3s+cooling
https://www.rx7club.com/showthread.p...t=fd3s+cooling
#3
What's your point ?
Join Date: Feb 2001
Location: Gainesville, Fla.
Posts: 3,573
Likes: 0
Received 0 Likes
on
0 Posts
Two cap, one has no pressure seat (just a plainc cap) this one goes on the fill neck on the thermostat housing. The second one is the pressure cap and goes on the AST. Running two pressures caps is incorrect.
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM