- Rx7 n54 swap
- Rx8 fan motors
- 99 spec bumper install. Parts list?
- 5speed, automatic waterpump asemb difference
- Best "Racing" Seat For Bigger Guys
- anyone got 99 spec oem skirts to fit with feed front fenders?
- Please help identify this connector for FD
- Rebuilt Engine Install - Ran for a bit, now won't
- shifter rebuild kit parts list question
- Heater core block off/valve
- What the hell is this part?
- How to calibrate Rev Counter?
- IRP motor mounts install question
- surge tank fuel pump wiring
- Question to all Trust Greddy V-Mount owners
- M2 Rollbar: Rear Strut Cap Hole Cutting?
- Ignition power stays on with key off and removed, dash lights dim
- Efini Y-pipe issue
- How to fill in air control valve passages?
- Low (Cold) Water Temps while Driving
- New Highest HP BNR Stage 3 Record? - 456RWHP On Mustang Dyno!
- Need help with ground locations
- having trouble after new rywire harness installed
- FD leans out when it hits 5 psi, please help me solve this
- interior panel metal clips
- XS Power Mid Intercooler
- BNR Stage 3 Sequential - Current RWHP Record?
- this isn't good...rust in the spare tire well...
- Fitting ID injectors with OEM type lower cushions
- Rear hatch rattle
- 413whp on BNR Stage 3 Twins
- Nice looking and functional alternatives to OEM Hood Insulator?
- fan only works with ac on /grounded relay
- Front window Bosch Icon wiper blades – 20A vs 20B size
- Seal/gasket for feed type 2 wing
- need some help with power antenna...
- Rough Idle
- No start
- Proper cold idle?
- Transmission Connectors?
- Part number for headlight shroud?
- Fuel pump wire harness – plug part numbers?
- Need help diagnosing rich idle
- no spark on either leading coil with aem coils
- What inputs does ecu need for idle control valve to work
- Thoughts/Ideas/Suggestions for alternate locations for ignition coils
- Flasher / turn signal problem?
- FD3S opinions
- Oil Pressure at WOT - What should it read?
- Misfiring
- Airbag Light On
- tire age a concern?
- HKS Twin Power PNP harness
- Idle Speed Control Valve delete
- properly seal oem oil cooler duct ?
- Alternator relocation
- FD will start on adaptronic ecu but wont start on stock ecu
- Can You ID this Sound??
- Heater core repair: How much PSI?
- Koyo Installation Tips
- How to Clean/Flush Oil Coolers
- FD OEM red leather solution
- Front Bumper Attachment Hardware
- How to properly setup helper spring?
- Making side ducting for rad: Need advice
- 95 A spec motor in to 92 JDM car. Fuel Thermo Sensor
- BNR Stage 3 Turbo Upgrade (2016)
- where does this wire go?
- Revival hiccups
- More headlight woes!
- Solenoid problem? Check valve? Dyno chart inside
- Transmission question.
- Shaving engine bay
- sleek headlight adjustment
- Missing main engine ground and split air tube part number
- over heating issue
- Dashpot adjustment?
- Headlight pop up intermittent
- Exhaust/Vacuum Leaks?
- Alternator wiring
- Backfire wont rev past 4500-6000 and PFC looses power and rests the controller.
- strange sound after clutch install, clutch not engaged
- R1 oil coolers install help plz
- 1994 Drivetrain locked up
- electrical issues after dash and front harness swap
- OEM Brakes for Track use?
- Which main- and rotor bearings (clearance/size) do I need?
- Blitz Intercooler Install
- Stock exhaust manifold pressure?
- tein mono sport with edfc active pro or ohlins dfv?
- Speeds up to 4000 rpm and from there, loses power
- Crankcase vent system can leak oil on track?
- EBC Bluestuff vs. Yellowstuff
- what is this swollen hose part number
- Oil Cool Lines
- Knock sensor plug wire orientation?
- Reading AFR’s using the O2 sensor port?
- not stuck handle but latch ? driver side
- Found out why my engine was losing compression
- Diagnostic process - Am I particularly stupid?
- Need help routing ignition switch connectors
- Suspension Setup: Tein Flex
- Peter Farrell intake--no air pump filtration?
- help identify what i broke and a new no start issue
- Restrictor in ABV
- Caliper rebuild help
- Pulling UIM for Injectors - Other "While You're In There" Tasks?
- Need Help with Clutch Bleeding!!!
- Coolant drain plug on center iron housing of block
- Pettit Unlimited Ecu. Rich or Lean?
- Rev counter going crazy!
- Hose Clamps!
- Bad brake master cylinder?
- What clutch are you using these days?
- Key ignition chime
- Pulling front fenders up to a inch
- Engine goes lean maybe TPS? Please help
- Size of transmission drain and fill plug
- Quick question about CatchCan install
- FD steering issue
- New build - initial start up - ECU Coolant temp vs. Rear Iron Coolant temp question
- wedge collar snap ring
- Oem headlight assembly
- Welding cracks in stock FD exhaust mani
- Plastic piece by side mirrors?
- Another smoking FD...
- Idle getting stuck
- Fuel rails
- Calculation of 99 spec downforce and lift.
- Relay clattering behind dash
- Front wiper mechanism removal??
- Rattle at idle after ac compressor changed
- Attaching duct to oil cooler
- MOOG-512118 question (rear wheels)
- Phenolic LIM to UIM gaskets
- Best fast acting IAT sensor options with Adaptronic ecu
- (new, not used) intake/airbox opinions?
- Upper Intake Manifold Questions, Part 2
- Sakebomb EWP vs Turblown
- Vibrate on clutch paddle issue need help
- Whistling / Whirring noise, varies with RPM
- Bought the factory mud guards. What Hardware??
- Emmission removed, using resistors on solenoids
- windscreen scuttle trim removal ?
- FPR solenoid, double throttle etc
- Oil pressure; how high is too high?
- Bleed Clutch First, then Bleed Brakes Afterward?
- **Tranny & Diff Fluid** What do you recommend?
- Center console
- Twin power wiring
- MAP Sensor connector
- What size air fitting/ vacuum line sizes for Tial Q?
- How to fix loose threaded insert on lower seat cushion???
- Rotor housing sealing surface
- E85 Questions: Is it right for me?
- Bose -- will it work without center amp?
- Making a custom downpipe
- Inspecting ball joints and tie rods?
- PLEASE CONFIRM: using JDM motor +JDM ecu on us fd
- Power Steering Cooler + VMount
- Stainless Steel vs. Mild Steel Downpipe & Mid Pipe
- Emission failed. AIRPUMP direct to Cat without ACV??
- Fuel cut symptoms at 8 psi
- Stock O2 sensor ---- for emission
- Greddy TT Intake Filters
- Size of coolant temp sender?
- 400whp with an EFR7670....on 93 pump. Possible?
- Apexi FMIC performance
- Advice for cleaning out the intercooler?
- Mounting AST with Blitz SMIC
- Trouble Starting / Lead's not Firing
- Effects of driving without a t-stat sensor (snapped)
- Secondary turbo basically free boosting ?
- Slow windows?
- Upper Intake Manifold Questions
- Idle issues & Blowout of steam
- Wiring Gurus - Help Needed!
- Aftermarket ECU: Air Pump
- M2 medium duct
- What to do while engine is out?
- O2 Sensor Replacement
- Innovate LC-1 calibration
- Stripped front subframe bolt hole
- Fuel dilution of oil?
- Knocking noise from rear end Please help
- Turbo Problems (Yes, I've searched)
- Dyno Comparison For Each Part Added
- Checking cooling fans
- How to make ducting for oil coolers?
- HOW TO: Handbrake Removal & Replace
- Ignition
- Handbrake cable replace.
- Question on priming the fuel system
- Front Brake Caliper Pistons
- eBay diffuser install?
- strange overheating problem + running straight water
- What coolant temp gauge + sender are you using ? Looking for reliabilty and value
- BNR S3 installation questions
- Does anyone Know the loaction of CPU.2 on the JDM FD.
- No Start - Good Batt, starter spins but doesn't engage
- 93 fd shutoff issues
- Transition problem
- Boiling in Coolant Reservoir
- JDM Center Console Buttons
- No start, not even a click 😡
- FFE Secondary and Bosch EV14
- Another boost thread
- Twins smoke at idle
- Help Please- Both Power Windows stopped working at the same time.
- Throttle Getting Stuck? why
- Stack ST 81xx Questions: Sensor placement, signals
- Boost issue
- BNR turbo from group buy
- Sohn OMP adapter question
- How much backlash should the differential have?
- Correct position of timing plate?
- Aftermarket ECU with twin-turbo support
- Fd abs sensors
- Electrical/ engine quirks 93 13b single turbo
- Testing IAC
- Alternator wire boot Part number?
- Ideas for my exhaust?
- Charge light
- FC Thermoswtich
- Airpump to Cat directly?? without ACV is possible??
- what injectorhat to use on ID1000?
- No oil pressure wierd noises
- What happens when....
- Anyone Driving on 245 / 45 /16
- fd3s Omp struggles
- Rx7 to Rx8 parts?
- ps/ac idle pulley long bolt size
- about to sell, fuel and spark issues
- Auto and Manual Transmission Harness Pics?
- Crazy Wiring Issue, wiring gurus help!!
- Fuel pump rewiring and AFR Q
- Exhaust Manifold to Block Studs
- Weird fluttering sound at idle?
- Carpet still available and where to buy parts?
- Evapolative Hose Diameter?
- Testing flex circuit board on back of gauge cluster
- 95 RX7 front bumper undertray issue
- Make your own plug&play adapter harness for 99-spec lights
- I'm stumped on a couple of footwell electrical connectors ...
- Series 7+ (No Primary Boost) Vacuum Solenoid Box (Failure, and information)
- airbag warning light flashes 7 times? not listed in diagnostic table
- Adjust headlight height (housings)
- Fuel Pump causing Rough Idle
- 4 piston calipers: 2nd gen dimensions vs. 3rd gen??
- r-magic ac condenser