I know this might be a dumb question to ask but i know you guys would give me the quickest answer. The small pipe that is coming out of the factory cat and goes up to the motor... how can i eliminate that? do i just take it off and put a block off plate or is there anything else that needs to be done?

 

Have you already eliminated the airpump and ACV? If so, you can remove the pipe, use a block-off plate and then you need to plug the line on the cat.

 

no i still have the polution pump.. is there a way to eliminate it with the polution pump?

 

If you have the airpump, why isn't it hooked to the cat?

 

just wanted to know if i could eliminate it with the air pump...

 

If you are removing the airpump and ACV, you can remove the pipe down to the cat and block off the pipe on the cat side.