- Uh.. Oh... I need some help quick...
- Car barely accelerates
- Time for new radiator?
- New to RX7club.. Should I buy this FD? *please read, advice needed*
- long Greddy gauges, flyrx7 tripod, custom rings
- Weird Idle
- Underhood Fuse 40amp B2
- 95 FD air pump part number
- How will my FD run with a series 5 Turbo?
- 5 speed conversion pedals?
- Help! Can't find a Cat for my FD!
- Power Window, Sunroof, AC lights NOT WORKING
- will not crank, will not anything.
- Air Intake Temps
- Stock injectors
- Best Exhaust
- need advice on redline water wetter coolant.. any good
- What Huge Fuel Regulators are available?
- I need electrical help!!!
- Problems with idle and reving
- Engine missing under acceleration running out of patience & money
- Rotor / rotor housing cleaning
- Cooling Issues After Rebuild! Need Advise
- boost pressure problems. HELP!
- Need some help (oil filler neck nipples)
- Passenger Power Window Switch / Intermittent
- shifter bolt question
- Rear subframe Torque specs?!?!?! ARGH!
- were does this pipe go?
- I need some exhaust advice.
- oil leak and weak boost. any ideas?
- boost gauge reading at idle?
- Quick downpipe question?
- Some questions about M2 intake.
- Daily stupid question: ECU plug
- What box is behind the egi relay? Pic
- copper crush rings
- Fuel Odor
- Belts too tight. Damage??
- idle problem
- Cat back exhaust
- Coolant and boost issue! :)
- Custom LED tail lights
- Two questions
- Top feed primaries, rails and seals
- rotary vs. v8
- Building a Fuctional FD From a Roller
- Transmission Probmlems R & 1st
- filling transmission, can anyone help?
- first dyno on fresh rebuild / non-seq - untuned
- New Member
- high milage
- another question, rebuilt first start
- FD3S Practicality
- need help car wont run
- RE Amemiya filter replacement?
- power is going down.... help!
- not your normal transmission noise!
- does anyone know were i can get the feed engine torque brace
- OEM injectors saturated... brand?
- secondary sputter
- Turbo problem please help
- Running w/o O2 sensor?
- first start after rebuild, sounds like a vacuum turning on
- Clutch noise?
- Non vented hood vs Vented with V mount
- So I stripped the turbo manifold nut -- now I'm all out of ideas! (with pics)
- Back in Biz, just purchased my new FD
- AVC-R sensor and solenoid locations
- Car turns off randomly
- Help me get this car started!
- Anyone else had RC 1300CC injectors stick open?
- Help buying '99 combo lights to bring them to Peru
- Drum of methanol for $285.00.
- I have the chance to buy a JDM Spec rx7 which one to buy
- Leading and Trailing coils firing at same time? Any suggestions?
- Where to buy Y pipe for stock turbo setup
- bad breakup at 10psi
- what is wrong:(((??
- Is the FPR bigger on FD than FC ? Walbro
- Choice of Clutch
- Help with Ignition System Diagnosis...
- Electrical Gremlins in our FD
- Wierd Idle after pull *Sugestions pls*
- engine mounts
- fixing the heater
- fixing the heater
- Does this WHP figure seem ok?
- Over boost even with MBC all the way out.
- Boosting 10-6
- intercooler help.
- Primary fuel rail from FC fit?
- Turbo problem or clutch slipping ?
- Low idle with A/C on ?
- hey guys need some help !!!!
- part number 99940-1001, where are you?
- WTB: V-mount
- 93 rx7 passanger window is stuck down
- How to duplicate this intake setup
- Things you should check before buying an FD?
- oil from nowhere HELP
- Need help for 400whp RX7 build
- FD reliable?
- Installation guide for water temp and exhaust temp gauge
- Do i need to repalce any gaskets when changing spark plugs?
- Pineapple Medium Streetport
- Newbie... question with hesitation and boost problem
- Check this out
- leaky injector?
- Pettit ECU for my JDM car?
- Where to go through firewall- AVC-R install
- screaming belt syndrome
- pulling turbos?
- catalytic converter identification?
- cleaning housings for rebuild
- how to: brake pad replacement
- installing my fuel system, and ive got a question.
- Speedometer reads high but Odomoter and Trip meter are fine???
- Gearbox Additive
- '93 Build Progress PICS
- Check engine light on - Code 16 HELP
- idle issues
- Help with a couple of little niggling problems
- Anyone tried out Tokico lowering springs?
- missing vacuum chamber
- Really High Oil Pressure?
- Cold start
- Car wont crank
- Sequential vs non-sequential
- What guages are necessary to have mounted?
- Pettit Starter Booster
- FC1000 by Jacobs Electronics Ignition system
- Car wont start
- Quick question about alternator pulley
- Weird Starting Problem Battery Related~Need Help
- Need Help Again! Lost my Dash lights and tail lights
- 2 questions
- European Vacuum Diagram?
- Need Help! where can i find a copy of an online FD Service Manual
- oil filter housing banjo washers
- How long do High Flow Cats last?
- AST installation
- Enough?? 400-425rwhp
- UIM Simplification. Questions in bold.
- Ignition switch light help?
- Static electricity ground panel in door?
- Question any help is greatly appriciated!!
- Source for vacuum hose and fittings?
- will i be ok without boost controller
- No Boost!
- headlight confusion
- more bang for my buck!!!!!
- Upgrading suspension, anything else I should do at the same time?
- WTF... can't remove fuel pump connector!!
- Crack in Stock IC pipe? (pics)
- radiator cap ?
- Pressure Test - Air blowing out of dipstick hole? Normal? Suggestions?
- Something is leaking
- keyless entry (have reference thread, please take a look)
- pumpkin weight
- Limp mode?...bizarre
- Super quiet cat-less exhaust... (Atleast going to see)
- ABS Light Stays On Any Tests to Narrow
- Turbo Hesitation
- Air Pump Alternator Water pump belt with underdrive pulleys
- First start after rebuild: Turbo problem
- Need some help
- Disconnect airpump = car faster??
- V mount vs CF vented hood?
- KG parts secondary rail and bosch 1600 install ?.
- Bizarre Starting/engaged starter
- Rear washer problems
- Excessive Shifter Movement?
- fd solid axle
- Bad pulley?
- Installing rear stationary gear
- Car Wont start....HELP!
- Engine height raised with oil pan brace
- S5 13b swap?
- DP inside diameter
- What holes are these behind ABS?
- my car can't start...
- Where does fresh air enter into the cabin?
- Torque Damper
- A few questions before i put it all back together
- What milage interval should you replace "Fuel Filter"
- Choosing a Boost Controller
- Sealant and Grease ?s
- 5-3-6 first drive
- Boost leak on primary?
- problem with fuel pump and injectors
- Twin power versions
- Cooling Issue PLEASE HELP!!!
- FD blues
- Running without airpump damage stock cat converter?
- fd3s no spark
- Ebay AST??
- please help!! what is it?
- Leak or No leak?
- Loud woosh and some smoke
- Transmission Troubles...
- odyssey battery terminal????
- Please help Coolent sensor Buzz
- fuel trouble in my country.. need advice..
- Radiator fans not turning on
- Oil Control Rings - can these fail?
- Front cover gasket... use dry?
- smell of gas when driving
- Help me with my Goal
- fog lights without headlights possible?
- Getting rid of airpump
- Cost of Wiring Harness
- Apexi Filter Replacement Size
- Mounting AVC-R
- Spark plugs and wires
- Does anyone use 0w-20 or 0w-30 oil?
- Hose Problem
- Cruise Control Actuator How to test?
- Battery Cable Size Calulator
- FD going 180mph on a Mexican Highway - VIDEO
- Craft Square mirrors for fd
- horsepower and torque
- Wierd starting problem
- Part number mystery
- Rx7 1995 Automatic Idle Problem
- how to take speed limiter off
- does anyone know if the cooling fan relays were used on other make/model cars?
- Suspension upgrade
- i need to know what you guys think
- 2 quick ones
- cooling fan problem (please see the bold font especially)
- 13b rew swap wiring harness problems
- Missing Bolt on Steering Rack-- Size?
- small "big" problem with rear caliper
- Injector Pulsing and Fuel Pump
- mazdaspeed member brace set
- Squeaking!!!!!!!
- turbo dissassembly (turbo precontrol valve)
- What are you using to block off the Y-pipe?
- abs removal
- Starting car up when cold and its shaky
- This might be an old repost but the engineering here is brilliant.
- Noob mechanical question. + emissions removal
- thread question
- Question about really high oil pressure
- Got an email today...
- how to tell if injectors are seated?
- clutch help please
- Low oil pressure and no MIL
- Wastegate help