Instrument cluster question
#1
Senior Member
Thread Starter
Instrument cluster question
There are 4 locations on the instrument cluster circuit board where connectors are plugged into it. Can anyone who has had their cluster out confirm whether there is a short 3 connector harness that plugs into the 2 smaller cluster board connection points with a larger connector at the other end that plugs into a blue instrument harness connector? I can't account for the two smaller cluster connectors or a connector to the large blue connector behind the cluster and this is the only thing that makes sense. I have nothing to compare it to so help would be appreciated.
Thanks.
Thanks.
#2
Freudian slip
iTrader: (1)
Join Date: Aug 2002
Location: Pocatello, ID
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
I really can't understand what you just said but...
there are 4 connectors going to the back of the cluster
- 1 black and 1 white going to the drivers side of the cluster. These both connect to the large blue conntector in the dash.
- 1 large white connector that goes to the center of the cluster. It disapears into the dash.
- 1 black connector that goes to the pass side of the cluster. It also disappears into the dash.
- then there are 2 white connectors, one on each side of the cluster that connect to the buttons on each side of the cluster hood. One for the headlight popup and one for the cc (if you have it).
That is all the connectors that should be behind the cluster. They are not difficult to figure out since they only reach the connections they are meant to be connected to.
Hope this helps.
there are 4 connectors going to the back of the cluster
- 1 black and 1 white going to the drivers side of the cluster. These both connect to the large blue conntector in the dash.
- 1 large white connector that goes to the center of the cluster. It disapears into the dash.
- 1 black connector that goes to the pass side of the cluster. It also disappears into the dash.
- then there are 2 white connectors, one on each side of the cluster that connect to the buttons on each side of the cluster hood. One for the headlight popup and one for the cc (if you have it).
That is all the connectors that should be behind the cluster. They are not difficult to figure out since they only reach the connections they are meant to be connected to.
Hope this helps.
#3
Senior Member
Thread Starter
cluster circuit board, you pretty much confirmed what I guessed.
I'm missing a small 3 connector harness.
I'll try to source the part and hopefully get it running again.
Thanks for your help.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
15
09-08-15 05:30 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM