- The RX-7 Lives! Yummy idle goodness!
- Does anyone have a Pettit boost controller?
- FD3S Project Gizmo
- No reading on Intake Temp?
- boost creep question
- Seat Belts question
- 96-98 ECU pinout?
- No spark at all (faulty CAS wiring)
- My first rotary swap: some questions along the way
- what is this connector for?
- re amemiya
- Flyrx7 pod - what am i missing?
- -Wont start- ?????????????
- 1992 FD good deal?
- how to kennebell boost a pump?
- External fuel surge tank by Lucky 7
- No Vacuum at idle?
- 3rd gen tuning
- Why only 6.5 psi? Stock seq. twins...
- Finally got a FD: A Story WITH Pictures!
- 93 RX7 Coolant Question
- mazda stealership !! ?
- Help!! FD will not go into reverse!?!?!
- Turbo compressor erosion
- Fuel Pump removal
- home made idler pulley
- kind of strange rear-end action....
- [help!] Newbie Turbo advice
- newbie advice needed
- glowing turbos
- Ethanol fuels vs. FD injectors
- Some Fuel System Ramblings, 2011 Edition!
- Ebay parts for the FD
- Winter Build/Rewire...
- Roof lining question
- Coolant Light problem
- ems stinger 2r tach output?
- help: throttle bottle
- incase anyone was wondering (diff compatibility)
- Starting problems
- Best combination for good flow - less noise?
- Supra fuel pump on stock injectors
- Water Temperature Sensor and Gauge = no Continuity
- Dash lights out
- rebuild cost?
- Relocating the stock air pump
- Do I need to upgrade fuel yet?
- Buying a FD
- another hesitation problem
- info on removing the A/C
- bolt and screw replacements
- Is it normal for trailing plugs to foul worse that leading plugs?
- Mazdaspeed Intake Box FD question
- Squealing Noise w/video HELP!!!
- Buying a FD
- new fd owner in need of opinions
- any help for 13bt s5 housings in fd
- Oil Cooler Upgrade List
- Another Awesome Battery Draining Question
- Need to re-wire Temp Sensor, need help finding wire on ECU
- Rats nest removal parts list
- Alright guys I need your input!
- What purpose does this serve?
- How would I go about fixing this? (Door handle troubles)
- changing vac hoses and i snapped the tips off some sensors
- Speedo, Tach, Odo and speed read out on PFC not woking.
- Porting templates
- water in the hatch...
- vacuum line replacement parts question
- fd3s ebay
- Help me spend my money!
- Does anyone know what hose this is?
- harness the problem 2
- Solenoid Replacement
- Turbo Mainfold Questions
- Clutch Pedal Causes Airbag and Brake Warning Lights
- Write up or Manual on Heater Core replacement
- Deflood Procedure and Internal Steam Clean
- Hesitation at 5500 rpm
- Lets talk oil filter pedestals / adapters
- rear main seal
- respeed oil pedestal (2010 version)
- Drilling the pre-control pill
- Greddy Type S
- Downpipe or Catback?
- Picture request
- greddy fmic question
- LED turn signals? Mod your flashers the RIGHT WAY
- quick y-pipe question
- 93 rx7 Transmission mounts help!
- External wastegate option
- 19K mile CYM
- Okay, I just bought a 3rd gen last week, looking to personalize it
- RE-Amemiya SMIC piping fit
- HKS 6 Speed Dogbox
- vacuum line help
- Got a Stock engine question
- ACT clutch to buy from
- instrument cluster illumination gone
- Found some high-res photos of Scoot 4-Rotor...also it's for sale.
- Is this normal???
- 3 bar map...denso vs gm
- I have a question to all who own and built their cars.
- 3RD GEN no title getting rid of
- Target AFR's at idle?
- pettitracing updated there website!!!!
- 850cc in KG secondary rail
- Rear Wiper Delete
- 99 spec "aggressiveness"
- 99 spec fenders
- water pump pulley turning by hand
- heater inop
- boost issues only in 2nd and 3rd gear
- My CYM RX7/FD featured on IRPerformance.com
- Need opinons and facts on exhaust setups.
- premix
- touch-less car washes vs RX-7
- Diagnose This Ignition Coil
- Question about ganador side view mirrors.
- Clutch Bracket/Pedal Differences USDM/RHD
- Turbo to manifold studs
- Teaser vid of my completed build project!
- Anyone know who makes this intake?
- question on automatic to manual differential
- Question about short throw shifters
- Rapair broken airpump connector
- Clutch issue - what to do?
- How do I check my engine health from a Fuel Starve?
- Exhaust Question
- First time out this year for me, anyone else?
- Fast Help Regarding Turbo Manifold Gasket!
- AEM Wideband UEGO. Analog Output?
- JDM FD build
- Cruise Control buttons from a M5 Protege to my 99 Nardi Wheel wiring help.
- How to de-power your steering rack
- List of Sites that export FD's from Japan??
- So, I went to port my wastegate...
- Properly straping an FD to a dyno?
- What is a good company to buy a jspec engine from?
- My crazy Custom Cold Air Intake Pics
- Under Drive Pulley Installation Question
- where to get clips that hold:
- Aftermarket lighting help
- shifter for drag racing?
- Door hinge bolt sizes?
- Some Before and After Shots of My R2 Project
- Quick question about RX-7 models
- FD at 10mpg even with pfc tune?
- injector pulse
- value of R1 black suede seats?
- antenna info?
- Refurbishing Blower Motor Box
- what do you think about this clutch setup
- Injector Dynamics vs. Peak and Hold
- Compression and When to Rebuild
- Fender well covers
- Loss of stability above 100Kmh(60mph)
- What is this manifold for?
- Won't crank
- Any guides on how to remove gearbox?
- Need help on coolant issue.
- Spirit R name plate
- Cleaning the twins before installing questions?
- Series 6 & 7 transmission differences?
- Have you blown your engine, any idea why??
- what can we learn from the McLaren MP4 to better understand the FD?
- 3.5 PSI turbo Dead??
- Fabricated Aluminum Oil Filler Neck
- 1993-1995 comparison
- Fuel cell help
- Ideas how to create adaptive driving aids with a 5-speed
- parts suggestions
- fan relay box relocation?
- Engine Stud Torque?
- Are these cars really that "sketchy"
- Greddy Pulley Belt Size..
- locked out. damn :(
- newer mikuni OMP in old car with pfc?
- no thermoswitch in later models?
- Shine street diffuser and sumped gas tank
- EVC-S For FD3S ? Diagram? Manual? HELP!!
- Pinion rack removal
- OMP modification for the adaptor
- Oil leak IN main pully, Main pully removal
- eccentric shaft moves
- Advice needed: starting a long sitting car
- Suggestion for Clutch street use?
- Mazdatrix Oversized Stud Kit
- Speed bleeder for clutch?
- stainless steel door sills
- RPM/TC* MiniMeet ft Me & Aquinos FD
- Engine Wiring Help!!
- this is why you don't put threadlocker on banjo bolts
- Question about series 6 housings
- Castrol r40 racing oil for e85
- Car wont start...
- Gap above OMP?
- Charging Battery
- Inner Tie rod Question
- Mannykiller's Street/Time Attack/Drift Build
- gm 3 bar map sensor
- Fuel line help?
- R1 suede seat fabric?
- front cover teflon backup ring and o-ring
- main bearings cavitation?
- Headlight help
- Causes for intermittently running on one rotor?
- PLX Sensor Module/Datalogit Install
- Touring vs R1 sway bar
- Does anyone have hood dampers on a CF or FG hood?
- FD rear suspension help...
- Car ran fine till I went to mazda dealership
- Blinking seat belt warning light FIX
- clutch recomendation please..
- RHD coil placement
- Anyone use touch up paint?
- vacuum lines - help me confirm a couple hoses
- A/C Condensor Mounting Brackets for FMIC setup
- Where to find new solenoid valves
- v mount setup results
- Dash light HELP!!!
- Hard start and very rough idle after adjusting the TPS
- Info on my new setup
- A new stronger engine rises from the ashes, a true Phoenix in AZ
- Map pocket door fix - how to
- Squeal, possibly from alternator? & Ignition break up.
- Spark plug wires?
- just installed my cupholder
- vmount deflector design dilemma
- replace all check valves the same?
- V mount core size
- Help with new ignition
- A/f Question when cars turned off.
- front cover gasket or rtv?
- T1 plug sparks in test, not in running motor...
- Need 2gen fill neck for ast delete
- Vendor Thread; LED Tailights conversion???
- In theory (twin turbo setup)
- Car wont stay running or Rev past 3k rpms? Help...
- Fan wiring gauge
- Fuel cell pic request
- FD harness connectors?
- ORC clutch throw out bearing
- Glove box issues
- Turbo cracks-going back to seq
- how to flush oil coolers
- Speedometer question
- Ceramic coating LIM and downpipe question/opinions
- Scoot/AutoExe combo
- May need more fuel, change primaries or secondaries?