RX7Club.com - Mazda RX7 Forum

3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:
Full Detail Automotive

Stock bypass valve needed?

Thread Tools
 
Search this Thread
 
Old 07-08-07, 11:27 AM
  #1  
Full Member

Thread Starter
iTrader: (3)
 
IRVINE's Avatar
 
Join Date: Jul 2007
Location: Ontario, Canada
Posts: 89
Likes: 0
Received 0 Likes on 0 Posts
Stock bypass valve needed?
Hey everyone, I wanted to know if I can remove the vacuum lines from the stock bypass valve and cap the ends, so everything goes through my aftermarket blow off valve. I know you can do this with a piston engine but I have not seen it done on a rotary.

Thanks,

Alex
IRVINE is offline  
Reply Like
Old 07-08-07, 11:44 AM
  #2  
Moderator

iTrader: (7)
 
dgeesaman's Avatar
 
Join Date: May 2002
Location: Fort Kickass
Posts: 12,302
Received 16 Likes on 15 Posts
Yep, same. Just remember it's set up to open under vacuum. It is not used for boost control.

Dave
dgeesaman is offline  
Reply Like
Old 07-08-07, 12:03 PM
  #3  
Full Member

Thread Starter
iTrader: (3)
 
IRVINE's Avatar
 
Join Date: Jul 2007
Location: Ontario, Canada
Posts: 89
Likes: 0
Received 0 Likes on 0 Posts
Thank you very much

Alex
IRVINE is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Installed UIM gasket, now my engine won't run
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Realistic Danger of Exhaust Cut-Out? (Fire)
Monsterbox
Single Turbo RX-7's
22
07-29-22 10:48 PM
SOLVED E-Fan VS stock clutch Fan with FMIC
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
Back to Subforum
3rd Generation Specific (1993-2002)
View Next Unread
I was so proud! But now denial,lol




Advanced Search
Quick Reply: Stock bypass valve needed?


Reply Closed Thread Share

All times are GMT -5. The time now is 02:20 PM.