- Hood Prop Options.
- trust/greddy DP vs HKS DP
- question about mazda gaskets, seals, and o-rings kits
- okay help me out pls with rotor pad install q's
- how hard to drive with know p/s?
- NS turbos running 10psi on stock ECU
- ? about tranny on 93 vs. 99RZ
- Anyone using a catco cat.
- Air dam/deflector for engine compartment
- REar caliper pistons stuck?
- Leaking from "plug" on thermostat housing?
- Finnally finished with Engine pull...
- Twin plate Clutch ?'s
- profec B problem....no boost.
- Dynoed the car...need help!
- 112mph speed limiter jdm cars
- overheating
- why is my 2nd turbo coming in at 4000rpm
- Custon FD Inst Panel Thread
- When AC or Headlights are on, all the relays in the engine bay click rapidly
- a/c ps removal
- HKS BOV and RaceGate
- replaced throttle cable, fixed all kinds of problems
- Put my 7 up on Cardomain.com....seems like a hit
- engine smoking
- life with MOP bypass unit
- Air pump fuse??? Plz help!!!
- Power Fc Holders!
- very very strange problem, please help!
- Easiest way to replace Turbo Control Solenoid?
- Fouling plugs
- Koyo radiator w/ PFS Intercooler
- size of stud holding precat / downpipe
- Twin Turbos??
- Away for 5yrs - Store or sell perfect FD?
- Airpump failure?
- limitations of stock FPR?
- Lag Question (no dyno sheet please)
- I may have found a stripped fd...!
- Threw a belt. Can I drive it?
- Speedo Calibrating Question??
- Power Meter HP Rating
- A cursed EGR problem
- Rolling Fenders
- more NS questions
- Alternator Help Please!!
- what is this hose?
- replacement filters for a pettit intake?
- Abel Iberra and my day!
- efini badges question
- Could this be it (Fuel Problem)?
- ECU Wiring stuff
- Silencer for N1 Single or RB catback for quietness
- confused with compression #
- A/C R12 -> R134a retrofit: Where are the pressure switches and should I change them?
- do colder plugs mean longer warm up times?
- low idle rpm after restart when engine warm.
- need some help with an idle problem
- Trying to figure out where a harness wire goes...?
- Help me get a Series VII!!
- Link to some pix and mod list of my car
- new engine what to look out for??
- Re Amemyia Light Kit
- a/r exhaust wheel
- High/Low tach readings
- Look at this sweet ass FD
- Blitz SBC-ID solenoid
- O M G !!!
- intake manifold removal question?????
- Grease nipple location for Labreck bushing?
- need to clean my engine bay but how?
- Dex-cool?
- how do u remove the damn solenoid rack?!
- Another boost problem CAn anyone tell me what sensor this is..
- How do you get the gauge temp sensor out?
- non sequential ?'s (tried searching)
- fan mod w/ "updated" wiring ? (searched)
- Greddy Smic Duct
- how much should i offer for this fd
- Coolent line in throttle body (bypass)
- Pic of Stillen x-drilled rotors on FD
- Gotham Hi Flow Cat Installed
- UPDATE on air vent problem! need help a.s.a.p.
- Oil Pressure Sensor install?
- Issues. need advice
- Car back together, but....
- help. which way does the thermostat go?
- Every time I take the FD out I like it more.
- brake light coming on
- just did some new mods
- clunking from front end?
- wierd problem
- could it get any worse?
- retarded question, bare with me Im new at this
- wastegate fireworks
- Radiator?
- do FD's have limited Slip?
- rx7 turbo question
- Bouncy Acceleration...
- Finished vaccum hose job and now two problems..
- PROBLEMS: exhaust, cooling, boost
- Tracked the 7 at the strip today
- FD products....
- Smoke, lots of smoke!
- Stuck lug nuts?
- HELP!!!! No Boost!!!
- How do I break in a new engine?
- Another symptom of failed o-ring
- Seconary Boost coming on-line with a trumpet sounding noise WTF?
- Why so many rebuilds?
- Why our O rings fail:
- New Malloy Reman Problem...
- Passed smog from CA State Referee
- Stock Suspension questions
- Has anyone have this problem?
- Driver's door will NOT open at all
- Headlight Problem
- Shipping a transmission?
- Damn Window Switch!!!
- crank sensors?
- which wideband o2 sensor...??
- what to look for in a used fd??
- Got my car back from Marvelspeed!!!
- F/S Water Intercooler and Custom Exhaust
- 750's wont run w/ a stock ECU?
- Rebuild Sreet Port 2
- Electrical Problems Causing Car not to start or idle
- How are these numbers for the first time at the track?
- intermittent boost
- ack, need a compressor housing for stock twins.. help?
- wierd temp guage thingy....?
- Single Turbo upgrade! Help!
- Why is my car surging?...Plz help...
- RB exhaust
- Car Not Charging
- Please Read (Auto to Manual Swap)
- Boost Problems
- Boost Problems
- Gotham Hi Flow Cat
- For anyone looking for an exaust
- Need Help-- Did a search already
- Anyone have a front reinforcement bar? 1 on ebay
- Is There a Gasket Between the TB and Intake Elbow?
- got done changing tranny oil, major problems...
- Just got my BI-State Custom turbos
- capping stuff and ac
- WTF little to no air comes out vents in cockpit
- Another altitude question - safe boost on stock ecu?
- Ground Strap: Will this work
- Idle Problem
- Air conditioning rebuild?
- My R1 w/BNR Stage 3s is *finally* hitting the dyno
- About ATF, need a quick answer please
- How do I remove the ball joint from the lower control arm?
- It getting warmer...any updates with those with Evans?
- Baker Precision Vaccum Hose Sucks!
- what kind of symptoms for a failing airpump?
- Newbie Needs Some Engine Help
- How much would you sell this car for
- Another fuel pressure reg question
- About to replace my tranny and diff oil...
- Looking for pictures of a upgraded fuel system in the engine compartment.
- Two boost leaks...found one...the other ?
- Finally got my FD!!! and she's a beauty!!!
- New 7 And Spec
- Any one replace the rear cross member? -help-
- interior part needed...
- over heat exhaust....
- Coolant Problem
- Pumps in parallel
- Won't start if A/C is on.
- A/C problem.
- advice
- Experience Needed
- Rx7 Help!!!!
- 99+ Intercoolers
- Mazda dealer blew my engine
- Where to get a strong tranny???
- questions
- Vacume pressure question..
- no oil no motor....the pics
- How hard do you blow (A/C)?
- Fuel Injectors & Fuel Filter
- Renovating 93 RX7 - What else, what's next?
- 5th gear Synchro write up
- suggestion for those with trying to fix 10-5-10 pattern
- Aquamist.......help!
- why does my car use so much coolant?
- Pictures of my FD!
- Amsoils new 2000 series gear oil...? for KAAZ?
- Newbie help please
- A couple questions
- engine pull help, pt 2
- how much hp should i have
- Apex Seals 2mm or 3mm and WHY?
- Quick Radiator Fan question
- another braided fuel line question.
- Blown Motor? need help
- Is this normal
- i pulled the motor and turbos have oil dripping of them
- Efini blank keys: Anyone else have problems making a copy?
- matching boost gauge?
- Another one down...update
- Weird Turbo problem
- First Time, missing during warm up
- Price check: 94 RX-7 Touring please.
- Throttle Body Gasket and 0-Ring Item #'s Please.
- Boost Gauge
- are light flywheels really worth it
- DP + MP + K&N + ProfecB@10psi okay to run?
- premix ration w/o MOP
- clutch speedbleeder size for fd
- two quick Qs concerning Apexi Power Intake
- Any Ideas on my prolem?
- My AC doesn't work - it used to with the stock ecu
- found another rx7 but not sur what to offer
- idle help anyone?
- Hiya!
- I Need Help!!!!!
- Liquid/Air Intercooler question (long)
- questions on buying rx7
- powdercoating pics
- where to buy a good jspec rotary?????
- EGR fix w/12v relay works!
- how much to pay for FD?? are the horror stories tru about how much FDs suck?
- upgrade Primary or Secondary injectors??
- do i have bad BOVs?
- New HKS fan & water injection controller
- FC oil cooler on FD
- pics of my MB...(biguns)
- quick question on fixing jumpy tach...
- Pics of my car.... (Not 56k friendly)
- back fire....?
- street ported engine set at what idle speed?
- Pressure Chamber Problem
- Pressure Chamber Problem
- Above 6800rpms
- My T-66 dyno numbers
- My left headlight goes ballistic. I'm assuming it's electrical.
- Engine Caught Fire....Questions?
- How Much Of A Risk...
- funny statistics on fd reliabilty
- turbo cool down
- good price for diff/ppf/tranny?
- I Need Help :(
- Cosmo Swap into a 3rd Gen FD
- What can be removed from UIM when doing NON-SEQ Conversion
- My stock gauges went out
- Alumaseal or Block Weld? Which one and application questions...
- light near the ashtray