- LF dynoh of 13Brew, stock port/rotors, non turbo/w header
- ???
- Requestin Pictures Fuel pump rewire
- Question about re-paint and factory rock-guard
- Belt size for Greddy/Ebay pulley kit with airpump??
- Need Help instrument cluster light wont turn on neither the parking lights
- Idles at 1500 RPM w/ Greddy Elbow
- Hertz/Burnout FD Project
- Technique for removing ACV check valve?
- Problems with taking boost gauge out
- problems after injector service
- Need help with stuff getting into the LIM
- can this work? (oil coolers)
- question: ignition harness
- Center tail light different black than 99 spec
- Looking for Part Number: MAP Filter
- Restrictor plate size?
- Idle Air Control Sensor
- Ruh Roh. Another "Is my car dead?" thread for everyone to laugh at(with?).
- Blitz Boost Gauge.
- copper radiator?
- RX8 Oil pan on a FD?
- BNR convert to non sec
- Dome light in the trunk!?!
- toyota tacoma rear diff in fd?
- Short shifter options
- [Rx7 Boutique] Mailing List & Cluster Service
- Grab a tape measure for me would ya?
- Need some Identification help....
- Narrowing down to my low 4500rpm boost problems
- ACV Solenoids vacuum routing
- How to extend exhaust? Pictures.
- AVCR do I still need factory wastegate solenoid
- Runs out of gas on left turns?
- oil pcv install
- FD social group?
- Wiring Issues, assistance needed! :)
- Installed RE regular vmount + powder coat pics.
- Front Sway Bar Mount Bracket
- Stock retrofit HID headlight options
- Reliability on Super low mileage FD??
- Stock '93 FD RX-7 Induction Box
- Need some serious help
- igniter
- Expensive Exhaust Manifold Gaskets!!
- Running rich and failed my smog pretest
- bought a beat down fd, have question
- help, making zero boost
- Any 3rd gen owner with SSR Comp 18x8s?
- HELP!... cant get oil to oil feed line
- Torque Specs FD - need help
- white smoke after boost
- oil in FD intake
- my power fc tanked
- Change hub or whole rear axle
- Fuel system help
- Engine removal for rebuild
- Oil & coolant mixing...lil help guys.
- Making the case for the TURBO'D rotary FD... Turbo options simplified
- 2mm or 3mm Apex seals---The Debate.
- Turbo Timer?
- going from 850cc prims to 550-650cc
- Tach and Speedometer do not work on my automatic 93 RX7. HOLD light flashes
- Garfinkle Fuel rail Adapters
- oil cooler line fittings
- Backing-Out An ECU Connector Pin
- drilling into carbon fiber hoods
- What parts interchange with the 13B's?
- Changing headlights, need opinions on what type is best
- relay and fuse box to main relay fuse box
- Tranny doesn't go in 5th nor reverse when hot
- Sqeaky Suspension / Alignment Issues
- New FD, bad motor what route would be the best to take? (already searched)
- manual steering rack kits
- 99-spec front height
- Engine/turbo Dramas with my 99 rx7.. please help...
- front iron damage
- What type of bulb do we have??
- help boost problem or maybe something blown
- FD Air Pump Connector
- NO Power Until 3500k RPM Whats Happening
- Shifter moves a lot in 4th gear??
- Compression test clarification needed
- another boost leak thread
- 93 bumper ligth
- Upgrade to one large oil cooler
- Removing the rear hatch - anyone done it?
- problems with stock headunit and tripmeter
- Question on mounting RA OMP Adapter
- Greddy elbow - mate to a front mount?
- Trying to find a thread
- I goofed and need some help
- Suspension fixed!!!
- found the culprit that was causing all of my coolant pains...
- Twin oil coolers
- What other parts should I replace on an Engine R&R
- My (Charge Relief) Solenoid valve broke... ?
- Transported FD arrives dirty..damage check?
- Front wiring harness 93 lhd
- question about coils(spark)
- my first brew rebuild
- Using pass side cooler opening for intake??
- Im ready to do a FULL vacuum hose job, need pointers
- Anyone have experience installing an HKS CAMP (not CAMP2) into an RX7?
- need help from the gurus: starting
- What exhaust parts to Jet-Hot coat?
- Interesting read on 3rd gen aerodynamics
- 93 roller ?
- adjustable fpr when?
- Bulb sizing
- Does Anyone Have Information Or More Pics On This Red FD?
- Coolant Overflow tank
- JDM wiring harness on a spec
- Need advise on swap install 96 longblock Jspec engine
- Should my next mod be V-mount or AI
- Oil catch can problem
- Best Stock-Looking Gauges
- where is engine serial # 13b
- Rhd fd
- 2003 FD3S (aluminum special edition)
- turbo coolant troubleshoot
- Handbuilt 4-rotor w/ dual 13b-REW intake manifolds
- 6K RPM miss
- RX7Store V-Mount Kit Info
- Progress so far on my 7
- Stock fuel system O-ring question.
- How many is tooooo many FD 7's?!?
- Water temp gauge linearization mod
- Question regarding stock/BNR turbos
- Custom License Plate Bracket PICS!
- LONG: Bonez cat, possible clog | midpipe swap | boost control | dyno | *VID/PICS*
- MAP Sensor Voltages
- Clutch will not bleed out!
- Front mount pic request
- Guys I need help with my heating and A/C system.
- 180 thermostat? 85c driving and 100c idle
- How much boost pressure am I losing?
- Trying to source the right rebuilt kit?
- 2000 FD3S Solenoid Unit Pictures?
- hi flow cat suggestion please
- Carbon Fiber fender liners i made!!!!!!!! LOOK PICS
- Pettits CC3 question
- question about flooding
- wastegate flapper swap question.
- Anybody Know how this AST is Attached?
- Does this Exhaust Manifold look right? (Pics)
- Looking for a switch
- Another fuel leak thread
- sputter problem HELP!
- Massive Spearco I/C's for American Turbo Diesel Trucks? Vmount Fitment?
- hessitation/studder when a accelerating from cruising?
- Rotary Extreme (apexi style) sideskirts
- Pictures of Revolution Time Attack FD3S Build!!
- Pettit Alignment Specs for 18-inch wheels
- help innovatie wideband calibration/start up?
- 99 spec turbo restricters vs 93 spec pills
- headights, fan, sunroof, and power windows will not work but everything else does.
- VIN help
- Boost exhaust cut out valve
- 550 injectors back in the stock primary rail modified for 850s
- About That 3000 RPM Miss...
- how to install Apexi turbotimer?
- Throttle Body Gasket
- Uim/lim
- A different approach to a FMIC
- Gear whine diagnosis
- Water Pump Pulley Fix?
- 5th Gear Grind
- ABS dead.
- no more vacuum leaks for me...
- My new parts car!! All Charred!
- re amemiya short shifter question
- Car wont turn off.....
- RE style taillight covers not fitting!i need advise
- Pettit starter booster problem
- Tranny fill bolt HELP Please!!!
- reccomend someone to replace turbine wheel and balance?
- Is this a bad ignition coil?
- How to remove UIM to replace Lead Coil
- Idle issues
- strange electrical?? issue? +battery question
- J&S Knock Retard Unit
- Automatic Brake reservoir work on Manual?
- speedometer and tachometer ground
- stock twins sequentical boost problem
- willa JDM PFC work in a USDM car?
- Won't Start. Cranks, checked fuses, batt, fuel, spark??
- What's the best repair manual?
- dash lights dont work..help
- Find the missing pieces in my build
- Exhaust silencer back pressure bad?
- What is most likely leaking here (rear differential) ?
- White Exhaust?
- What happened to scuderiaciriani.com
- Need new door handles
- Greddy Type RZ BOV Help
- Samco intercooler piping... problems with install...
- stock turbos max whp?
- Fuel pump identification
- I need a Radiator Help me
- how to tell a jspec trans
- Going to scream over hard to find suspension parts!!!
- Single tip exhaust recommendation
- Supra fuel pump rewire / pfc remap?
- directional air venting problem
- HKS FCONV pro throwing code13 ...
- Some suggestions and input on rebuilt engines
- Writeup: DIY poly motor mounts
- Boost issue?
- oil leakage between the tb and uim
- Clutch issues
- 99 spec frontlight: What am I missing?
- Help!!! cluster lights and tail lights won't turn on
- mcautocreations FD
- engine mount thread holes cracked
- Re-Using Downpipe Gasket
- Miata Airbag with 2003 protege steering wheel?
- Headlight covers
- fusebox....OUT!!
- Official 2010 FD Calendar Voting Thread # 8
- Official 2010 FD Calendar Voting Thread # 7
- Official 2010 FD Calendar Voting Thread # 6
- Official 2010 FD Calendar Voting Thread # 5
- Official 2010 FD Calendar Voting Thread # 4
- Official 2010 FD Calendar Voting Thread # 3
- Official 2010 FD Calendar Voting Thread # 2
- Official 2010 FD Calendar Voting Thread # 1
- classic car registration?? anyone??
- can the coolant buzzard cause too much fuel
- 99' stock air dam with 93' configuration
- Making a Tire chart for rear tires
- new member needs initial setup help
- coupler sizes
- What set-ups pass emmisons/smog
- Question for gurus, since I am getting old, and have crs.
- NGR Performance Type-s BOV
- Throttle Body Adjustments
- Brake rebuild problem, rust!
- Door latch trouble
- How easy/hard is it to pull engine and replace seals?
- RS Pantera Carbon Duck Tail Rear Spoiler
- Sparco Chrono Seats?
- pfc water temp guage issue after front mount install
- Somebody Clunked an FD.....
- Need Help with grounding wires in rats nest. Please Help!!!
- Greddy BOV flange are they all the same
- starting problems after rebuild
- C-West or RE-A sleek kit replicas?
- stock turbo shaft/turbine replacement ?
- fighters garage intake