- Inlet manifold oil leak.
- greddy boost gauge, belts, and o2 sensor help
- ID this connector
- RZ keyless entry part #'s
- Engine bucked, CEL went on, what does it mean?
- bov noise question
- Auxiliary fan trigger signal
- crank angle sensor connectors
- HKB Hub w/cruise control built in!
- AIR BAG sensors for rebuilt title inspection
- Cool catch cans
- I might have stripped a bolt (help)
- Going Single Checklist
- coolant overflow leak question
- Amazon.com ?
- Who can name this oil plug?
- Vmount Purchase info
- Clutch Problem
- How do I remove the twins?
- Ground plug
- 4k idle???
- Back Knock Sensor
- Who makes this?
- Tightening the Mirrors?
- Name this Aero
- Blitz FMIC bracket question
- Manifold glowing at idle
- "signature" on housing after rebuild?
- New Greddy Ti Oval Exhaust w/Video
- Bushing/Drivetrain Clunk?
- Automatic Engine , onto an manual car?
- Engine Mount Questions
- Help me figure out what aero I have
- Can I use Redline Lightweight shockproof in an FD tranny?
- if an FD is flipped is the engine gone?
- Has anyone ever made a custom y-pipe for NS twins?
- Nopi at PBIR
- Whose 20b-swapped FD?
- Exhaust question
- Tuning a Daily Driver?
- Fuel injector upgrade question
- FD oversteer much?
- How can I check the compression on an engine without the transmission
- is a N3A7 ecu safe is a CA 1993 FD
- Retrofit projector issue
- fd/fc/rx8?
- troubleshoot blown engine?
- FD broke a wire
- Anyone with Xcess oil pan and bigger dual oil coolers
- trouble shooting rear clunk
- fuel in oil
- Intelligent Non-Sequential Mod...
- Where is the Purge Control Solenoid?
- Thunk/Thud Noise : Diff ???
- Is oil pan leak a given?
- New cluster question
- Fuel regulator with 2 vacuum hose?
- Darwin: 1 | Cat: -10 | Me: -$$
- Another "Where does this go?" thread.
- Recaro RZ seats if you have them I need your help.
- Premixing Fuel ?
- 99 FD turbos vs 95 BNR s3 turbos
- Concerns of Fd.
- Curious Bridge Port Questions
- guage cluster
- What am i missing!
- Picture/Details request on your custom VMIC setup!
- Knock Sensor Error code?
- What kind of v-mount? On fd
- Discovered oil coming from lim just the far left runner.
- odd boost issue (searched, found nothing)
- just getting into FD world
- Knight Sports V-Mount Installation Write-Up
- N3y7 ecu?
- Blocking factory oil thermostat
- Runs terrible, starts bucking, goes lean VIDEO
- Speaker removal
- WPC treated motor, too extreme?
- Favor needed from those with ASP/Pettit SMIC
- Need some help with my FD =(
- Another My Car Won't Go Thread
- Fuel Door latch wont open?
- Reviving after 2 years
- Are aftermarket crank pulley's worth it?
- FD Stock BOV correct operation?
- Could ABS or PS removal cause long Beep?
- Plug wire question
- ABS Mounting Pics PLEASE!
- Searched, still new to rotaries
- FEED door handle alternative?
- with a street ported motor do you need an aftermarket ECU?
- New motor that has been sitting a year?
- Steering column exchange is this bolt reverse thread?
- Side View Mirror Size
- Rear End Suspension Upgrade - Please your advice -
- What is this? Can I remove it from my manifold?
- neo synthetic > redline oil
- anyone know what these rubbery things are?
- Mouting lsx coils
- emissions bull shi....?
- Mint 1995 interior plastics and one off 240mph Speedo pricing???
- Dash Trim Overlays? Successes/Failures?
- Please help identify this connector.
- Diff or tranny?
- Personalized License Plate
- custom build exaust questions and header wrap
- Very weird rear end noise
- CPU (Seatbelt blinking light, alarm buzzing)
- Will this work? (headlights)
- blown apex seal on dyno
- Projector headlights
- Car won't crank
- Turbo Oil Feed Line...fitting that goes into the block??
- Which relay to buy for Fuel Pump Rewire?!?!?!
- Coolant Needle Going Towards Hot
- Sunroof leaking - drain plugged?
- Sunroof leaking - replace weatherstrip?
- grinding sound in reverse
- Fender liners, pulling my hair out!
- budget Intercoolers FMIC / OEM IC + what size?
- 86-88 Radiator cap assembly question
- I broke something - what is this called?
- Best place to buy exhaust?
- Greddy pulleys plus air pump belt size
- Change in idle
- Possible TPS problem
- HKS twin intake review..
- Walbro 400 LPH Fuel Pump
- What is this bumper? and oil thermostat? how to mount it?
- Pettit STMIC vs Rotary Extreme v-mount
- e-01 boost menu not accessible
- Single oil cooler options?
- please someone help with tyre size
- New build. Starts, will not idle and blue/white smoke.
- Rev limiter + meth injection
- Sputter/hesitation...automatic (ew)
- Should I replace the Lower Intake Manifold Gasket as Well?
- Diff rebuild - any tricks/hints I should know about?
- aftermarket fuel lines and such question
- Rx8 eccentric shaft in rx7
- And So The Rebuild Begins. Help Me Not Make A Mistake On The Many Options
- Cable Identification HELP!
- Cosmo engine in a 7?
- questions regarding high idle and spark readings.
- Different 5th gear ratio?
- A'Spec Turn Signal Lens?
- Error Codes?
- Where is the center speaker amp on an RHD FR?
- 3" exhaust gaskets: Where to buy?
- check engine light -- changing plugs?
- How to install LS2x coils with Fd harness.
- What should I put in this hole???
- gearbox strength
- FD picture thread
- hesitation/backfire issue
- AST to overflow hose popped off. Now what?
- wtk: length of rx7 fd3s gearbox
- Circuit Sport Ignition amp?
- '93 starting issues
- OS Giken Twin Plate
- Snapped Seat Belt guide (pic)
- Injector Qs: Removing Varnish and Primary O-ring Sizes
- Mad Mikes Mad Bull 4-Rotor FD - The intro
- It's not stiff anymore....
- Weird lack of power and misfiring only after some driving time
- Help: Center Iron "Nipple" Breather Stock Setup.
- Riddle me this!?!?!? CAS signal
- Weighing engine rebuild options (buying pre-built)
- where to buy the 99 spec light bulb socket wires lol
- Shifter wave spring and Knob orientation?
- RHD too good to be true?
- auto to manual
- FD got rear ended by F250. Need advice from those who've "been there, done that"
- TONS of white smoke expert help needed
- Stock Twins dead?
- is there a difference between 93 and 96 sensor
- fd needs help!
- Crank angle sensor mount broke
- BOV & CRV hose +troubleshooting
- Stupid question on hose/nipple
- Change exhaust manifold gasket.
- Clutch PP set up
- mazdaspeed door sills
- Engine Stalling
- Possible V-mount?
- Bad coils or worse?
- Exhaust Stud Thread Pitch?
- looking to get into the rotary game
- can the fan recall run the battery down?
- abs delete ?
- EGT's are off by 100 degrees or more.
- oil filter sandwich adaptor plate and water temp sensor adaptor for FD?
- Gauge cable routing
- exhaust manifold spacer
- Intermittent Starting Issue - What's Causing It.
- Where can I find some solenoids?
- Exhaust sizing
- 94 R2 listing price advice
- Tail lights stay/come on by themselves
- Would you buy it? 94' R2 Rebuilt title $7,800
- Removing headlights
- Where can I buy a Jdm Steering wheel?
- Jdm cluster work with US car?
- Had my keys stolen, can I change the locks?
- Strong fuel smell under boost acceleration...can't find source!
- '99 spec combo light harnesses
- is there realy need for two egt probes?
- Seems Cool - Aeroforce Interceptor Gauges
- Dual Oil Coolers...thermostat required?
- FD Annotated Harnesses (Front, Instrument, Dash, Rear, & Floor) + *Index*
- Keeping cabin heat down advice needed
- Ecu grounds
- Precat Facts...
- Chargespeed Vendor here on the forum?
- Should these go somewhere?
- Why would shifter turn?
- A/C won't turn on at all
- Where is the fresh air intake for the HVAC?
- My Electric Water Pump Setup.
- My boost goes on and off in 3rd-5th gear
- Does anybody actually has a JDM imported, titled, and insured FD in the States??
- oil pressure question!
- Need Help Trouble Shooting!
- Abs Leaking?
- Which housing did mazda place the knock sensor F or R ?
- Help: Cold Start Issue
- WTb Broken window switch!!!
- Rebuild timing?
- Clutch switch connectors
- stupid question
- update after a long time away
- Diagnosis - I think my mazda reman has an o-ring leak
- Idle past 3000 rpm
- All in 1 electric turbo timer/boost/nos system controller??
- 2002 rx7 RZ WHEELS?
- possible coolant seal problem?
- Did I install my Greddy gauges correctly?
- 0-100 time fast enough?
- Is this the correct FJO Injector Driver?
- Gasket for wax rod assembly
- "pics of fds next to other cars"thread
- Spark plugs How do these look?
- Who created the build section?
- front fog lights connection
- I need a rebuild - come get my business!
- ummm I broke my powersteering pully
- How much should I expect to pay for a rebuilt engine?
- Turbo Rebuild/Replace Question
- It's that time of the year again... FAILED emissions
- injector confusion (do primarys come in diffrent colors? )