- First time to the track in my 94 FD...
- Changing the spark plugs
- Oil Light?
- Oil Trouble
- Anyone ever tried to use the 20b turbos on the 13b?
- does anybody have a diagram that tells which pulley is what?
- Norwegian FD3 rebuild +++
- Belt stops squeeking with wd40 sprayed on pulley underneath alternator
- Where to get used turbos?
- Questions about full non-seq and new motor
- Water temp gauge
- To those w/ Polished engine parts...
- Opinions about the 'Route I want to take on my FD3'
- Replacment cap for M2 AST Deletion Kit
- What intake fits PFS SMIC??
- Downpipe help!
- Throttle Sticking
- How long does Air filter last for?
- how much did you spend for maintenance
- custom intake (i have searched)
- Need to bleed the slave.........
- Just started new streetported motor!!
- exhaust noise video clips?
- Won three battles tonight
- profec b and needle valve?
- Pictures from Sears Point today
- OMP help!!!
- Anyone shooting flames out dual tips?
- What would you do?... Turn lamp corroded into socket.
- Question
- Lower intake manifold porting. Any hp gains?
- Fan Mod only comes on & off when cars off.
- An accident (with my 2days old FD)
- Is a Street port needed???
- Profec B very very strange boost patterns
- Pipe Cracked!!
- PFS SMIC installation question
- attn: fd's w/ streetported motors
- Simple manifold question, I hope...
- doest go above 5 mph??
- how to take car out of sequential mode
- Apex seal question...
- New Motor For 2003
- bonnet lifting at high speeds
- RX-7 to come
- Why should I get a RX-7
- 99' Spec Engine, Turbo, Tranny on 93' FD?
- mazda says engine is shot
- Need a site to order stock misc. parts.
- what mods next
- one more time...
- Bringing over a 96+ FD
- wastegate porting
- how to remove/check turbos
- Sears Point tmw...
- Lookin for a PICTURE
- small backfire cause - running rich VS bad exhaust gaskets
- Labor cost for clutch on FD
- rear swaybar came off!
- A real Quick question about gauge wires.
- The Sunroof Effect
- Dynoed last week and had horrible breakup, Need help diagnosing(pic)
- OK, what happened?
- ***TRI-Point Clutch****
- New engine break-in period
- anyone have pics of the three gauges lighted up in their passenger side airbag.
- anyone have pics of the three gauges lighted up in their passenger side airbag.
- which turbo is which??
- Quick motor mount removal question...
- Where to lift the engine for tranny install?
- Anyone know of any issues putting the fuel additives for smog check?
- Help Help Help
- A thousand crickets....
- Sunroof & heater Questions
- ASI AST tank questions
- Inspection and compression check results~~
- OH NO! Not another Ghetto Mod: Engine Torque Brace! PIX!
- wtf is going on?
- wtf is the meaning of this (rust on brake rotors)
- what are the best pulley belts to get mine are squeaking
- To those who have Linearized their Water Temp Gauges!
- Had some paint work done on the CYM, comments welcome!!
- How long did your clutch last?
- Signs of a bad clutch
- A little present to myself...
- My Xmas present from the FD...
- Overkill on fuel system?
- Help Idle Problem
- electrical problem on my FD
- How much cc is the standard primary injector?
- Engine Code #9
- question for those with m2 and CWR intercoolers
- 94 rx7 with problems (advice wanted)
- 94 cali ecu will work with 94 non cali car?
- need diagram of solenoid rack
- What kind of bulb does the stock front turn signal use?
- Whats the difference between FULL non-seq and the poorman's non-seq?
- Whats the difference between a Greddy IC/stock turbo and Greddy IC/single ??
- another turbo...or rebuild?
- Need to find used parts website
- cheapest place to buy Mazda parts?
- MSD plug wire feedback
- FYI: intercooler comparisons are done SMIC VS. FMIC
- 99 spec lights
- FMIC vs. SMIC
- FD recalls?
- Stock vs Bonez hi flow cat?
- Hosed again!
- Vaccum Leak?
- Petit Steering column pod install??
- FD stalled on cold start up, w/ white smoke coming from turbo area.
- Can I bling too??!!
- Problems with 3rd gen rx7
- Who's good at rebuilding trannies?
- Doing hose job: Filter things on ends of solenoids
- is there a fix for the warped front bumper?
- Ease of throttle response.....
- FD runs low 11s with full interior, sound system and 20 inch rims!
- Should I upgrade the radiator for my daily FD?
- just reinstalled turbos and car won't boost
- Ported wastegate, now new problem..
- CRV Piping: Hose or Plastic
- Rear Muffler
- Autometer Water Temp
- 190 left!!
- Tranny went out
- Clutch Problem
- does vta cause low spd stalls?
- Why am I running Lean?
- Greddy SMIC Install w/ Pics - post your feedback
- Efini Emblem Part Number
- What should I do while my motor is out?
- Video of Torque Brace: Before and After
- What to look for when buying a 3rd gen 7
- 76k miles original engine, do or dont?
- looking for a 3rd gen. rx-7 twin-turbo?
- midpipe
- High Pressure Radiator Cap
- idle madness
- FD or 3000gt(Need the RX-7 guys advice)
- Cant find the wire for the Fan Mod
- Well i wana by a 7
- electrical problem?
- Cloudy gauge glass?
- Misc Body Piece
- Door Seal/Gasket
- Can i use permatex copper gasket spray
- midpipe & downpipe questions...
- Clogged Pre-cat?
- Got Duct - Show your pic!
- Underhood Insulation
- seriouse help needed..turbo problem
- my cooling system drama....
- Is it okay to use fuel stabilizer in FD?
- Congrats To All The GREAT FD Forum Members
- transmision fuid
- i now know why people go to non-seq...
- Idel problem
- Cold idle fix...
- Shift Kits
- Need Part # for seconardy fuel injector o-rings
- ecu problems
- Greddy A/F - O2 sensor
- computer questions
- Boost controller installation help needed
- dimensions of m2 large??
- vac. hose diagram for installing boost controller needed...
- Quick question on Greddy TB Pipe
- Great Thread On Water Injection - Where Are You Guys?
- What type of wastegate is on the stock turbos?
- Need help!!! My FD's messed up???
- question about installing block off plates
- Clutch Net new clutch question
- O2 senser woes... make the right choice
- Throttle body coolant line removal... can you plug the ends?
- Unobtanium Bushings
- Half Heigh pop up with Sylvania X1010 HID
- Clutch Shaking
- exhaust leak
- blitz intake
- M2, ( stage 2) boost pattern?
- Where can you by mixing plates?
- Profec b install strange boost
- Stock Belt Sizes
- getting a 3 gauge center pod....what gauges?
- Were Can I Get The Random Tech High Flow Cat
- Just started new motor, got a question
- moisture coming out of the exhaust....?
- Battery mounts
- identify this part please
- Greddy duel intake system vs. HKS J-spec intake??
- downpipe?
- Leaked coolant/tightend clamp, stopped leaking
- downpipe to cat exhause leak
- Adjusted my Clutch like the instruction stated..
- Greddy E-01??
- Advantages/disadvantages?
- ECUs and EBCs... What do I need?
- CW intercoolers
- Loose Shifter
- were is the best place to have my motor rebult at
- JIC 505SUS exhaust....
- What 1/4 mile times should I expect??
- changing suspension bushings?
- need pics and feed back of xs engeering intercooler installed
- Which Would U Buy
- Gear change and Speedometer
- Profec-B - Accidental Adjustment
- I just did the fan mod!
- Need pics of Fender liner ("Splash Guard") screws
- she doesn't run right
- draining tranny oil?
- What to look for when buying '93 RX7 ?
- getting a 94 RX7, what upgrades should I do?
- street port how much more fuel?
- most expensive nonturbo nonengine repairs?
- Dual Intake
- help me decide on a intercooler
- Mods Too lean for Automatic Trans?
- A piece of Domestic Rotary History
- Electronic Water pump??
- Nonprogramable ECU and increased boost
- $2400 for complete overhaul of FD??
- Do I get an electronic boost controller with or w/out fuzzy logic and which is best?
- Help! Stock alarm doesn't lock the doors all the time
- Question:Is it hard to install........
- broke passenger side door handle (outside)
- vaccum line
- RX 7 Reliability
- disconnecting motor from transmission.
- Dual intake K&N cone filter
- Got a used Greddy SMIC
- What's this motor worth??
- Question about replacing the Handbrake handle
- For those with failed rebuilds...
- m2 polished intake pipes
- Upping The Redline, Why?
- Please, help me get my car back!
- pull to the right
- How do you run 15 psi or 1 bar safely?
- air bleed screw adjustment
- A cheap and easy Christmas present that we can all get for our FDs
- intake temp
- need help worried about engine!!!
- how to tell if your rear end is $hit
- where did everyone mount their profec?
- how gradually do the engines die / pre-inspection?
- Boost Guage Omitted
- Blue clip by ECU
- Fuel Filter Placement