- OEM airbag connector part / harness
- snap rings
- Possible blown apex seals. North Cal shop help?
- Idea for Headlights (corvette c5 units)
- Stock twins - cracked wastegate port
- Original FEED carbon weave?
- Adding fuel potential prior to tuning
- AC Dryer help - Denso system
- Rear strut/sway bar endlink bolt replacement
- Complete fuel line replacement
- Oil pressure changed from normal
- Refinishing interior bits
- Compression at minimum of Mazda spec
- Rotor housings... are they paper weights...
- Transmission/Shifting problem
- Batt Relocation, Power/ground rewire
- 93/94 front harness help
- Clutch Switch / Fork plastic part
- Insulation on transmission heat shields?
- Coolant buzzer + middle dash speaker wtf??
- Twins: Primary noisy after rebuild
- Loud, fast vibration sound from hatch area
- Securing seatbelt guides on Spirit R Recaros
- throtl – Rebuilding the FD's Shifter
- FJO water injection and A-spec 500r Turbo kit.
- Rear main seal oil leak?
- AN fitting to oil coolers keeps coming loose!
- Single Turbo Install Options 2018
- Reversed TCA vacuum and Pressure lines
- R1 lip... how effective and what is the vent for?
- Need advice about refinishing 93-spec dash panels
- mystery pipe
- A/C Compressor Options
- OEM Wipers
- Any tips for putting Magnecor wires on spark plugs?
- feedbacks on this cheap SMIC from Jperformance
- voltage dropping at idle.
- 1993 JDM rear brake calipers
- DEpin Power FC for stock unmodified harness on stock FD
- Big Impact Noise and then big Coolant Leak
- LIM rear lower runner crack
- No aftermarket Cross over pipe?
- tune issues
- Heavy Bucking When Cold
- Greddy Intelligent Informeter - looks like there is an FD3S cable?
- Best way to waterproof mount 99 wing?
- intake forced induction noise very loud with no obvious leaks...
- [ELECTRICAL] ID Wire
- Chk Engine #11 & #51
- Idle surge when car is getting hot
- Bose Soundwave wiring + audio stuff
- Long-Term Tire Wear
- US Passenger side tail/brake light problem
- new build oil pressure.
- Why are both leading plugs connected to the same ignition coil?
- Helppp!!!
- Where is the AC Relay?
- Bad oil gauge?
- Tuning PFC
- Screws for OEM steering wheel?
- HOW TO: Fix headlamp retractor motors.
- Fuel Pump Electrical Bulkhead Connector suggestions.
- Injector Diffuser
- Correct front and rear emblems?
- SR motorsports SMIC question
- Missing part, maybe someone knows the part number?
- Mazdacomp differential bushings?
- Went to get a tune a few weeks back and got some bad news...
- 3" V-Band clamp nut thread/pitch
- FD stalling?
- Vacuum Line Check Valve
- Wiring the pop up FD headlights on a stand-alone toggle?
- Downpipe/Pre-Cat stud - supposed to look like this?
- Is my iron useable?
- Inside of airbox and piping covered in engine oil (stock 2002 FD3S)
- Is my new slave cylinder bad?
- Passenger window beltline molding problem.
- Coolant Overflow Tank Issue, Coolant Not Returning
- need help with transmission alignment dowel pin measurement
- Jdm key fob for central locking part number?
- 4th gear high rev grinding
- Need help on wiring defrost switch light
- Stock Twin and Ported build recommendations
- Air Bag Warning Lite and High Frequency "Siren"
- FD revival project- Cosmetics
- Rear counterweight (PICS)
- Rear left brake caliper banjo leak issues!
- How bad is it?
- Rebuild or new engine?
- Attention track guys...what do you use for trailer tiie-down points???
- Rz recaro bracket question. What are theses
- HELP! click click noise and white smoke around y pipe/ twins /turbo area
- Guess my boost pattern problem
- DS carpet deterioration
- Headlight alignment
- sequential troubleshooting / issues
- Engine/Charge Harness Wiring, Fuse Box
- Uneven front height - lower driver side
- Aluminum coolant necks??
- Chassis harness advice
- Banzai diff brace question
- Wiring Question about x-14 connector
- RE Amemiya headlight instructions
- Transmission Clutch - Push, Pull
- Question about injectors
- Device for Monitoring engine details / OBD question
- End Float Spacer selection
- Thermal management
- Gas smell after long, hot drive. Can't find leak
- Mazda FD Throttle Position Sensor Discontinued - Options?
- Dual oil cooler project - parts list and pics
- Clutch Conversion
- transmission leak!
- Flywheel differences - need help asap
- Door wouldn’t shut, now it does, why??
- NEED HELP: Side Seal Question
- Help me find/buy engine bay finishing trim picture added
- Replacing vacuum hoses and found a plug and exposed Hardline. Need help!
- Not long now! FD3S
- Are 93MT vs 94MT Drivetrain Parts the same?
- Which heat range plugs?
- Need pics of Defined V-Mount AC Bracket Setup/Install
- Could you please tell me where this plug goes?
- Tach went erratic and now stopped working after manual tranny swap
- Convert AC R12 in to R1234YF anyone???
- Aluminum Door Sill Scuff Plates
- Body CPU FD01 / CPU #2 Components List
- OEM RZ,Spirit R recaro rail solution
- Brake bleeding issues - Apologies for asking a Q on this topic!
- Speaking of seats, recommendations for driver's side seat
- Sticky starter
- Engine bay frame sticker
- Sanity check (boost levels with Profec)
- Coolant Seal Hydrocarbon Strip Test Volunteers?
- What fittings for AN oil line from pedestal?
- Dimension Request
- Car only runs when I let the spark jump 10mm
- Hyperion Tank Cover cable ties
- Needing some small parts
- 99 plateless bumper
- Pressure in gas tank?
- Idle Air Control / IAC Valve for FD?
- AC Pressure Cutoff Switch Spec
- When to mess with fuel upgrades??
- FD Dual Auto Down Window Switch
- JDM mirrors converted for LHD?
- FD revival project- cleaning
- FD Pop-up Alignment left to right?
- FD revival project- headlights draining battery?
- Help! Starting Issue - 1 Rotor Until Warmed
- Custom kick plate?
- Installing outer door window trim, need some help
- FD center rim to fender measurement?
- Ok I got lazy and now I think it bit me in the rear end.
- AC compressor shaft washer shims
- odd mac valve boost control solenoid location
- IAT sensor failure? Is it common?
- FD revival project- ITS ALIVE!!
- Long time listener, first time caller
- AST to overflow bottle coolant hose
- Loud engine bay
- Cooling system pressure test...coolant leaking from overflow tank
- SMIC ducting? Does mine look bad?
- Front sway bar link - mounting points on Control Arm question
- It's a Penetrating Oil! No! It's a Grease!
- How to bench test knock sensors
- Fuel Injector LIM O-ring
- Switched +12V for fog lights
- Repainting the plastic headlight covers?
- Ignition breakup over 7psi/under load
- Six flashes of air bag light?
- Difference in Reverse Lights?
- Less engine power with A/C turned on
- Idle surge when cold
- Right window does not move- motor/regulator
- FD Instrument Cluster Flex Print Components
- Ignition switch question
- Just failed emissions. Then I passed.
- Windshield info shared
- Front bumper canards
- IACV - humming/buzzing noise
- Air Pump Removal - Main Bearing Stress?
- ID 1700 primary injector question
- 1994 Sputtering/Spark ignition problem
- Is having the radiator on full time a bad idea?
- Where to get a tune??
- Sparks coming from exhaust . Clogged cat or ignition?
- AC directional control not working?
- Chattering sound after new diff
- Does every FD3S need V-mount?
- Fd revival project- Start Up
- Questions about tire size
- Center Cast Iron Coolant Drain Plug - Part Number?
- Is there a way to differentiate between an FD3S Manual and Auto Rear Drivetrain?
- 1994 Airbag Diagnostic Module Repair
- Fuel pump not coming on with diagnostic junper.
- removing gauge cluster hood how to
- Toe link bushings bad again
- Knock sensor connector
- Correct rivets for VIN plate
- Beware of Oil Pressure Regulator Mod
- Fd revival project- coolant
- Fast question about water level wire
- Exedy Single Sports Install advice
- FD coolant level buzzer problem with pictures
- Passenger side window control Rx7
- Black smoke on acceleration and declaration
- does heatsoak limit boost?
- Feel dumb, but PowerFC Boost question
- Front end strengthening
- Dashlights go out when headlight switch activated
- Primary fuel rail
- Bushings
- Haltech GM Air Temp Sensor Reaction Times
- No fuel pressure
- Sard 850cc Fuel Injectors - Discontinued?
- Removing stuck seat
- Lack of fuel from fuel pump
- V-mount install advice
- How do 96-02 fd pass emissions in IL
- How to Identify a Bad Idler Pulley
- How important is front tow hook?
- No power to brake light switch
- ACV Tube Removal
- RX-7 Drive Belts (V Belt / Serpentine Belt / Fan Belt) FAQ
- Best place to tap +5V in engine bay?
- Antigravity ATX20-RS Battery
- IRP Brake Master Cylinder brace-review
- R-Magic oil cooler ducts with Sakebomb dual oil coolers on a 99 spec bumper?
- JDM .806 5th gear
- Smoking wiring in my interior
- Drivers Side water leak??
- Power oscillating at high rpm with squealing sound
- Coolant leak from filler neck
- IGN1A coils - shielded wire?
- Okay guys, I need all your knowledge
- Loud whining from turbo area above ~ 2500rpm
- Taking apart brake master cylinder, and how I spent my weekend
- Problem running neo synthetic in transmission
- Is this the plug for the VSS?
- NLA emission parts , CA car
- Torque spec for brake caliper caliper to caliper.
- Driving with Power Steering belt off
- Headlight issue with imported ‘92 FD
- I built a PowerFC ECM Logger/Dashboard tool. Anyone interested?
- Mazda Woven Nylon Tape
- Question about old rotary extreme twin vmount
- Remove and replace diff center/bearings.
- Custom cluster Fueltech ft500
- Starting/ignition issue