- Hatch glass seal
- electronic boost controler question?
- vacuum leak?
- what is this on the oil pan?
- HKS EVC 5 installation
- fuel injectors
- Resistors with my pfc?
- Relay Question
- HP estimate
- Quick PFS Intake/SMIC Installation Questions (I searched)
- High flow cat Bonez or Magnaflo?
- Bad fuel pump?
- Having with problems with the Alarm going off. HELP
- Unknown shorted relay H302 in driver's foot-well
- n3b8 pettit??
- transmission wiring.
- ok i am a newb and in process of non-seq
- motor sitting for 2 years need help
- Sleek Headlights.... new or old type?
- strange boost issue
- R1 dual oil coolers
- Stock ABV location, pics please.
- need help wiring 850s n 1600s
- Door handle replacement DIY?
- Extrude Hone
- What ever happened to the metal Pettit rear flare GB?
- What to take out?
- Cleaning paint after removing wing.
- Fuel pump not working cause air bag?
- door panel creaking
- Just bought turbo twins, need help/opinions...
- Brakes / master cylinder
- FD Fuel Starvation
- Resonated MP vs. Straight MP
- Apexi FMIC intercooler install
- where did gotham racings website go?
- Block off plates for non-seq
- Help. Low boost only in first gear-sorta
- Whats the best port
- BOV troubles.
- Is this a blown coolant seal?
- Electronic issue.
- Thinking of options for a rebuild
- harness connector question
- M2 Wilwood 6-piston BBK: What rear brake setup
- ECU Pettit A/F ratio..
- where to find gauges that matches the stock ones?
- 5th Gear Syncro Tool Question
- Alternator bearing
- very low idle after car heats up.
- Thermosensor question
- unbolt iat sensor
- Question: Brake bleeding w/upgrades
- I love this car!
- Downpipe to use for O2 Sensor on BNR twins
- Plugged hole on UIM?
- ebay cheap clear lense + 8000k or 6000k?
- Opinion: Stationary gear bearing condition
- twin turbo vs. big Single
- 1993 R1 AC confusion
- what to do about to removing ACV or EGR whatever :D
- need some feed back. 13B-RE FD.
- Pop off (relief) valve question
- Hood liner
- clutch clarification
- stupid boost pattern
- NEED HELP*** Fuel issue !!!
- My Water to Air Setup - Australia
- BrainSTORMING...how can I make the windshield wipers faster?
- non sequential but only 5 psi?
- Cooling Problems, searched already.
- Need some help.Engine removal.
- Steering problem
- manual drive shaft to auto rear?
- clutch suggestion
- Boost Controller Problem
- Need help about purchasing an RX7
- Droopy Hood Liner
- cracked pintle caps on primary injectors
- resistors for fuel injectors
- Surging, and Almost stall out when at idle
- lights flickering stay on when parked
- Wastegate actuator and prespool actuator hose size?
- Help: Cleaning Gas door spring
- Specter328's GT7 RS Build:
- What do you think my 93 R1 is worth?
- orphan wires where they go.
- Diff holding pressure
- 99 spec foglights
- Looked at used RX7, lots of problems and missing parts(?)
- Desperate Help needed with PS window
- motor wont crank!
- does anyone know where i can get just these
- alternator exciter
- 3rd Gen Commercials?
- what PSI on fuel pump?
- HELP: 1st gear + clutch + brake = stalling out
- Modding my bone stock FD:)
- Overheating FD, Waterpump pulley
- Car won't start
- rotor housing to use or not to use
- steamclean fail!
- Pettit ECU+Midpipe?
- Starting issues
- 99 Spec Bumper Install
- Whats normal oil consumption for an FD?
- paint code - SSM Clearcoat
- 3rd gear primary turbo not building boost.
- Time for an aftermarket IC?
- Feed side skirts with oem mudflaps will they fit
- Looking for ACT street/race...Vendors??? who wants my money.
- Exhaust Q???
- replacement 3rd gen u-joints
- need boost control?
- Mcaster water seals ( inner ) 9319K239 order to canada help
- Looking for the owner of this car
- Do you need an oil charge when topping of an R12 AC system
- Auto to Manual?? what you think?
- Low Idle with A/C on
- 99 spec bumper aluminum support rivet size
- vortech supercharger on FD.?
- PPF Adjustment
- help installing knock sensor
- Tach calibration issue or Problem with the Tach?
- Racing Beat Presilencer
- Anyone ever removed the inner window seal?
- car won't crank
- Signs of a Bad Fuel Pump
- dual oil cooler kits
- EGR valve vacuum line
- Back in an FD - Need Opinions -Thanks
- EVO-R RE HID Sleek Headlights.
- series 8 bushings?
- O2 sensor type
- thermoswitch pic request
- rubbing noise on right turns/ squeaking noise in car.
- water dissapering
- Few questions
- blown side seal? VIDEO INSIDE
- Techedge Wideband users, question
- Help on engine
- The Outside Diameter of Idler pulley bearing. PLEASE
- Fuel pressure pb
- NHTSA Compliance with JDM 3rd Gen
- New mods jitters!!!
- Where's this hose go?
- Anyone using an Evo intercooler?
- pics of radio din please
- Fuel Cut in 4th 10psi!!?? WTF?!!??
- Maybe I'm going crazy .. but I can't find the knock sensor lol
- Title question
- If a turbo leaks, does that mean the oil seals are gone?
- Viton tube and check valves
- Has anyone blown a RB muffler and can they be repacked?
- Autometer stockish looking gauges
- oil cooler suggestions
- Plastic welding, new side project...
- 13b TT w/ install
- Front fenderwell wire harness
- bypassing TB "coolant"
- what do I need for a basic rebuild?
- Working on you car BLOOPERS.
- Wierd Boost pattern... need your input!
- whats it worth
- older jdm y pipe
- Clutch Slipping in 5th Gear...
- Wire Harness
- FD diagnostic tool and program?
- i'm newbie to rotary, can anyone tell me how big of this problem is?
- Really noisy unobtainium delrin bushings
- plugs
- Gas problem
- Clutch Job
- where to get rebuild videos?
- weird idling at start up and possible coolant leaking???!?
- RX7 Hopeful!!
- another ACV removel Q
- Clutch disk dilemma
- Going on a Roadtrip in your FD? Check your spare!!
- Fresh motor first start-up vid
- intercooler - SMIC - i've searced and read...
- help on thermostat
- Grrr ... car was running great then pulled into gas station and like crap
- Clear Signals?
- No electrical power?
- Unknown Idle/Temp/Bucking Issue (89*C)
- Engine smoke from DP/Y-pipe area?
- Wiring harness question.
- Engine Bay Fuse Block Cover Pictures
- Rad fans only work when AC is on?
- one year after rebuild - Still having Primary turbo problems..help
- Whine sound
- Looks like water seal failure, right? Vid. inside
- Does anyone have instructions or DIY / Pictures on installing a RACESHOP CAGE?
- Is My FD over boosting?
- Resurrecting the A/C
- Fuel cut problem need help
- Question for people with Fidanza Aluminum Flywheels
- Updated Pettit caliper adapter brackets
- apexi rsm installation manual?
- OMP where to buy??
- Turbo control solenoids and valve help
- Fuel Pump write up with pictures
- Where can I find metal clips?
- CEL / MIL Light stays on, no codes
- Stuck seal?
- Need some help identifying where this stuff goes
- tsudo downpipe
- Oil Cooler question??????????
- Maybe Time For New Brakes
- What next?
- Auto exe rear tower brace
- non seq fabed Y pipe pics
- Custom OEM hood vent cutting
- Boost is stuck below 5 psi help please
- Difference between HKS intakes??
- 3rd gen vert
- voltage stabilizer
- Weird 1 rotor problem
- Problem with PS Window
- Hitting 13psi?! Boost creep or busted boost gauge...?
- Did I just blow my motor? Or is it something stupid?
- red hot exhaust near the motor...?
- How much more efficient is it to have two oil coolers?
- stainless steel lines...EVERYWHERE!!
- 99 spec corner lights wiring
- Single Turbo Engine Harness??
- Fuel Pump Problem?
- OBD 1 Code Reader.
- Bend or replace oil cooler line?
- driving with blown coolant seals?
- can anyone tell me what seat this is?
- has my engine been rebuilt?
- am I OK mounting my block on a stand with 2 bolts?
- does anyone know of a Top mount IC setup on an FD?
- Pics of Mixed Black/Tan Interior
- “loop line” manual rack conversion question
- trans control housing fluid level
- some abnormal coolant issues (related?)
- Road Dyno In Car dynamometer
- AST Removal
- braided fuel and brake lines
- poly engine mounts
- Rotary Tech! Good buy? Bad Buy? Potential RX7 owner
- SMOG Test: EGR Fail
- Secondary Top Feed Rail Install w/ Stock Parts
- next step for more HORSEPOWER!
- Does Your Stock Pos Battery Clamp Look Like This?
- Sway bar end-links -- are they supposed to have a slight curve to them?
- Cold start: weird idle, backfires like machine gun, thick white smoke from exhaust