orphan wires where they go.
#1
orphan wires where they go.
I have been trying to patch up my wires harness as it seems like Edward Scissor hands previously owned this car.OK so i removed the P/S and A/C.Now i have 3 wires in the harness that have no connectors and the colors don't seem to match any other wire.
1.The black wire with Grey covering that comes out of the oil pan-where does that connect to?
2.There is a black wire with red stripes with a black single "female" connector that is just hanging where the P/S was.also the other half of that connector "male" just fell in the floor when i removed the bracket so where does that other half goes?
3.There is a blue with red wire sticking out of the lower part of the harness by where the starter wires come out.where does that goes?
This might not be enough information so i will try to post pictures tomorrow.
1.The black wire with Grey covering that comes out of the oil pan-where does that connect to?
2.There is a black wire with red stripes with a black single "female" connector that is just hanging where the P/S was.also the other half of that connector "male" just fell in the floor when i removed the bracket so where does that other half goes?
3.There is a blue with red wire sticking out of the lower part of the harness by where the starter wires come out.where does that goes?
This might not be enough information so i will try to post pictures tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM