Bouncy Acceleration...
06-21-03, 02:11 AM
#1
I Sold My Car 2 the Devil
Thread Starter
Join Date: Oct 2001
Location: Duncanville, Tx
Posts: 2,361
Likes: 0
Received 0 Likes
on
0 Posts
Bouncy Acceleration...
Anyone run into this... all my rear bushings have been replaced.... the diff bushings have also been replaced w/ new stick ver. and the rest are jimlab... I'm guessing either the diff. is jumping when I start to move the car or the engine is shifting causing the driveline to snap torque the rearend causing it to jump... anyone have a solution for this?
TIA,
Ryker
TIA,
Ryker
06-21-03, 03:50 AM
#2
Full Member
Join Date: Apr 2003
Location: westchester, NEW YORK
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
did you run into this problem right after you replaced the buchings, and does it happen no matter what or only under certian conditions? The diff could have been re-installed wrong.
06-21-03, 02:38 PM
#3
I Sold My Car 2 the Devil
Thread Starter
Join Date: Oct 2001
Location: Duncanville, Tx
Posts: 2,361
Likes: 0
Received 0 Likes
on
0 Posts
Actually its been doing this since before... I just pulled my diff to rebuild it w/ the KAAZ unit. I used to have bad wheel hop in reverse (just backing up) and replaced all of the lower control arm and pillow ball bushings which helped this. I'm just stumped... I've replaced them all and still jump, jump, jump. It dosen't make sence...
Thread
Thread Starter
Forum
Replies
Last Post
blu2fourty
2nd Generation Specific (1986-1992)
4
04-27-05 05:49 PM
TonyTurboII
2nd Generation Specific (1986-1992)
9
10-04-01 08:42 PM
