advice please
#1
Full Member
Thread Starter
Join Date: Dec 2002
Location: dallas
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
advice please
i am getting ready to ad the following mod's to my 93. (i am just now reaching the 1000 mile break-in on new(rebuilt, malloy) motor). pfs ic, pfs cia, rb dual cat back, pfs piggy back(car already has bonez downpipe and high flow cat). i am going to have a wide band before installation( probably lamdaboy). my question is what guages should i use. i have evan's coolant so i am thinking of not getting a water temp. i am getting a boost guage of course. i am thinking a fuel pressure and egt guage in the center speaker pod that is sold on this site. i have searched and there was a lot of good info just looking for any advice before purchase. thanks and have a good day, craig
#2
I have more fun than you.
Join Date: May 2002
Location: Sand Key/Clearwater Beach, Florida
Posts: 1,078
Likes: 0
Received 0 Likes
on
0 Posts
Get a Water Temp regardless of Evans. You need this gauge as the stock is useless and dangerous (I know) and Evans isn't going to do you a bit of good if it's leaking from some hose or you have a thermostat problem.
Then next, the Fuel Pressure would be better than the EGT out of those you compared.
(This assumes you have a Turbo bootst gauge you said you were getting . If not, you need this immediatley.)
David
Then next, the Fuel Pressure would be better than the EGT out of those you compared.
(This assumes you have a Turbo bootst gauge you said you were getting . If not, you need this immediatley.)
David
Thread
Thread Starter
Forum
Replies
Last Post
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM