- problems with underdrive pullys
- V-mount
- Greddy pullies + Pettit's underdrive main pulley
- No spark - Previously Haltech Owners Please Read
- Finish the rear of my FD!
- What headlights for cwest headlight kit?
- Learn me on Rotary!
- yet another coolant thread, trust me, i searched
- Compression ZERO
- Need help on FD thats been sitting for 6 years..
- vacuume line replacement
- who is using the hks evc 5?
- Intercooler piping
- Rich = Knock??
- Flickering of driving lights...
- Shooting for 350hp. reliable?
- Summer is here....AC question
- Idemitsu
- Block Off Templates Anywhere?
- FMIC and bigger radiator, what do you all think about this idea
- opinion on exedy clutch?
- Oops!
- New 1200cc secondaries injectors from RCEngineering
- clear headlights? ? ?
- Twin Vs. Single
- AC from R12 to R134a...
- Smoking after spark plug change
- Who makes poly motor mounts?
- Overheating, busted AST...
- Aftermarket Ignition Coils, and other parts.
- ECU electrical connections
- Dual Oil cooler connections
- Anyone have a pic of a modified rebar?
- Counterweight installation
- starting problems
- Rear window demister no going?
- Rear diff. gasket??
- While changing sway bar bushings...
- Fuel pump resistor and fuel related question
- 3000rpm start, no longer happening :(
- sard fuel rail
- Line Lock??
- is there a fuse here?
- Too many freakin' hoses.....help needed!
- Got oil coolers?
- Japanese Spec Workshop manuals
- Just washed the 7, enjoy the pics!!!
- No primary boost
- how can u tell authentic 99 tails?
- WOT while upshifting question..
- FD single question
- looking for FSM online, anyone know where to DL?
- Clutch disengagement 300 miles after replacement
- AST the same as Breather tank?
- what do you think of this ??
- 99 Taillights(genuine) swap for..
- NPG+ in 110F air temperature
- oem fuelfilter with 2 255lph pumps?
- Take A Look At Your Headlight Covers!
- Grounded the alternator- car won't start
- Body Electrical Troubleshooting Manual
- LIM gasket job update
- vacuum line
- Just got oil changed
- Quick Efini Y pipe Question
- A positive Mazda Dealer Experience
- Non Sequential Profec B help!
- Chromolly Roll Bar/Cage
- dash removal
- Big difference in airflow between stock MP and High Flow Cat?
- Modified RE amemiya Intake
- Radiator Drain Plug Broke. help plz
- gearbox 6speed?
- Newbie
- need help pulling out the radiator
- Update on rebuild
- newbie here.... lookin into 1993 RX7 TT????
- Driving with no ps/ac belt
- Body Panels
- Pics of my new ebay brake rotors!!!
- New FD3S, new to me
- Front windshield wiper motor removal????
- 850 cm3 injectors in primary rail ???
- My poor Rx7 won't start...
- Strange electrical prob
- Cracked AST or disconnected hose?
- New Version of Rats Nest. Updated with Diagram
- I'm stumped! *VID*
- deinstalling a cat converter
- Idler pulley for A/C only?
- Who has a battery kill switch for drag racing?
- Intake question - searched
- Where can i get a license plate bracket that i don't have to drill into the bumper?
- Wiring Mod For Hotter Ignition
- will an RX8 6 speed tranny fit and or be worth it?
- Allow me to Re-introduce Myself..
- Top speed, please post you top speed on you rx-7
- FD Clutch Replacement
- Just installed a Tsudo Catless Downpipe
- How to fab a 'cheap bastard' intake yourself?
- Yet Another Question On Air Pump
- Should I swap fuel pumps?
- FD finally saw some sun: PIX
- "Newbie" first post
- Blitz DSBC specs
- Blown EGI Fuse
- Rev Clock
- losing coolant and ast cap
- Ratsnest
- Oil pan... gasket or not? Also sealant
- help with old post
- ? Starter cable questions and solenoid interchangeability
- Optimum WOT AFR on 91 octane...
- Dents - Leave em? or break paint?
- Tower (Strut) Bar Recommendations - Thx
- want to know..
- Pettit,and m2 ecu questions
- How much fuel are you using?
- vacume hose?
- Crack in the plastic behind the shifter?
- Paint codes?
- wanting a Rx-7 but wanting to know the flaws first before buying
- FYI: Defi gauges DO fit the Tripower gauge pod
- apexi n1 evolution
- Please help...cant find a certain thread
- What to do with my HEAVILY modded FD???
- Noisey Clutch
- Finally Got My Baby!
- Pressurizing system to check for leaks
- anybody use rew turbos/ manifold on FD?
- New motor mounts
- ***Cosmo ECU***
- Engine wiring harness.
- Got it Clean!!
- Will i break anything?
- How rare and how much are rolling chassis?
- Sending out a SOS
- What on the drivers side of my oil pan?
- need advice: cold startup rough, hard to start warm
- Some pics of the FD's (56k go bake a cake)
- where can i find the best price on 1 primary fuel diffuser
- Car Trouble
- Resistor for 1600cc top feed injectors
- new reman low vac
- brake pedal
- Does automatic trans. tach work for manual trans?
- Anyone ever seen code 40, "purge control valve solenoid" CEL?
- A few Questions
- wiered idle
- Finally got my car back, a few pics.
- coil pack?
- Dash pod???
- Colant leak...need help!
- Nos on an FD
- shifting problems, transmission? need help!
- Kirkey racing seat install
- help please 93 R-1
- Help with installation of the Hi-6 igntion
- Installed TechEdge Wideband and street tuned for 1 bar
- afternoon photoshoot
- New here and looking to buy a '93 RX7
- mold on front end
- Crappy plastic interiors...
- How to support motor from below, pulling motor mounts
- Brake Light Switch Rubber Bumper Stop
- Removing the air pump???
- boost controller setup
- Does anyone else think the 99 front end looks bad
- i got some weird problem... O_O
- Power Steering Pump Leaking
- I have a boost Problem
- unusual engine check light
- only 8 psi?
- Rust in spare tyre hole/area?
- rust in boot area?
- question on the 20b motor I want to buy one and install
- Help with Battery Brackets
- Strange Start Problem
- powerfc: need engine harness wire verified
- fan belt size?
- Electrical Bulkhead Terminal
- SMIC VS. FMIC Which do you run?
- Very poor fuel economy, normal?
- anyone have some good pics of the panspeed bumper?
- What size pills to reduce boost by 2psi?
- How many First Owners of an FD's are there??
- Bucking in 1st gear
- Knight Sports
- pics of fuse box area needed
- how to port wastegate...
- *pics* shipped my car off, goodbye rx7club!
- Just another '99 conversion
- Question: Powder coating suspension parts??
- gotham racing milled primary rails
- Can someone tell me what this is??
- new times after Kan tune, 1/4mile
- where to buy Engine Torque Brace ?
- driver side outside door latch is sticking
- I'm starting to suspect my engine MAY have been rebuilt once already...
- XSPOWER Intercooler??
- *Pics * After carwash :D
- No fuel entering housings, WTF?
- muffler seems to be hitting the sides?
- Spring perch ?
- Wiring Diagram
- oil change questions
- Boost leak
- boost at tickover
- ABS Malfunction
- is this a central locking wire?
- what average speed do you drive your FD around? (legal or not)
- Wiring harness confusion... Help!
- I WANT to run 7psi of boost......
- stock security system
- Fixed my secondary turbo issue, but what is this small filter?
- can you help me ?
- Overall cost of reliability mods?
- get your 1993-1995 FSM here
- OEM RX7 OEM Scuff Plates - Anyone install these?
- twin power and aftermarket coils
- Tower (Strut) bar 93-95 R1 - OEM - Can anyone point me to one of these?
- Apexi Engine Shut Off Timer - Worth It?
- Apexi Engine Shutoff Timer - worth it?
- Fan/Feul Line Recall - What gives????
- just a warning
- stalling sputtering new one on me
- injector upgrade...
- Profec B Tuning?
- Catback installation question
- What does this port feed in the exhaust manifold?
- Am i safe for the summer without a Boost Controller?
- has Anyone here Painted the mesh plastic in their Side Vents ??
- Fuel in Engine Oil !?
- Battery cable size and replacement
- Anyone buy from ewheelz.com??
- where does this harness connect to?
- I knew it would happen sooner or later. Looks like sooner.
- 2005 RE Amemiya GT300 in air tunnel
- Problems
- wanted a how to or write on engine rebuild
- wanted a how to or write on engine rebuild
- Sleek headlight with Projector headlight
- pills
- Just had the car re painted
- Boost and other issues
- Clutch and Flywheel combos
- Interesting discovery upon teardown of my engine...pics inside...need advice?
- how difficult would it be to install a/c after its been removed
- SSAUTOCHROME is doing SMIC's now
- Intake manifold design!