Blitz DSBC specs
#1
Full Member
Thread Starter
Join Date: Aug 2003
Location: Sydney, Australia
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
Blitz DSBC specs
I'm soon buying a Blitz DSBC off my friend but I didn't check if it was a spec S or R. Just wondering if it's OK to run the spec S version with my stock twins? What difference is there by using two solenoids, as this is the difference between the specs.
Just to add I'm going to buy this EBC and install my Microtech MT8 w/laptop software and put in a full 3" exhaust w/ HF cat soon and also removing my airpump. Just an update
Thanks,
Joseph.
Just to add I'm going to buy this EBC and install my Microtech MT8 w/laptop software and put in a full 3" exhaust w/ HF cat soon and also removing my airpump. Just an update
Thanks,
Joseph.
#2
RX-7 Bad Ass
iTrader: (55)
Blitz makes good boost controllers, but they have made a TON of them over the years and it's hard to keep track of which one's which. Regardless, most any of them should work just fine for you.
The R is just supposed to have a bit better response, and the S is the less pricey version, but it should work fine for you.
Dale
The R is just supposed to have a bit better response, and the S is the less pricey version, but it should work fine for you.
Dale
#4
Full Member
Thread Starter
Join Date: Aug 2003
Location: Sydney, Australia
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
Just got the Blitz boost controller today and wanted to post pics of the electronics that are going in soon as I stock up more cash! How can I tell the difference between spec S and R by looking at the parts? It didn't come with manuals.
The MT8 is upgraded w/ LT software, the sticker on the back identifies this upgrade.
The MT8 is upgraded w/ LT software, the sticker on the back identifies this upgrade.
Last edited by Ripzta; 05-23-05 at 06:58 AM.
Thread
Thread Starter
Forum
Replies
Last Post
edgars95rx7
Link Vi-PEC
0
10-01-15 01:59 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM