? Starter cable questions and solenoid interchangeability
05-18-05, 10:08 PM
#1
? Starter cable questions and solenoid interchangeability
My solenoid that is acting up, but I'm upgrading the wires while I'm there.
After reading the archives, the consensus seem to be that the starter cables (positive and negative) are fairly weak components in the chain.
Hence, I'd like to replace them with 4-gauge or 2-gauge wire.
Does anyone know the lengths and ring connector size so I can make these ahead of time ?
Also, are the stick and automatic starter solenoids interchangeable ?
TIA,
:-) neil
After reading the archives, the consensus seem to be that the starter cables (positive and negative) are fairly weak components in the chain.
Hence, I'd like to replace them with 4-gauge or 2-gauge wire.
Does anyone know the lengths and ring connector size so I can make these ahead of time ?
Also, are the stick and automatic starter solenoids interchangeable ?
TIA,
:-) neil
05-19-05, 11:15 AM
#4
www.rotaryresurrection.com has a nice bit on replacing the power cables and grounds.
looking at the parts diagram, the starter solenoid (assuming I'm looking at the right one, 24-760 "Switch") does not appear to be interchangeable between the manual and automatic versions. They are not the same part numbers. I suggest you go to www.iluvmyrx7.com, download it, and look for yourself on page 1-J8.
Dave
looking at the parts diagram, the starter solenoid (assuming I'm looking at the right one, 24-760 "Switch") does not appear to be interchangeable between the manual and automatic versions. They are not the same part numbers. I suggest you go to www.iluvmyrx7.com, download it, and look for yourself on page 1-J8.
Dave
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM
