who is using the hks evc 5?
05-25-05, 07:16 AM
#4
05-25-05, 10:10 AM
#5
Apex seal blower
Join Date: Mar 2001
Location: Toronto, Ontario, Canada
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
You PM'ed me a question about the setup. Since I had the same problem before because I had lost the manual I would rather post it here for other people to know.
On the controller the valve hookup is as follows.
Make sure you turn the controller to popet mode for external wastegates. The switch on the back of the unit with the volume *****. Make sure the power is on the the unit when you do it otherwise it freaks out and gets upset
(External popet Wastegates)
O - Top valve of the external wastegate
I - Take a feed from your turbo housing or pipe BEFORE the intercooler. Use a T fiting to send a line to the I of the controller and the other line to the side valve of the wastegate
B - Manifold pressure. Just use one of the nipples at the bend on the UIM.
Raven
On the controller the valve hookup is as follows.
Make sure you turn the controller to popet mode for external wastegates. The switch on the back of the unit with the volume *****. Make sure the power is on the the unit when you do it otherwise it freaks out and gets upset
(External popet Wastegates)
O - Top valve of the external wastegate
I - Take a feed from your turbo housing or pipe BEFORE the intercooler. Use a T fiting to send a line to the I of the controller and the other line to the side valve of the wastegate
B - Manifold pressure. Just use one of the nipples at the bend on the UIM.
Raven
