- Tranny and rear end strength...
- Help electrical issue's
- Re-speed brake kit ?'s
- Power Steering
- How to tell if motor is ported
- How to buy gforce tri link
- Yes, another no start thread. (not a noob-searched)
- FMOC partially installed precausion question
- gauge cluster
- Got a parts car! Yay! No Keys!
- wheels on a gsl
- SA LSD rearend upgrade.
- Tranny shaking when engaging into 1st
- 1st gen Rad replacement...
- Turning clock off?
- Any gotchas installing RB exhaust?
- back to the Wankel!
- Heater hose
- help removing the choke cable and box
- GSl-SE and GSl LSD differences?
- Anyone have good bad exp. w/ GP1 duraflex body kits?
- T11 into 12A car, I know search:) but the driveshaft?
- 84 rx wond start please help!
- Doing my own paint-job!
- Cheap Suspension
- Anyone try putting a 2000 + Miata Dash or 2000 + Mazda 3 Dash into their 1st Gen ?
- FB trany into SA
- Wipers inoperative since engine swap.
- (gsl-se)Engine won't stay running
- Jacobs Electronics: ACCEL 8.8mm Spiral Silver Plated Copper Core Spark Plug Wire Sets
- 2 questions.
- Electrical wiring diagram needed
- Curious about interest of the Rota Rewinds but in the right pattern for the 5x114.3
- Driver door handle and lock electronics.
- i need third link pics
- Bridgeport Carb.......Opinions
- looking for pictures of electrical
- K&N and Sidemarkers
- Carb question
- Oil leak question
- TII rear end in a 1st gen, Has it been done?
- 80-85 Radio bezel
- Nikki Carbs....
- Transmission interchange question.
- suspension question
- Need Help Identifying Wire
- Clutch fork compatibility question
- Ford 8.0" rear end swap
- Suspension bottoming out in front!!!
- Intermittent power loss
- white "haze" smoke. (searched)
- Another turbo thread.
- Short Shifter (searched)
- Straightening a Unibody?
- My new project car.
- Vents behind doors - do they come out?
- Instantaneous Loss of Engine Power
- Delorto 48mm carb information needed.
- Megasquirt.
- Cruise control cable interchangeability
- No + voltage at B terminal on alternator!
- power loss and throttle stuck
- Need new suspension for rear
- Someone please measure their door panels for me
- Hatch Strut With Wiper
- I just bought a Nikki Carb rebuild kit...
- 1980 rx7 backfire
- oil pressure sending unit?
- Noob looking for some help regarding 13bt engine conversion.
- Project Thread: Cartech SE Turbo Kit Install
- Lowering the rear
- idler arm-- TRW same as MOOG?
- Idea for the idlerarm
- Body Moldings - to remove or not to remove?
- Electrical fire after new battery installed and ground wire
- omp linkage??? checked fsm
- A/C question. How to remove system from vehicle?
- I Blew the coolant hose that goes....
- Rear Hatch Seal
- Suspension upgrades. What are the choices?
- lug nuts (studs)
- rear hatch window?
- What plugs, etc., to use?
- Wheels and Tires
- Stereo surround differences
- Which gear ratio preferable? 3.933 or 4.076
- clutch hydraulics, which component
- Steeringwheel play.
- Stock Nikki with my half bridge 12a
- Lights On Chime
- parts swap, just curious. (82 vs. 85)
- Coolant low level light on.
- FMOC replacement help
- Grinding into second gear.
- Help With Sunroof
- Electrical connector identification needed
- thanks to everyones help...my refurbished car
- cutom trany brack pic making from scrap
- exhuast over heat light
- automatic 1st gear whistle
- 2nd gen plug usage in a 1st gen question
- B&m 144 Supercharger On 12a PP
- Poor idle, engine misfire on 84 12A
- electrical issue: lights keep the radio on
- Electrical short problems
- Immediate loss of power.
- What wheels are these?
- Brake light warning light on dash..??
- Got it started... runs like crap... pinging and knocking noises
- suppose to be a 1 inch drop but it doesn't look it in the rear
- Engine rebuild questions
- Best Back End?
- voltage dropping
- Fuel tank interchange information
- weird viabration?
- starter and fuel pump
- Power Antenna Question
- Power loss when hit 3rd gear
- What does our LSD look like?
- Strut housing/spindle bent?
- Brake Bia's....??
- Ready to hop up my 7 - 85 13B
- performance help
- my seven project (pics)
- sleepy eyes
- New Projectiles: 3mm Rotary Aviation Superseals
- question about flywheel balance
- Fuel pump options
- SA front end rebuild kits?
- cold start problem
- Noob with a driveline noise
- Holley Gurus!!!! Please Help!
- Fuel pump clicking like crazy
- are there different 12a's
- 20B Curiosity
- Engine dying once warmed up.
- Does changing timing effect your AFR?
- Ignition choice question.
- Cold Mornings = No Tach
- Hawk HP Plus with X drilled and Grooved discs
- emmissions
- Resonator for my FB
- 12a block
- Full Racing Beat exhaust?
- Hard starting and glowing at converter
- Has anyone seen these wheels?
- Engine runs great... Should I be worried?
- Porting the engine
- Question on where i can find....
- Seized oil cap?!
- Clutch Questions
- 10a rotary engine apex seal
- Fpr and Fp gague ?
- Brake Booster/Idle ?-Searched
- New Battery, DeFlooded....Starter is fried...
- How and what does a syncrometer do?
- N/A 13b into 1st gen?
- Quick question about brake fluid.
- Reliability Mods and More...Much More!
- Help! Collision switches on an FB?
- OMP testing information needed
- fuel delivery question... searched but no luck
- Other Mazda's with 4 x 110?
- F@$&#%G Caliper Bleeder screw!!
- Choke Cable/Box 1985
- Puzzled by stereo problem..
- Igniter Wiring
- 2GCDFIS with MSD coils
- Fc 5 Lug Rotors
- Cold start problems?
- Gauge cluster
- Where can I find hub adapters?
- Lexan Hatch
- Ongoing no fire to leading side on Sa model
- gas tank help
- Holley carb help please.
- length of dip stick
- Power window install ?
- Engine rebuild or rebuilt engine? I'm thinking rebuilt engine. Your thoughts?
- '80 Air Mixture
- Electrical Gremlins
- Storage of my 7 questoins
- Walbro fuel pump.
- Speedo Went Out.
- My SA Series 5 project
- 12a oil pan qustion
- 3rd member bearings.
- Car sat for awhile, now won't start.
- apex seals
- Info on antenna for '79 Rx7
- GSL-SE Axle nut torque
- Engine running poorly, car has sat for awhile
- For those with cone air filters installed....
- 1.3b, weak power...please help
- Hot air recirculation
- FB roll cages, need a PA local car for measurements.
- No Bubbles
- I passed emissions !!
- 12a Rotary Compression Check???
- Weird acceleration problem
- Anyone ever hear of alessio wheels?
- Full Carbon Fiber Widebody Conversion Kit
- Junk Yard Throttle Body for a Niki manifold.
- turbo nikki carb flooding
- extremly rough idle with smooth acc
- update 12a with Garret GT42
- Coilovers
- One sided play in sterring!
- Brake Pad Cmpany Comparisons
- Has anyone gotten the vacuum advance to work right with an aftermarket carb?
- 1st Gen Mazda Competition Prep Manual???
- Stage 2 Racing Clutch
- s5 JDM TII in fb pass CA smog?!?
- How much paint does it take?
- Panhard Bar...
- Rough idle
- SA Brakes
- Ground your fuel pump? guess so
- Brake and random sensor Question
- Another push button starter thread.
- How to tell between S2 and S3 disk rear?
- anyone ever relocated their front mounted oil cooler ?
- Question about a weber carb
- Diff
- 2 cars. One engine. FB or FC?
- carb swap? good or no
- Between OMP lines
- Ways to increase compression on 12A/13B?
- New 1st Gen Body kit on the market
- SA Front Brakes and Suspension upgrade?
- gauge cluster
- Does anyone have a Fiberglass or Mariah Hood?
- Clutch disengagement problems.
- level sender servicing question
- RX-8 tranny into SA?
- Flames shooting out of tailpipe. Engine running rich?
- 12A-T vs 13B-T
- What is the S4 Intake mod?
- Broken temperature guage.
- "Porting 5th & 6th ports" OR "Good site to explain porting rotaries"
- rims for 84
- weird electrical problem? headlight motor
- Funny exhaust pulses during warm-up
- took apart the 13B for $85
- So, the bolt on the back of the alternator goes directly to the battery right?
- Amazing what an emblem will do...
- aftermarket airdam question
- Gsl- Se flooding information needed
- Piping size?
- Custom Light Cover Scoop (Pics)