is there any way you can do sleepy eyes without having to buy anything... i want my lights to look like 13 beefs.. im not sure how to do it and i dont want to break anything

 

The *** to adjust your headlights, should be under the rubber boot if memory serves correctly.

 

If you wana do it the proper way like my car, go to this thread man. In aus we call it 'lazy eyes'.
http://www.ausrotary.com/viewtopic.php?t=72556
You can do it all for round $10AUS. Not bad at all.

 

This is a technical question and belongs in the other section. :-)

KIDS!

 

All you need is a switch u can get one a radio shack or even an autozone not very expensive I just did this actualy not hard to do. here is the thread i used. https://www.rx7club.com/showthread.p...ht=sleepy+eyes

and u could have found a bunch of threads on this by searching. sleepy eyes or half way head lights or even layz eyes. its not hard to find.

 

Don't know if ya noticed..... But my car has the 'sleepy' or 'lazy' eye's done to it...
Follow my link and you can't go wrong...
All the sleepy eye's is.... In simple terms... It's a kill switch linked to the 'power' wire from your switch that pops the lights up.. Turn kill switch on..(cut's power to the retractor switch) Turn 'on' your retractor button(which would normally pop up your lights, but because the kill switch is activated they don't) Then all you do is flick the kill switch off....(Lights re-act and start to pop up) Then you flick the kill switch back on so the lights stop in that spot...
Pretty simple man, not that hard.

 

so do you just turn the **** or what...

 

Where is this magic ****? Hidden under what rubber boot?

 

Hes refering to the manual raise and lower *** on the headlight motor. Just pull the rubber cover off and presto.

 

<a href="http://photobucket.com" target="_blank"><img src="http://i94.photobucket.com/albums/l108/mtph/sleepy.jpg" border="0" alt="Photo Sharing and Video Hosting at Photobucket"></a>

i like this but how can i get it so that the way my lights are now i can raise them up to actually use the lights and make the position they are in now the down position

 

i like this but how can i get it so that the way my lights are now i can raise them up to actually use the lights and make the position they are in now the down position

 

the **** wont let me move them, it just moves a little then spins then they just go up then down again. it say remove fuseable link 15, but i cant find it, is it the one under the steering wheel or the one under the hood?

 

i unplugged the red and white wires next to the *****.. they are clipped together and then when they are unplugged you can adjust the **** and they go up and down..