- Need some help finding JDM/AUS parts
- Just Finished my new Tail Lights
- project car
- How can I bypass my afm?
- Black plastic piece in a slot on bell housing starter rim?
- AC Grommets on Firewall removal
- Oil Problem?
- Need help asap!! please and thank you
- Wiring Harness swap
- Anyone have pics of wheels 15x7 +20 on an fb?
- How to clean up wiring?
- Raising compression ratios?
- 85 GSL-SE idle problem
- Where do the coolant hoses go that run from the w/p housing& the rear iron on a SE?
- need some help guys.
- SE Surging and Stutter prob at 3k rpm.
- gsl se fuel pressure
- FSM link for my 81 ???
- FC Seats in a GSL-SE
- Grinding noise from transmission area while in nuetral & car trying to go forward.
- Starter Noise
- car wont start with out choke
- Removing sunroof/welding in solid roof skin
- Vacuum Solenoid Color codes
- dash is out, what would you do?
- power loss
- Coolant leak in odd place
- Broken rear wheel stud!
- How do I get the steering shaft out of the housing?
- does anyone have an edelbrock carb on a stock-port 12a
- Machining my stock flywheel (maybe)
- fc gas tank into fb
- S5 alternator, now dummy lights are on
- Rust Repair on rocker panel?
- how do i get rid of my voltage reg.
- Stock FB wheel offset?
- resetting the timing
- TII and a 12A diff?
- Grinding from tranny?
- hood latch
- Does No Leak fix the dowel O ring leak and bad oil seals?
- Input shaft question?
- Build and tuning/setup questions
- What's up with the 3rd-gear problem with SA gearboxes?
- SA rust spots
- GSL-SE bogs bad under full throttle
- My 81 build
- which carb what tune?
- Adjusting clutch?
- Leak of Death
- Part throttle stumble
- gsl-se Power Steering
- power steering bracket
- Rad temp/level sensor?
- Disable / remove trailing ignition
- Water temperature gauge inoperative, coolant light on?
- Torque converter removal.
- 3rd Gen fuel injection to 12a engine question
- Another "What's this" Thread: Oil Pan part (not oil level, the other one)
- Turn the ignition key but nothing happens.
- Under heavy braking the pedal seems to travel excessively?
- RX7 on the Road!!!
- help need with my 85 gslse
- in dash cd player kit for an 83?
- refueled...now wont start
- bac block off plate
- gas tank
- Winter Prep
- GSL-SE intake on 89 to 91 13b turbo engine
- Starting a rebuilt motor...?
- Car wont start while hot
- Exhaust flange gaskets keep blowing out?
- my project
- Streetport 13b plates? And..how do you get exhaust sleeves back in?
- Sticking brakes after master cylinder rebuild
- gastank leak
- Header Return on Investment
- Hood Pin Poll
- Gauge Readings
- New (to me) 1985 GSL - SE - Steering question
- gas tank problem
- Clutch wont release
- New Tires?
- Rx7 Runs! 1st time in years
- Rubbing Front Left Wheel
- My first project car!!!(problem with the idle
- tie rod hlep
- rough jerking(lol)
- blendzall oil premix 12a
- no trailing spark and no tach ??
- ok. identification help plz
- FB: S4 TII swap....
- Reassembling a GSL-SE & No start condition>
- powering manual door locks with keyless entry?
- 1980 tii
- 3" inlet muffler with dual tips?
- Failing California Smog Test
- Quick question about an '85 GSL-SE
- my redline suprise
- Stock 80' Rx7 ready for mods...
- Anyone running a bridgeport 12a with Racing Beats street port full exhaust?
- oil seals smoking!
- What steering column do I have?
- TII exhaust manifold question.
- porting size = rpm max hp is made?
- turbo oil feed question
- wheel bearing question
- differential rebuild. need advice
- Who keeps stealing my brake fluid?
- Suspension/Steering Issue when making turns
- Noise from Rear end...
- 4 questions please take a look any and all help and info would be appreciated.
- blue smoke
- ??CHOKE QUESTION?? on a 1984 RX7 GSL
- Anybody Have the Atkins EFI Kit?
- easiest way to change shutter valve
- Jammed lock linkage
- touble starting 84GS this morning help please???
- carb questions
- Disconnecting clutch hydraulics hardline?
- Backseats?
- What's this connector? Can't find in diagram
- Can't get this thing started!
- What is the function of the air bleed in Fuel Injected Engines?
- Center Console Setup Help
- Dash lights blinking at idle / low voltage..??
- Sta-Bil vs Sea Foam
- Fuel pump relay
- Which fuel pump?
- 1985 rx7 gsl-se wiper motor issue!
- Konig Wheels for an SA22?
- Synchros and bearings
- Are GSL-SE axles to long for a 84/85 GSL rearend?
- Which rear LSD Disc brake rear is an exact swap into a SA22??
- Locking Cylinders
- weber 2bbl progressive weber on a 12a
- tore down another 12A
- idle problem
- Help me choose right water pump please
- What is the fluid capacity for a 5 spd transmission?
- Rear axle question
- identify this model, "harder then expected"
- GSL SE full throttle problem
- Headlight linkage assy
- 12A Shutter/coasting valve tech question
- rack and pinion info
- S5 T2 engine with SA trans and GSL rear
- What's this port?
- 85 Rx7 12a Will not turn over (followed the guide!)
- JDM Turbo
- heater or defrost?
- Ooops, main pulley holes don't line up.
- Exhaust Collector Issue, Need Suggestions
- EFI Fuel Lines (Supply & Return)
- Door lock cylinder....how to disassemble?
- need a bit of help with 45 DCOE
- 3 main fusables later
- Hvac wiring
- What does this switch do?
- Cruise control switch?
- Flywheel ????????
- 12a turbo with TII parts?
- clutch pedal travel
- injector questions
- 84 GS hollow Cat?
- targa RX7?
- Anyone on 13" Panasports?
- 48mm weber on 12a 4port
- starter be causing smoke?
- cruise problem on GSL-SE
- SA alternator replacement
- SA engine bay wrieing harness.
- 85 fb ideling 800 BUT!
- exhaust overheating
- Replacing or painting the roof liner ?
- Another slow Build thread (56K noway!)
- Combo switch 85 GSL-SE, will it fit my gsl?
- Just got 85 GS And got ?
- Electrical problems with turn signals
- Now I am having transmission problems...please advise
- Gsl-se tranny noise. Help!!
- Boosting a 12A
- Interesting probelm (SE actuator related)
- Rats Nest Removal Q
- how to install Racing Beat header
- better cooling for gsl se
- Quick question about the front sway bar holder
- wire tach with no trailing?
- Idle problem: cold stall and stall after rev
- Oil leak (front of engine)
- Original Headlight Lens?
- Rebuild Kit?
- strange fan relay kit....
- Oil wiring related question.
- Changing lug pattern options on a 79
- different alternators in 79?
- Noob Question...Oil Injection
- Emissions issues... getting ridiculous
- timing--just trying to understand.
- High spring rate question
- The Great RX-7 Rally Car Build!!!
- fuel line question
- homemade compression tester
- Need advice on engine that has been sitting.
- 13b rebuild damaged?
- holey on 12A
- Stock fd muffler on a fb?
- Struts
- choke problem.
- Spark plug question
- Engine will not run with all plugs in?
- A few thread pitch/sizes needed, coil question
- Project Keiko - Thanksgiving Update and New Owner!
- 1st gen parts weight list
- Engine Swap
- MOds needed to fit sterling onto holley manifold
- Hey, what's this sensor for?
- Opinions on the sterling carb
- exhaust
- photos of mindtrain and racing beat headers
- If an alternator dies on a SA does it make the tach act weird?
- Secondary throttle butterflys wont open
- rotor housings and plates
- 84 GLS-SE Tranny Help please
- GS ring and pinion into GSL-SE Diff?
- Replacing the Clutch, and diagnosis of failure
- how do i drain ALL radiator fluid
- Grinding noise while decelarating
- gonna start tinkering soon had a few questions WARNING long post
- What to watch out for when buying?
- rearend gearing
- GSL-SE rear brakes with out the GSL-SE rear axle
- Tach wire ?
- A/C Questions
- Are rb carbon racing seals good?
- carb an intake manifold
- No spark after S4 13B swap
- Anyone ever do a write up on swapping a FC cross member
- Figured I would post a project thread with pics of car I have been asking about
- HELP installing distributor
- AGAIN!! autolites destroyed my seals! help
- 1984 Mazda RX7 GSL project asking for tips
- Winter Storage
- Hearing a wierd sound when I shift
- S4 exhaust manifold question?
- help with carb
- Auto trans leak?
- 85 fb+s5 13b+fd manifold&turbos=possible?
- 12a front cover interchangeability
- use a turbo as a muffler