- 12A mods: realistic or not?
- Brake Fluid/ Brake Line Problem
- Strut rod bushing fitment issue
- Should I do it?
- How loud are without the cat?
- Front bumper adjustment
- Thinking of buying a 1st Gen for a Rally Car... have some questions.
- runnable?
- weber 40dcoe jetting
- Weber 45DCOE Jetting Recommendations - 13B 6-port STOCK
- 83-84 dash conversion issues
- Need Ideas to Fill This Gap Around My Radio
- Calling all Grant steering wheels!!
- TII turbo.
- Champagne Test as well as other issues (searched & lengthy post)
- help me please
- What do I need to do to drop my JDM S5 TII swap into my 1st gen
- Manifold glowing red
- Holley 465 problems
- Steering Question
- front wheel bearings...
- Getting the FB track ready for next year.
- Good shop in Milwaukee WI?
- motor swap ?'s 84 engine to an 83 problems
- Door Seals - Metro LM107
- what is the jetting setup on the racing beat holley?
- assistance please
- GSL-SE Will 16x8 + 26 wheels fit the rear?
- FC crossmember in a FB...steering!
- 81 GS giving me issues
- sterling carb fuel economy
- curious swap
- Hooked up my MSD Wasted Spark, another question.
- Putting 16s on the FB...what tire size??
- Help with Struts
- Carb questions
- Throttle Cable Solutions?
- Sterling install questions
- hooking MSD to my 7, leading ignition
- O rings under oil filter pedestal are pinching / curling
- power window failure
- Rebuilds are sketchy.
- shifter slop
- 4 Port 13B
- GSL-SE Power steering problem
- how to change o rings?
- Engine runs rough only at certain speeds.
- How to tell if clutch problem is master or slave? GSL-SE
- Separating oil pan from engine on GSL-SE.
- Strange fuel problem
- thinking of buying a 1st gen rx7....
- Hillclimb with a 12A Bridgeport
- Rats nest removal snafu! (where does this vac line go?)
- Testing oil level sender
- racing beat pulley help
- Uh Ho.........
- Need help to ID an unknown relay!
- What is this?
- Need some advice
- Floorboards welding?
- Replacement Fuel Pump Question
- Thank you
- finally got around to removing the rats nest, and ...
- batery cables ,fuel pump ?
- Loss of power at lower temperature
- motor ruined?
- A few questions
- Vacuum line question!!!
- Premix Ratio??
- Oil cooler replacement
- GSL runs rough after operating temperature
- Coolant temp increase after "YooHoo" Belt install
- Carb Electronics
- 83 Ignition Parts
- Need help!!!
- new car check it out
- Where can i get this bumper?
- Window trim issue
- Eliminating cap and rotor and some failing ignitor pointers
- Will a SARD FPR work?
- Rebuilding a Nikki, wich kit should I get?
- rebuilding my 12a....any tips?
- Length of manual trans speedometer cable
- 12a pressure plate torque specs
- Line Locks
- New Exhaust need some tips
- Can you install a FC aluminum water pump housing on a FB??
- weird issue not sure what to make of it
- Brakes/Bearings: Recent retail info
- Cpu
- Mazda FB rear rotors new,where to order ??
- MSD on 12a
- Cool idea - 2 step with 1 MSD box...
- GSL-SE steady throttle hesitation/sputter
- Engine
- At what point should the actuators open?
- 79 SA 12a Flywheel Removal
- Dead electrical system 1985 GSL-SE
- cruise control doesn't work now
- Windshield Trim
- 1985 RX-7 GSL-SE Fuel coming out of the exhaust
- A/C Prob
- Drive shaft / exhaust heat shield question
- backwards rotation
- 1980 does not start - will turn over
- need advice about a/c's in 1st generation rx7
- new Bridgeport has low compression help!!!
- Question about power and clutch. 12a engine
- Whats up love this website
- MSD 6A Tach Signal Accuracy
- Turbo II Hood scoop?
- 12A Teardown Pictures
- Found a muffler, what do you think?
- Using low-lead gasoline
- Oil Gauge doesn't work.
- Loss of power & massive backfires
- I Need Help Making A List
- Quick discussion on OMP GSL-SE
- Weather stripping alternatives?
- Rear Hatch Struts (with wiper)
- Miata gears in a FB
- horrible problem
- two quick questions
- clock keeps cutting off. help
- What did this engine come out of??
- Rear coil springs
- Need Help With Nikki Carb!!!
- 12a vs 13b
- 12a Bridgeport octane and things NOT TO DO!
- coils
- Starter maitenence.
- High oil temp, what are normal operating temps/pressures?
- Tank install trick????
- gsl-se brake master cylinder
- 79 SA Auto to Manual trans swap.
- Fuel Pressure
- 13b housings milled of 12a
- electric fan controller settup
- why is my engine doing this?
- 36 dcd weber jetting
- drag tires rims and suspension
- Is it time to bring the Mariah back to life?
- Mr2 Fans question
- new oil pressure sender/switch--question
- holley dashpot
- coolant leak... or should i say lake?
- holley bread tie test
- Ring gears options
- Will clear coat work for this?
- coolant leak?! where?!
- What's That Smell
- A/C Cycles while driving or at high RPMs
- rim recomendations
- Let's talk about freezeplugs
- gauge
- best apex seals for turbo
- Backing plate/rear axle issue, halp Please!
- New exhaust opinions
- Removing rust with electrolysis
- gsl-se egr valve
- driveshaft
- Reflectix installed - Thoughts and comments
- Transmission problems
- Centerforce II Clutch
- A/C Compressor does not cycle and stays on
- Takes a verrry long time to pump gas
- 12at motor
- pilot bearing question
- GSL-SE timing issues.
- Engine weight?
- Radio problems
- Pics of my finished RX7 project. Finally all done!
- why do my headlights keep going up and down?
- Are Hi-Performance HEI Modules a Waste?
- Cat Replacement pipe.
- My transmission crossmember is broken.
- HELP!!! Putting it back together with a carb on it!
- disposing of old wiring
- A/C Condenser Are They Still Avail NEW
- Dyno'd my Cartech Drawthrough Turbo (12a)
- Color
- Series 3 - gone electric
- Need some assistance re: carb/fuel pump
- Mikuni issue, AFRs
- Weird Issue with turn signals.
- Squeak when turning car off?
- pilot bearing seal?
- Power loss?
- s5 clutch cylinder
- Picture of the clutch pedal/assembly?
- Bosch 44 mounted in-tank
- High idle for no apparent reason??
- ride height?
- Things to replace my ashtray with?
- Anybody have a part number for these belts or a link for them?
- Proper Ignition setup for 12a???
- wing ?
- Engine Bay wiring
- Muffler installation
- 1st Gen Engine Bay
- help! my differential doesn't fit
- Total 12a Engine Height?
- Respeed TII install kit for 1st Gen RX7?
- Brake problem...is it the caliper?? Please help...
- Fuel Pump
- 13B rew swap
- Conversion rear diff pinion flange
- ECU problems
- quick question
- Yet another Nikki problem
- 12a questions
- Need your wisdom. Engine management system
- Starting/Warming up conflicting info
- Brake MC Hard line nut removal
- Looking at a GSL - Front end questions
- 1st gen brake question.
- 8.8 and slicks ???
- Simple Suspension Question
- Need some help with blockoff plates...
- Mallory 4110 pump 4309 reg GSL-SE Tank pick up needed?
- Installing starter switch/button.
- carb removal question
- dual weber from rotary enginnering
- 81 RX-7 Won't Stay Running
- 82 msd resistor question
- Glowing dash?
- Dellorto Frusteration
- so i messed up Bad
- water to oil cooler to front mount oil cooler
- 12a bridge, n/a tranny?
- What are these wiring connectors under the shifter trim?
- question
- RB Header Dent: Should I Bother Fixing This?
- Trans Issue
- Graphic document for replacing Body Parts
- ReSpeed vs Racing Beat and other suspension questions
- AC robs power, can belt be too tight?
- noise after coilover install
- intake porting question
- looking for weather strip
- Dizzy question searches but didn't find
- Simple exhaust question
- Drivers side door switch
- waffle rims painted
- AutometerTach in 12a?
- wrap around intake manifolds
- New radiator
- front sway bar removal
- Exhaust help
- Your Input Needed