Ok, the last of my parts should be on there way, Tomorrow the stock carb and intake are coming off (bout damn time too) and Im going to start mocking the rest up, so I can get my linkage for the accel cable and omp rod figured out.
My question though is for the folks that have hooked up there OMP. I know that the lines run up to the two bungs on the back part of the upper manifold. Just drill and tap, but what did you just as a hook up for lines? just a couple of brass fittings from like lowes?

 

Use the stock nikki's OMP brass fittings. I always mount them on the engine side. For the OMP line, you can slightly apply heat to the stock plastic lines and bend so it can be routed in the OMP fittings. Or you can trim it and then use small diameter fuel lines to extend it. I have been using this technique in years and I never had any problem with oil eating the fuel line.