help, making zero boost
10-21-09, 12:56 PM
#1
Ronald..
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Location: Fairfax/Manassas VA
Posts: 2,013
Likes: 0
Received 0 Likes
on
0 Posts
help, making zero boost
I did a simp seq setup last night and now I'm getting zero boost. I can hear the turbos spool and the bov sound but I get nothing on my boost gauge. I've checked the intercooler hoses and the y-pipe coupler and they all seem to be fine. Does anyone have any ideas?
10-21-09, 03:47 PM
#6
Ronald..
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Location: Fairfax/Manassas VA
Posts: 2,013
Likes: 0
Received 0 Likes
on
0 Posts
I've done that and everything is in the correct spot. Are there any other reasons the boost would not come on? It feels like driving around with the intercooler off.
10-21-09, 03:53 PM
#7
http://www.autosportracetech.com/RX-...erOverview.htm
It's possible that if your Charge Control isn't working properly, you could be venting all your primary boost out the Charge Relief valve (since it will be open during the low portion of the boost pattern). Again, you'll have to check your work. If it was working before you did the work, then it's something you did.
It's possible that if your Charge Control isn't working properly, you could be venting all your primary boost out the Charge Relief valve (since it will be open during the low portion of the boost pattern). Again, you'll have to check your work. If it was working before you did the work, then it's something you did.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM