What intake fits PFS SMIC??
#1
Junior Member
Thread Starter
Join Date: Feb 2002
Location: Northen VA
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
What intake fits PFS SMIC??
I'm looking to purchase a used aftermarket intake system and a used upgraded ecu. I currently have a PFS SMIC and I would like to know what intakes fit with this intercooler. What would be the best performing and most durable intake that fits? What prices should I expect for these used intakes?
Thanks
Thanks
#2
Lives on the Forum
iTrader: (9)
Hey,
The PFS IC is made to work w/ the PFS intake (draws from the 3" duct on the side of the main duct. I have the unit and have been happy with it. I even modded the intake to ALSO draw air from beside the radiator like M2, CWR etc. I think it works very well.
I'm in NOVA also (reston) and i'd be happy to show you my setup sometime.
I may in fact even sell you the intake (i am eventally going to uprgade to a large SMIC, and a fully custom intake.)
The PFS IC is made to work w/ the PFS intake (draws from the 3" duct on the side of the main duct. I have the unit and have been happy with it. I even modded the intake to ALSO draw air from beside the radiator like M2, CWR etc. I think it works very well.
I'm in NOVA also (reston) and i'd be happy to show you my setup sometime.
I may in fact even sell you the intake (i am eventally going to uprgade to a large SMIC, and a fully custom intake.)
#4
Senior Member
Join Date: Aug 2002
Location: Navarre, FL
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
I have the RX-7 Fashion intake, and it looks like it will fit with the PFS SMIC. I'll know for sure in the next couple days. I purchased a 3" flange from Aircraft Spruce, and will be adding that to the side of the intake to use the duct air, in addition to the normal bottom hole. Wish me luck, getting started in a few minutes.
Cheers,
Cheers,
Thread
Thread Starter
Forum
Replies
Last Post
msilvia
3rd Generation Specific (1993-2002)
28
04-14-16 12:58 PM