Adjusted my Clutch like the instruction stated..
#1
Hi Powr FD's
Thread Starter
Join Date: Oct 2002
Location: OKC
Posts: 806
Likes: 0
Received 0 Likes
on
0 Posts
Adjusted my Clutch like the instruction stated..
On the 'Lightning in a world of Thunder' site, there is a link on how to adjust your clutch pedal to be as low as the dead pedal. I did this and my clutch wasnt grabbing, infact it was burning it out. So I slowly adjusted it back to where it would grab again... and its as high as it was stock. Has anyone else ran into this?
#2
I did this about a year ago and it has worked fine since. The only problem that I have found is that when te car sits for awhile there is alot of play in the pedal until the fluid builds up.
#3
Hi Powr FD's
Thread Starter
Join Date: Oct 2002
Location: OKC
Posts: 806
Likes: 0
Received 0 Likes
on
0 Posts
well maybe I did something wrong then.. I unscrewed the clutch pedal rod out a bit, then adjusted the clutch sensor mount. If adjusted the sensor too far out my clutch would grab all the way and I would be burning the clutch. You think it has to do with the rod adjustment or the sensor screw? I put it close to stock position to not screw anything up.
#4
If I remember correctly, all I did was remove the sensor and the bolt behind it and replace te sensor and I screwed it in as far as it would go. Send me your email address, I have a picture.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM