- oxygen sensor wire broken
- Need help putting nose back on.
- Updated: Car won't start...Expert help needed!
- recomended oil vis
- High idle...
- I got 4K to spend.
- need pic of mounted Koyo, and question
- Need a price approximate...
- TSUDO downpipe/midpipe combo I highly recommend.
- why do 3rd gen engine blow commonly
- resonated midpipe
- is my piggyback computer dead?
- help a newbie out
- car over heating
- car starts at 3000k rpms then drops to normal...
- How much HP will I lose switching from Apexi Duel N1's to RB duel tip?
- where can I buy a nipple for my IC pipe
- where do these wires go question...
- Spec clutches
- why would I get no boost after a short WOT run
- Bleeding Brakes w/ ABS
- Diagnosis help... Smoke
- questions on pressure chamber
- Fair deal?
- Rewiring ENTIRE Engine Harness
- Electric exhaust cutouts.
- got my car tuned! yeah! now my clutch sucks! boo!
- DP flange opening smaller than stock?
- 3rd gen able to rally?
- Coldair concepts
- what kind of oil do i use
- Buy Manual and Rebuild It Yourself?
- Greddy FMIC question
- Strange Noise After Greddy E-01 And Boost Guage
- Size for precontrol pill
- Low vaccum at idle
- My speedo stopped working!!!
- USonic Injector Cleaning
- Who's car is this?
- electrical problem (boost controller shuts off) electrical gurus needed asap
- MSD 6A box burning hot?
- clutch problems
- Hi, New RX7 owner, in Maryland
- injector resistors
- Compression Question
- wiring diagram manual?
- Profec B II / Does it help with boost response?
- arrg! whats holding me back?
- Got my Rx-7, finally!
- Please tell me why my car runs so hot!!
- Car died help!
- Rear Differential Failure at 105K
- Deleting parts when putting back together
- 94 FD Air Bag Light Stays on..
- Shooting out flames from the A$$, Ahh the horror stories.
- Weld on O2 bung. What size?
- really Wierd cooling issues
- Leaking Coolant out the Overflow tank whats wrong?
- smoke coming out at specific times
- need some settings for greddy profec b spec 2
- RE N1 hood installed on my FD.
- Removed UIM and replaced - Now IDLES at 4000RPM - Won't Drop!
- Where to get twin plate clutches?
- Engine Harness Pics/Diagrams..need help
- who used a manual harness when they did a auto to manual swap
- M2, SR or RB - Choices, choices.
- Healthy Engine?
- Oil Catch Can mounting
- horsepower?
- Greddy Turbo Timer Help!!
- greddy titanium exhaust
- The quietest exhaust combo?
- Common Trouble With Oem Ecu
- Engine running weird after bein hit......
- Who's had there FD Painted Professionally?
- electrical problems: no power to flasher unit
- Please Help Me Out Guys!!!
- Wondering about warm up
- Hi newbie here
- pre-cat nut stuck
- 850cc in Primary fuel rail how to?
- What to do now.
- car stumbles, spits, sputters, after 4500
- 8-6-8 Boost From a Dig?!
- Blew My Engine (Not the First Time and Sure as Hell not the Last)
- ecu questions (auto trans)
- My First RX7!
- Please help. little popping sound from the intake area.
- need help installing greddy profec b spec 2
- just a warning
- Best Aftermarket warranty...?
- where can i purchase a 99 spec transmission
- Need help (Auto to manual wiring)
- Custom hood, Z3 kind-of oppenning @ air filer area
- strange rattling noise from trans area
- Spark plugs (newbie)
- TANABE Springs 2 inch drop?
- spark break up? or what?
- aero data on FD?
- Size of starter bolts?
- would a boost controller solve this?
- idle problems, is this the end ?
- For Those with Open Intake
- R1 with rear speakers?
- has my apex seals gone
- just lost my rotory virginity
- Salvage / Theft Recovery FD3S's
- FD Stock BOV Hose Size..
- stock psi
- ANy diferance between the Apexi IC's?
- idle problems :-(
- Data link connector?
- quick question
- Air control valve/ Relief valve?!?
- new to the fd club...any referrals to downpipe upgrades?
- I'm Stuck! Help needed, opinions
- settings for the Profec B II for inspection
- Fwin Radiators
- We Have A rear End Problem....
- need some advice
- So close to passing Inspection - Need Advice!!
- check engine light (please advise)
- Who's hollowed out their Main Cat?
- if anyone is interested
- friends NEW 99spec front end :PIC:
- Can FPD be eliminated without FPR?
- Pics of OE rubber brake lines?
- Knightsports EBSIII
- what is a normal idle?
- No power to ECU or Odometer - Everything else has power. Car Won't Start.
- Fair price for a 13B-REW core
- Primary injector seating into rail
- Terrible Idle...
- wastegate actuator ok?
- CRV and Aftermarket intakes
- Anybody ever had this wierd problem I had last night?
- What's the difference (auto & manual motors)?
- I have no odomitor (sp?)
- Boost spikes on sec
- Intake fabrication - how to - pics
- Where did you guys mount your turbo timers?
- pic wanted please
- 13b-re and 13b-rew same front plates?
- Is this worthy?
- Twin scroll?
- Fuse Box
- Interior Lighting Help!
- Which wires does the ECU get it's power source from?
- Fuel Sender
- Which Connectors are these for?
- do you guys drive with ngk racing plugs?
- Put on a midpipe and got a quest
- stock bov
- Ultimate gauge solution
- Mazda crate motors
- AEM ignition ? best olace to buy?
- MAP sensor price in Europe.
- Radiator and water temp gauge went out. Which fuse
- Get your injectors cleaned!
- how hard is a basic streetport
- Are all third gen woners dumbasses?
- Aluminium Motor mounts?
- Looking for underbelly pics.
- Where do I install the sensor for a Fuel Pressure Gauge
- What exhaust is good for FD ??
- question about a DP and MP
- difference seq turbo & non seq turbo??
- Single or Twin Turbo?
- Can I Use Any Kind Of Seal For The Coolant Filler Neck
- missing vacuum line?
- make it go away *buzzer*
- what u guys think?
- WoW
- FD artsy fartsy *Video*
- eh... major problem?
- secondary boost problem
- PPF question
- ask and you shall recieve A reman!
- Boost Issues
- ask, and you shall recieve a reman!
- At what coolant temp do you panic?
- clutch problem being gay again
- Smelly,smoky rough idle
- Apexi intake for 100 bucks BRAND NEW is this legit?
- Where is the cheapest place to get the Apexi intake?
- An Interesting boost problem
- Still more questions about fd basket case
- question about AC lines
- question about tensioner pulley
- Edit progrems For 3rd Gens
- Where to find: Aluminum RX-7 Fashion Intake
- Any Drifter Fds out thier
- Making redline BEEP louder ?
- UIM torque settings?
- third gen switch?
- Are the following mods safe?
- controlling boost with PFC?
- 1/4 mile for auto fd ? w/mods
- 1993 Rx7 Stock Ecu.
- Where is 93blackFD?
- mods
- Wont start..Need help
- Anyone with Apexi Tech meter ?
- Carpet? Aftermarket sources??
- turning heater on reduce heat under hood?
- M2 ECU or Peter Farrell Powertrain Mgnt Sys
- Finally got my RX7! Here are a few pics.
- TFP Polymer is the sh*t for paint!
- secondary boost problems
- Midpipe
- greddy fmic piping...aluminum or steel
- Oil Catch Tanks..Are They Worth It?
- car smokes when I turn off.
- Ecu!!!??!
- are there any differences between 93 and 94 interior pieces???
- idle problem (sorta)
- blitz sbc-id install problems
- Help me out (buying questions)
- i have to ask - why no boost with low gas?
- Trim in air inlet?
- squential vs. non sequential
- turbo intermittent boost probs.
- Oil pan question
- Cooling hose advice needed
- Lets play identify this plug...
- Air Intake Pipes for a better fit?
- Greedy FMIC w/ Apexi Air Intakes..
- Car wants to stall when at idle/no gas, worse when hot
- anybody have experience with Water Injection at the track?
- radiator fans aren't coming on early with AC.
- Hello, AST question
- Don't remove MAZDA letters from calipers!!!
- replacement speed0?
- By pass Air separation tank?
- searched...runnin rich
- Sucking noise at Idle and at Acceleration
- how to recharge air condition?
- Repair manual only from the factory?
- Alex with a C-west kit Where are you?
- i searched and i need a real answer..please read *LONG*
- Weird Tranny Noise
- I need some help (car purchase)?
- Exhaust sounds raspy
- Symptons of a bad Fuel Pulsation Dampener!
- AC Evaporator leaking into passanger foot well?
- 300 rwhp on sequential?
- Low Idle. *searched*
- Interesting Electrical Problems...
- Modify stock FPR to be adjustable???
- Looking to buy