What are the ohm values for testing the oil level sender that goes in the oil pan? My dash light is lite and the buzzer sounds. This is a fresh rebuild and it hasn't even been on the street yet. I know the oil level is ok. I pulled the sender tonight and ohmed it out and I'm getting very inclusive measurements. Sometimes 300 ohms, other times over 1k ohms +. When I move the plunger up, it does read infinity.

I have plenty of spares, I might have to pull one of those and test it.

I looked at the FSM but did not find anything about test this.

 

Specified resistance is 2 to 4 Kilo ohm at 50 to 86 degree farenheit.