ok im trying to convert my doors from manual windows to power windows is there a thread already on this or can someone help me and explain what i should need and do to convert it with ease. i already have motors and regulators and switches for this to be done i just need a little guidence or a picture would greatly help of the door without the panel on it to where i can see the bolt pattern for the power windows..but like i said any assistance would be greatly apreicated and i have searched the threads for power windows and conversions so i did at least try to search for the thread if it did exist.

 

You also need 3 more short wiring harnesses. A right and left from each door motor to under the dash and a 3rd one from the main harness to the switches. It took me the longest time to figure out which harnesses they were and I had a complete harness from the same year strung 25 feet across the floor. Have an enlarged wiring diagram printed off, including all of the plug diagrams. With masking tape and a magic marker start identifying sub-harnesses and connectors. I remember lots of red and green wires in the sub-harnesses. You can dl the manuals from the following link.

http://foxed.ca/foxed/index.php?page=rx7manual

Not a fun job since the radio and center console needs pulled.

 

well i printed out the two main pages for the power windows it probably be better if i had like real life pictures of a car instead of a wiring diagram. and you said i needed 3 more wiring harnesses well that sucks i was hoping to just steal a few connectors off of a old car and just wire it up myself

 

First one I did was a 83 S model and the harness was in place for the window switches. I don't remember if I had to get the one from the motors to the connector harness or not?

What year was the one you did Trochoid?

 

anyone have any pictures on the door with power windows in it