quick question
#1
tookey bird
Thread Starter
iTrader: (1)
Join Date: Jun 2009
Location: lemoore CA
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
quick question
ok so i was cleaning my rats nest and i was moving the delay valve around to get to other things and i snaped the end to it i was just wondering if i could just bypass it temporarily till i can get another one?oh and its the one coming from the switching shutter valve. btw its an 84 gs with a nikki. another question is can u loosen up rubber hoses by puting them in tranny fluid?
#2
Rotary Enthusiast
Join Date: Dec 2007
Location: Texas
Posts: 1,079
Likes: 0
Received 0 Likes
on
0 Posts
How long is temp lol? Have you tried driving it? Order some silicon hose, remove rats nest, replace all nasty old hoses. I have repaired tubes with JB weld. The trick is getting it to dry with hose on so you only have to push it into the metal side.
#4
tookey bird
Thread Starter
iTrader: (1)
Join Date: Jun 2009
Location: lemoore CA
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
temp= a day or two, and thanks is ther something that will loosen up rubber hoses?
i havent tried driving it yet ive been just replacing burnt wires and chewed up wires all day so i haven't goten around to starting it yet i will here in a bit.
i havent tried driving it yet ive been just replacing burnt wires and chewed up wires all day so i haven't goten around to starting it yet i will here in a bit.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM