Top feed primaries, rails and seals
05-18-08, 08:37 PM
#1
registered user
Thread Starter
iTrader: (1)
Join Date: Jan 2006
Location: San Diego
Posts: 2,469
Likes: 0
Received 0 Likes
on
0 Posts
Top feed primaries, rails and seals
Hi, I searched a found a few threads about top feed primary injectors sealing by cutting the top of the diffuser and using that as a seal, but in my own playing with it, it looks like just using 2 of the flat lower O rings would put the injectors in about the right place, and should seal just fine.
Anyone done this?
As far as fuel rails go are there any alternatives to the KG parts rail or is that the only choice?
Thanks..
Anyone done this?
As far as fuel rails go are there any alternatives to the KG parts rail or is that the only choice?
Thanks..
05-19-08, 03:34 PM
#4
Lost You in the Rear View
Join Date: Jul 2007
Location: Rocky Hill, CT
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
i have the CJ fuel setup.. very good quality and i recommend it. also comes with the adapters to use the top feeds without cutting diffusers and stacking O-rings. it is also the only fuel system that i know of that uses rails that do not look like the KG rails. the KG rails are just made from generic extruded aluminum stock that everyone else uses so the CJ rails give your engine a very unique and "modern" look
