- Question about heater output?
- 2 stroke
- atlanta guys help a brother out?
- coloured rpm 99 spec gauge?
- Where is this car - Challenge?
- Look at what I found in Pacific Rim
- FD3S Common rust areas
- Rx7 FD Fuel system.....
- not getting enough fuel...
- My other 3rd Gen RX7 is a Civic
- is there anything truly special about tuning a rotary engine especially a 3 rotor?
- Auto FD, not getting any boost, cant get any power, cant rev past 3k in gear.
- MSD/Coil Help
- Rotor housing resurfacing results
- Do I have to seal the oil pan with mount?
- Current limit on spare spade acc +12v ?
- Pettit downpipe install..one thing after the next =/
- Oil pressure falls as rev goes up once the engine is warmed up.
- FD upgrading FPR & Single Conversion
- Seat belt differences
- What have I done now? Diagnostic Box fire.
- Rats nest staring me in the face, what next? Trying to fix leaking fuel injector.
- Oil burning at high RPM
- Solenoid box aluminium wrapping...opinion?
- Engine dowel pining or studding?
- Rx7 Sway Bar mount
- '98 JDM 5th gear on base?
- boost problem almost nailed down...few q's for the pros
- 5th gear synchro replacement
- DP Install: O2 Sensor ground question..
- Is anyone making a 2014 FD calendar?
- Fortune RX-7 Crashes into crowd
- Fuel System Design
- Pettit Y Pipe
- Torque specs for putting turbos back together
- Getting more power out of my RX7?
- fd: remove rear storage,insert oem speaker covers?
- Replacement Hardware
- Arkdesign Boost Controller
- Radio antenna problem
- ffe fuel rail injector install with pic
- 99 Spec Twin's Reliable Boost?
- Anti theft cut fuel?
- pinion/companion flange auto FD
- ACT Xtreme Pressure Plate
- Caliper Dust boot Clips...
- ACV removal but not the air pump
- Swan Neck Bumper Mount Uprights...
- Headlight Motor Help
- Tdc?
- Side indicator lights
- Does oil control ring have some anti-ficitional coating on it?
- ACT Monoloc Wedge collar
- FD Ignition breakup or?
- fd rx7 question
- Rebuild Specialists!! "A Breakthrough in Rotaries" DISCUSS!
- Carfax history question : FD roller
- Intermittent Cold start backfire
- Crack in rear iron when installing oil press reg... need advice
- Engine Rotor question
- Car cover help
- IAT wiring
- Engine looks crooked
- Broke the nipple on the double throttle solenoid.
- Engine Reinstall
- Resistors where to? For simplified sequential harness no emissions
- Question on removing big bolts & misc
- Gates Powergrip Hose Clamps?
- defi gauge
- Door Handle Issue
- compression test...oh noooo
- Help with a connector please
- How t mount the Spirit-R footrest?
- Super seal question
- D/S Door lock problems
- Preventative hot weather maintenance.
- Who store their car during winter?
- Voltage question 12v - 15.1v
- FFE vs CJ Fuel Kits - You cannot go wrong
- What race spec rotaries actually sound like...
- RX8 Oil Control Ring Rubber/O-ring in FD?
- Factory mazdaspeed a-spec version?
- Lean during Start Up. Issue or Normal?
- Where is my boost going?
- Does your hood hit your headlights?
- V-mount oil cooler idea.....
- catalytic converter replacements
- Removing A/C compressor
- Removing the engine question
- 200mph Rx7 red llimit and 4.444 rear diff
- iat sensor question
- Exedy Twin Disk - can't go into first gear when engine is running!
- Installing aftermarket transmission thermostat, which line is which?
- Have you seen this FD
- window used to work with key out (timer relay)
- Texas Mile FD
- Cooling Issue
- Question on stock Apex seal
- Rear Divider Screw Covers
- Do JDM Headlight Fitment
- engine builders opinion reusing parts
- Torque Specs for Reassembling the Twins after porting
- Feedback on New Innovative LC-2
- Steering rack question
- Manual rack conversion 2.0
- How much is my car worth if I sell: 94 apex'i single turbo FD with FEED bodykit
- Fuel Kits and Injector Choice!
- WTAC 2013 (World Time Attack Challenge)
- FD3S Code05 Knock sensor
- Frustrated with oil cooling system leaking
- Slight overheating problem
- Rear Coolant nipple plastic ?
- Horn wiring
- 725/2000 ID's in stock rails?
- 1993, AC Not Turning On
- Bolt on OEM 43.5psi / 3Bar Fuel Pressure Regulator
- Anyone know how much these go for?
- jdm vs usdm ecu
- Rebuilt ECU or aftermarket?
- Help Troubleshoot Bucking
- rotor housing resurfacing question
- Checklist before going to dyno
- Dented FPR, is it fine?
- FD just randomly shuts off
- pre control / waste gate solenoid plugs
- HKS Sparkplugs - where to buy?
- Looking for some clear headlights for retrofit?
- my '95: Preliminary Outlook and Planning
- Battery Relocation: Remove Storage Bins?
- rx7 wiring harness question
- Ric Shaw Racing FD3S in 2013 WTAC
- engine has sat for three years-rebuild?
- A/C delete grommet
- Y pipe coupler
- cracked rear iron around coolant nipple
- Tap for Secondary Rail
- What is this cable?
- Seat Ride Height
- DIY centre gauge pod
- Need help with this problem.... Car wont start
- FD Testing Event: November 25th Virginia International Raceway
- Tri-point engineering FD gauge setup question
- fuel lines during engine removal
- Removing power steering air conditioner bracket
- Book: RX-7 by Jack Yamaguchi
- Idle speed valve not turning on....?
- How Much Would You Pay?
- Real cheap china compression tube for fd anyone ever try ?
- 1994 FD Touring or Base?
- Front Bumper Gap
- How does the engine bay look?
- Wiper length and dimension
- Hood lift at high speed
- Air pump question/delete pulley kit
- Hissing under boost
- MOP aux tank air pump?
- /Drive FD shoutout
- Stuck Throttle
- What kind of Truck & Trailers are you guys using to tow your FDs to the track?
- Hardlines for CJ Motorsports Dual Bosch Pumps
- FFE Secondary Rails + ID2000 Install?
- Rough idle and misfiring at all rev. levels
- as a daily highway driver?
- Electrical help
- Metal oil filler neck
- Coolant temperature switch delete??(automatic cars)
- which diff brace is better?
- Big bang !
- Is this too much fo a mint FD?
- Buzz from exhaust, solved? need advice
- Unknown vacuum chamber
- No map, tps, omp signal at all reading 0v on power fc. ?
- wire harness wire thickness
- Bonez HF CAT makes noise inside
- Supra denso FP identification
- turbo control solenoid leaky oem plastic cap?
- Cell phone holder/cradle/mount
- Stock hood is not flush with fenders
- How good of a deal did I get on this FD?
- tuner needed Eureka, Ca
- Buying / trading for FD - Thoughts on this one?
- cruise control
- My Brembo BBK Rebuild Project - *Pic Heavy*
- New 4" Aluminum Exhaust
- 99 spec wing dimensions ?
- What sensor is this?
- Rear Suspension Arms
- First problem. FD stalls, super rich cold starts!?
- Gopro Bumper view ;)
- Supra fuel pump (Denso 195130-1020) low pressure flow rate?
- Capping vs Removing + Resistors for Solenoids
- RE-A Sleek Light Install Help
- Car is dead
- Cold compression check
- Just bought downpipe, JetHot quote $180?
- simplified sequential vacuum question
- Help: remove front cover in engine bay, loud ticking from front of engine
- is 6an fuel line enough
- low compression running on two plugs
- Dent Pulling?
- Single turbo - smoking !
- Need help identifying a hose.
- Hold Light Flashing on Petit ECU
- Can I put HID bulbs into stock foglights?
- About to install powerflex bushing
- Stock transmission
- Has anyone ever welded a muffler in the downpipe?
- Ripping hair out, wire ID please!! :)
- Curing transmission tunnel heat
- Retrofitters and Sakebomb headlight users
- egi blown fuse while driving.
- Modified Magazine Front Cover Feature Nov. 2013 Issue
- the fd's best & worst features?
- White smoke
- pintle cap replaced need advice
- good downpipe
- Question about front brake HARD lines...
- Help with my next mods
- Xcessive vs Himni Poly Motor Mounts
- Carbon side skirts/winglet thingies
- Electric Vacuum Pump Brake Bleeding
- Weird speedo problem
- Easiest way to install FD tranny and engine?
- How do I store a short block?
- My FD lives!!
- OEM Engine coatings & plating
- Now this S**t car wont idle at all
- Something inside my transmission wanted to pop out and say hi, what is it?
- Can I change steering effort?
- Replacement Positive Battery Terminal/Clamp
- Restrictor Pills on the 99 spec (N3G1) turbos?
- Remove rear seats?
- Anyone know how to replace cylinder lock
- FD3S Brake Hose/Hardline Diagram Please?
- engine or body
- Petit AST cap?
- stiff clutch driveability tip
- Clean gauge pod set ups and where to buy
- Panel gaps
- Brake problem
- can i run 48mm injectors with kg fuel rails or do i need extenders
- Spec-RE Pro Diffuser Install
- Car cover?
- WOOOOOOOOOOT!! back from the body shop
- Distinct Buzzing Under the UIM
- No sound from right speaker?
- Ignition Amplifier installation
- Simplified sequential with double throttle diagram
- windows wont work
- Stock twin turbo oil drain