pre control / waste gate solenoid plugs
#1
pre control / waste gate solenoid plugs
sorry I was looking at the FSM , the wiring diagrams for some reason exclude the turbo systems
and the turbo diagrams for some reason does not show the wire colors haha
I'm sure I'm missing the right section or skipping over it .
but if anyone would be so kind as to tell me which plug goes on which solenoid as they are twin solenoids , and twin plugs and one plug could go in either or direction .
I used to know because the baked plastic cover had the curves on them But The baked plastic covers broke off . so now they are just wires . and I don't know which one goes where .
I tried looking up the harness diagram but it doesn't label the color of the wires or anything so if any one with working sequentials would be kind enough to take a peek at their solenoid plugs and see which plug goes to which one . I'd be very grateful
and the turbo diagrams for some reason does not show the wire colors haha
I'm sure I'm missing the right section or skipping over it .
but if anyone would be so kind as to tell me which plug goes on which solenoid as they are twin solenoids , and twin plugs and one plug could go in either or direction .
I used to know because the baked plastic cover had the curves on them But The baked plastic covers broke off . so now they are just wires . and I don't know which one goes where .
I tried looking up the harness diagram but it doesn't label the color of the wires or anything so if any one with working sequentials would be kind enough to take a peek at their solenoid plugs and see which plug goes to which one . I'd be very grateful
#2
ArmitageFD3S
iTrader: (13)
The only way I know to obviously tell which is which is because there's a white dot on one of the plugs that matches up to a similar dot on the solenoid itself. If the plug it completely gone I don't know a good way to tell which is which. I'll take a look at the color of the wires when I get home and see if there's anything to go by there.
#3
The only way I know to obviously tell which is which is because there's a white dot on one of the plugs that matches up to a similar dot on the solenoid itself. If the plug it completely gone I don't know a good way to tell which is which. I'll take a look at the color of the wires when I get home and see if there's anything to go by there.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM