Hi I have a usdm 93 rx7 that I bought as a roller but the deal is I have every thing besides the usdm harness but I do have the jspec rx7 harness so is there any way to modify the harness to work in a usdm rx7 also on which harness I do end up with I am going to do a single turbo swap so I am going to remove the rats nest. But should I buy a usdm harness or modify the harness I have.
Thanks

 

First you have to figure out what series JDM harness you have.

I found this:
https://www.rx7club.com/3rd-generati...s-spec-868289/

 

I've done it and its a pain in the ***. If you are not running emissions and single turbo its a lot easier.

 

Hi Im going to remove the emissions and im doing a single turbo conversion but is the xo5 connector the blue connector under the passengers dash were the ecu goes if so I think you have to shorten the connector by two pins because it is two pins to wide.
Thanks

 

Wouldnt the fuse box and cpu as well as the ecu swap sides, making connection points to dash impossible to reach?

 

Hi I heard that they will fit correctly but the xo5 connector will need to be modified to fit.
Thanks

 

Ill post up a rhd complete body harness set up for you tomorrow, I have lhd pics already. You can compare and decide if its worth it or not

 

Hi if you can that would be greatly appreciated.
Thanks

 

You also will have to extend the coolant temp sensor lead.