Somehow, I've lost the pictures that I took of my engine while disassembling. Now it's time to re-connect the injector connectors to the injectors, and the primaries are so close together that I can't tell which connector goes to which injector. (I put ID's on them...should have just labeled them front/rear..DOH!)

Does anyone know which pin at the ECU end corresponds to the front and rear primary injectors?? I checked the wiring diagram from the factory manual, and unfortunately, they don't call out the injectors specifically (they are just labeled fuel injector). If I knew which pin at the ECU end was designated for each injector, I could easily determine which connector goes where.

Or, if they're batch fired from the factory, then none of this matters anyway!

Anyone have any ideas???

Thanks!
Justin

 

Shop manual page F-62 shows where they go. Section F also does have individual ECU pin outs and should show which pin goes to which injector.

I do believe it nees to be wired up properly, I don't think it's batch fired.

Dale

 

Thanks Dale, that's exactly what I was looking for!!

Justin