View Full Version : Single Turbo RX-7's
- Coatings for Manifolds, Down Pipes, and Housings
- The end all debate on XSPower/SSAutoChrome/OBX turbo products.
- How much power to expect with these mods?
- One for the experts Part 2 (pics)
- Has anyone ben in contact with Ron from D&R?
- i'll try this one again...
- Looking for a decent turbo
- Will a Super 60 Trim compressor fit this turbo?
- Turbo Rebuild
- what size turbo is this
- newbie question
- ok just to upgrade seconday 850's to 1600?
- SSAC manifold+jetcoating=stronger?
- Manifold for on-center housing?
- Need more info on the GT4088
- Sneak Preview of my new Turbo
- Divided, Undivided?
- How should I plumb my Fuel pump???
- single and factory motor
- Downside of venting oil system pressure to atmosphere?
- What is the most extream angle that the center section can be at?
- HKS wastegate spring questions
- anyone run this precision IC?
- Tial 46mm WG
- t45 flange??
- Stock Twin Removal
- Gt42r
- GZ LIM and R85 question
- Wheel Trim?
- TA/TV turbochargers
- Gobble noise
- OBX, XS-Power, SS-Autochrome FD turbo manifold owners only
- tial BOV any good?
- tubular manifold?
- turbine & housing trim
- Can't control boost - need advise
- Tial BOV (search doesnt show same symptom)
- gt40r variations?
- Pics of GR67 Turbo installed
- MasterPower Anti-surge compressor housings
- problems with marren fuel injectors, please read, and give your opinion
- Turbo header length
- Innovative turbo??????????
- Help me name that turbo
- anyone running a T67, thoughts?
- A Little Taste: PFS tuned and built ......w/..GT 42R
- going single and aem ems is true that i dont need solenoids and only few vacs?
- Cheap Turbo . com??
- apex seal question?
- Does Greddy make a differenct manifold than this?
- GT40 Question
- T78 Vs Gt35r...
- oil pooling in new bnr s4 turbo
- thinking of single conv. need honest answer
- going singlet-78,want to remove rat nest what should i leave?
- My GT42 dyno chart
- Question about full boost at partial throttle at lower rpm
- Are the T II turbo flanges the same on any garret turbo?
- GT42 front wheel One peice? or
- Aeromotive A1000 Mounting
- GT40R dyno chart
- which single turbo will suit me
- Turbo Wrap ?
- One for the experts
- Quick question about single turbos
- anibody with the a-spec gt35R with the t4 hot side? opinions
- How do I pressurize a Single Turbo system? (check for boost leaks)
- Vehicle Inspectors require blow off valve closed off
- Looking for a picture of a particular setup
- Ball bearing T70 too big for fd?
- Need to know the size of a fitting.
- Stock TII Blow Off Valve
- 50mm HKS yellow spring
- Compressor heat?
- HKS standered wastgate question
- Ebay ss t04 turbo..
- MY TSO4 parts on ebay ending soon!!!
- Turbo does not spool
- GT42(R) dynocharts?
- Just picked me up a manifold. tell me what you guys think.
- Engine Replacing Question
- A Positive Statement In This Forum
- O2 sensor mounting? Help please
- Coming along nicely...
- dyno'd today.
- We talkin' 'bout EGTs!
- How size matters. Compressor map illiterate? By Zero R
- Going Full TO4B on my AE
- WG help!!
- Fuel system questions
- Awesome info!!!!
- Single turbo vacuum diagram
- Ignition MSD# TII coil #
- Atmo BOV & engine life?
- Ct26
- Check out this turbo for me Please!
- opinions on this wastegate setup?
- new to rotary motors need advice about turbo setup.....
- so fresh and so clean
- helppppppppp
- manifold / DP fitment
- Where is your wastegate dumping?
- 247rwhp@12PSI Bone Stock TII Motor
- 650rwhp@32psi on a junked motor!
- Choosing the correct spark plugs after going single?
- HKS log manifold question
- HOLY CRAP! 28 psi boost spike on 91 octane & lives to tell about it.
- does 365 rwhp seem right for a T61 stock ports at 14 psi?
- T04E rwhp 278 @13psi
- Done with single.. high idle
- what happens when you prime your fuel system?
- Blocking off coolant and oil lines questions.
- Car wont start..flooding...help!
- Monster singelturbo!!!
- PFS Tuned T67 dyno #"s
- Need help sourcing SS mesh flexline exhaust tubing/pipe
- how many psi is safe for this setup ?
- 5 inch steel mandrel bends
- 417whp@15 but hurt motor
- need help picking a single
- HKS Racing wastegate flange part # or CAD drawing?
- Scatter Shield??
- Air filter for T78 ...limited space
- Apexi RX6
- What is the correct torque for the nut that retains the compressor wheel?
- Who sells turbo manifold gaskets?
- general question on swapping compressor to turn T04E into SC6152E
- T72 dynochart - 9psi and 15psi
- AF61r Efficiency Question
- Turboing Issues...
- What can i cut with the PFC
- good price on RE-Amemiya SS mani.?
- increasing the DP/MP size...is it worth it?
- single turbo kit!?
- T04Z vs. T51R
- HKS cast manifold
- The RIGHT SIZE post..hahahaha
- Fuel Pressure Stay At 20psi Help...!!!
- whats kinda power is this turbo good for? (to4 inside)
- Cracked Greddy manifold
- HKS standard wastegate
- I'll be putting my 60-1 in this weekend.
- Help me out, which turbo to go with, need some input quick!
- V-band flange gasket?
- welp i have a problem... expert advice needed
- v-band adapter question
- 600+HP "V8 Killer" / Crispeed Powered - Dyno sheet included
- V-Band Reducers, do they make them for my application?
- Need some help with turbo problems!!!
- Single Turbo P-Port or Twin Turbo P-Port
- Difference in Flanges....? T3, T4, Divided T4
- Ebay Turbo Kit, do or dont?
- turbo rebuild questions
- turbo selection for cosmo engine????
- Maps for single turbo
- flow rate - turbo II fuel pump
- engine life with 350-400whp?
- Oil pressure regulator for turbo feed line
- What size Turbo is this
- Metal Cat Melt Down
- QUICK oil drain question
- O-Ring failure - Considering Options (RX-6 vs 99 Twins)
- what size streetport with rx6 turbo..?
- Thoughts on wrapping exhaust header
- stand alone turbo oil system
- T04S ball bearing
- turbo question
- Fuel Upgrade .......
- what timing and split to aim for at around 30 psi
- PFS installed T67 Pics
- My Updated Dyno Numbers
- what bov you running with your single?
- Hi Flow Cat
- Running Ball Bearing
- Breaking tires loose at high speed
- oil in my gotham racing turbo question
- turbo set up
- Anyone using a GT40????? on the street
- Water and Air intercooler
- Crazy idea ...
- Building SS-Braided Turbo Oil Lines
- TII project: 350hp to the wheels
- Wastegate spring question.. are they special springs?
- MasterPower 60-1
- looking for 450hp what is the best turbo for that job?
- Building 400+ HP FD
- Turbo Caculator
- NEED PFC MAP stock fuel system with 11psi boost
- Air pump removed, now what?
- Turbo/Fuel Cut Problem
- Miight Be Selling My T-78 Turbo Not Kit
- i just install my custom T04 .60 but i only 4psi help
- where to get a .8-.125 oil reducer?
- custom single turbo kit question?
- Single Turbo Parts
- Chipped compressor wheel, rebalance?
- Best Turbo a can use to replace my TD0620G?
- Garrett GT40 on Ebay
- help me get my semi pp turbo to start
- Finding the Right turbo quesitons
- 397rwhp @16psi w/ GT35r, Stock Ports
- Who would be interested in this twin GT30R kit, pic inside
- T4 To T3 flange adapter
- 1300 secondaries and 550 or 850 primaries?
- Some pics of my custom twins
- Info req: HKS 50mm vacuum nipple
- Converting a Non-turbo?
- boost dropping after peaking at approx 5,500 rpms
- 379hp @ 1bar T04E
- 465 RWHP @ 22psi T04S
- im looking for someone named aaron cake i think
- Has anybody used Slip Fit connectors on a manifold?
- How much shaft play is acceptable?
- Can The T-78 Be Made Into A Bb Turbo
- More problems, need help. Searched
- Single Turbos can get good MPG
- T04b Fd
- Installed 2nd Fuel Rail now Surging idle?
- Single turbo reliablilty
- Picked up a load of T04's and need some info
- Problem intalling single, help please.
- K27 part number verses flow/hp(searched)
- pump gas ???
- aluminum tubing
- SAFC and a single.
- Which BOV (yes I searched)
- Anyone running a stock fuel system?
- 10 sec w/ r85 @ 22 psi
- new turbo manifolds
- Post a pic of your HKS T04S in here.
- rear end setup for 11s
- I need help installing secondary fuel rail!
- PT67 vs 62-1 Which Turbo...?
- NEW GT35R Setup from the RX-7store
- Which Garrett T72
- batterys ize question for single turbo
- bov valve placement
- waste gate boost line
- so I've been having bad boost creep recently...
- Lean out on Boost...
- Changing from a TD06 to a T78 or T88?
- *Video* of my 10.74 pass.
- Af61 ( Fc) Kit Installed
- Bosch 044 12x1.5 to AN10 outlet fitting
- What bolts do you use on your turbo
- Normal Temps? Intercooler Fan
- HKS racing blow off valve or TIAL
- what's the fastest quarter mile time by a t-78
- T04S on open exhaust?
- turbo decision