Fuel system questions
#1
Fuel system questions
I want your feedback on what pump to use. here are the 2 im lookin at.
Aeromotive A1000 600lbs which i know most people use. or should i get the aeromotive eliminator which is 800 lbs per hour. Before you answer here is my setup.
1990 T2
13 B re cosmo motor ported yes ported
Upgraded T78
720cc primary inj.
1600cc sec.inj
-10 braided will go from tank to the pump
-8 from pump to yblock
-6 from y block to each rail
-6 out of rails to reg then -6 return
also going to use the sump from summit
Im going to run around 20 psi but as high as 30.
Im using a micrtech ltx10s with a 3 bar map
Let me know if you think the basic a1000 wil work or i should go bigger just in case. thanks in advance for your input.
Rodney
Aeromotive A1000 600lbs which i know most people use. or should i get the aeromotive eliminator which is 800 lbs per hour. Before you answer here is my setup.
1990 T2
13 B re cosmo motor ported yes ported
Upgraded T78
720cc primary inj.
1600cc sec.inj
-10 braided will go from tank to the pump
-8 from pump to yblock
-6 from y block to each rail
-6 out of rails to reg then -6 return
also going to use the sump from summit
Im going to run around 20 psi but as high as 30.
Im using a micrtech ltx10s with a 3 bar map
Let me know if you think the basic a1000 wil work or i should go bigger just in case. thanks in advance for your input.
Rodney
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM