do you guys think that jetcoating the manifold would strengthen it? or does it just keep under-hood temps down?

 

Ceramic coating shouldn't do anything for strength. It's actually quite tricky to find a ceramic coating that will hold up on an exhaust manifold for a rotary as well.

Dale

 

I sell coatings that will last on any exhaust or motor application. I even do the inside of turbine housings and the turbine itself. These coatings actually rejection heat when done on the inside, therefor the chances of fatigue are greatly reduced. Underhood temperatures are vastly reduced to the products on the market, and its pretty obvious what the other effects on the motor and turbo are...

 

How much?

 

How much?

 

Sorry about the double post...I hate my computer!

 

I pm'd you guys. I might add I guarnatee these are the best coatings available on the face of the planet, gauranteed.

 

If you buy an SSAC manifold, have all of the welds redone, mine fell apart around 1,000 miles. Mine's OBX, but i hear SSAC is the same thing (i don't know for sure), they're both junk, i rewelded mine with a mig, it looks like trash, but it's never falling apart again.

 

Cryo them?

 

I might add I also make a very killer exhaust manifolds for many many different cars...





And before I start getting myself into trouble adversting, I have been trying to contact Boostd 7 for months about becoming a vendor no replies...

 

Shiny...

 

damn, if i didnt have the greddy cast, id like to have a nice tubular one from you.