- Motor Mavens Article about my 20B FD
- Frame collision specs
- Clutch pedal to the floor
- How To: Rear Fog Light in Taillights
- to slam or push hood closed?
- Compression when Cold
- Racing Harness install for FD3S
- installed PFC car wont start?? HELP
- fd rebuild
- Checking Ball Joints
- FD's don't run rich.
- NipponDenso vs Walbro 255
- Flooding and sparkplugs + some electrical
- Are all interioable at dealership?r parts still avail
- Implementing Series 8 rats nest into USDM FD's
- High-pitched turbo whine under vacuum: possible causes?
- My new engine!!!
- FJO Injector Driver Installation
- Pulsing idle :o
- OMP Declassified Part II
- Power steering loop line kit: where to buy??
- Shifter assembly question.
- Where does this plug go? if anywhere...
- Name that sensor
- Cold weather = hard to shift 1st and Reverse?
- do most engine builders port the exhaust ports?
- Headunit and Din Pocket
- passing emissions any info
- troubleshoot Fuel Level Sender
- Charge Relief/Air Bypass Valve help
- cfm calculation for intercooler dimensioning?
- koyo modifications for vmount setup
- Startup compression
- the first "my car is running perfect" thread ever
- Knock/Heat Light flickering on?
- Fuel feed to rail question.
- Car won't hook in 2nd Gear...
- Another boost issue question. Can anyone help?
- question about overheat
- Stuck in Accessory
- Ganador exhaust clips?
- Aem x wifi
- Can't stop coming back... but need surrogate for now
- Dipstick
- FD Modification Horsepower Gains
- Help: Starter Problem!
- Can you check over my fuel setup
- Dome light R1 removal
- FD startup/first idle problems.
- Cluster/Speedo Asisstance
- JDM parking (backup) sensor?
- 94 FD Fuel Issue
- Airbag light flashing
- n-flow rad on not n-flow
- headlight question
- Windshield Washer Tank - pump removal
- harness resistors
- Not-so-Mellow-Yellow '93 R1
- oil temp gauge reading 90-100C'... is it normal
- 850 cc in primary rails?
- Major fuel leak, please help
- Blitz Nurspec Type R 93+ RX-7
- Oil Color (same color as Cardboard)
- OMP Mounting Bolts. Size/Thread/Pitch?
- How to get out the rear seats?
- Koyo N-FLO (dual pass) radiator question
- Cables from center console to trunk?
- is it bad if my injector is missing this?
- cheap FD expensive fix
- What brand intercooler is this?
- Weird compression test results
- Clutch problem? maybe
- Made a video, removing uim
- Effects of an exhaust leak?
- 90mm Throttle body
- Where can I find engine bay dress up parts ?
- tiny box connector by igniter?
- Mikuni dual pump OMP
- hey everyone:) i need advice on getting a new starter
- old trust greddy 3 row intercooler issue.
- Idle issue
- Clutch troubles!
- Pop up lights and the insurance company
- Sad Day: Crash pictures
- Poor quality Mazda thermostats?
- Anyone use BOSCH filters?
- Very unusual boost problem
- OMP replacement and sensor q's? (CEL code 27)
- New intake setup - help
- constant power while cranking wire?
- Axle C-clip: Fitting in an aftermarket LSD
- Replacing broken rear window, do I need to order new seals too?
- Yet another Car won't start Thread
- Removed seat foam; uncomfortable and still not enough room
- Differential guru advice needed
- Exedy hyper single repair part number?
- need help on choosing right products for FD
- Spark Plug Wire Surprise
- Help! Major Electrical Issue!!!
- Help with Fuel System
- Swapped SMIC for larger unit - now slower??
- I'm a FD owner again.
- Ignition problem need help!!!
- curious
- Simplified Seq?
- Broken wire on coil harness?
- Probably blown but I am in denial... What do you think?
- Intake manifold gasket
- Revised EPA fuel economy ratings for the FD
- Replace or remove ast?
- I need to complete a partial underdrive pulley set.
- 93 FD only 20mph HIGHWAY?
- A/F ratio at idle on FD?
- Car is running like poop and I'm out of ideas
- octane issue
- Horns horns horns...
- To fix weak seal & ABS Control Unit?
- Exedy hyper single clutch / counterweight?
- Which gauge to buy?
- Ran with no oil , chances of potential damage?
- My battery is going to explode!!!
- Anyone ever FSM test the OMP/MOP pump?
- Green quality Gauges?
- My brakes are killing me
- Engine has been sitting for a year, UNSTARTED
- sunroof seal
- Does Odyssey PC680 battery cross reference to an Optima or others?
- CJ-Motorsports single 044 setup
- '95 ABS Unit in a '94 - pin out question. . .
- Braided power steer lines and oil cooler lines - anyone done them?
- what other parts can u take out after deleting the abs unit?
- What to ceramic coat/polish
- older 1600s, diffuser, o-ring, spacer which? pics included
- Making two crappy twins into one good one...
- Exedy hyper single clutch thickness
- massive fuel problems
- Brand new set of solenoids. All failed tests! Am i doing something wrong?
- JDM Motor?
- Changing The Twins.
- Tempted....yay or nay??
- Brand New FD RX7 - on sale in Germany
- Premix with apexi power fc, 2 eliminate oil injection
- check Engine light
- one piece coolant fill neck.
- First startup / Need advice
- Good Sites
- After months of sitting idle in the garage...
- Greddy turbo timer removal???
- Going Rate for Downpipe Removal?
- i need headlight covers
- oil smell like gas... please help
- trailing arm bushing removal
- difference between 1992 fd and 1993+
- Water temp sender location?
- Anybody changed their rack and pinnion?
- GReddy Turbo Timer help
- Spare set of twins!
- HKS Blow Off Valve Tuning
- just wanted to share my wire/ fuse tuck project
- stock primary fuel rail sealing question
- OMP Declassified
- need advice for fuel system
- bosch style fuel injector clip X male pig tail.
- JDM Vacuum line reduction
- Good source for fuel hose?
- JDM Fuel Cut
- Can I Disable the Antenna?
- 1993 Front Harness Annotated Connector Pictures
- Downpipe/Midpipe Combo
- BOV spring rates
- Installing Greddy Front Mount
- Connector help needed
- cheap bastard intake - my version
- Simplifying your engine bay
- differential bushings
- Right hand outside door handle troubleshooting (broken)
- help, no indicators
- Issues with counterweight - gen interchangeability
- Question about RX-7
- Fuel Cut CPU
- GReddy Hardpipes - Fitment Question
- am i cym or not....
- 92 RX7 problem
- T-56 trans question
- How often should you change your sparkplugs?
- Coolant Sensor question.
- Kg parts fuel system
- The case of the exploding muffler
- Gasket matching the UIM
- Looking for input/advise on Cosmo RE intake install on my REW
- Need pics of all original harness clips
- Oil leak: Oil pedestal or what? [Pictures]
- ECU plug layout (Searched)
- Pillow balls for the trailing link or trailing arm replace
- Unboxing: STRI gauges do NOT match the FD interior!
- Help: proper way to remove power steering
- Someone turned in a fd for cash for clunkers
- Startup idle problems....
- Fuel pump to line advice needed...
- sticker curiosity
- oil leaking!
- Feed Sonic SR Exhaust
- UK 20B N/A PP Build!
- 800hp Tranny?
- link to find part number
- Difference between the two dolphin tail mufflers?
- missing my (actuator turbo pre-control) twin turbo what do i do?!?!
- New engine, Boost/Fuel problems
- rotor housing good or bad?
- Nissan Quest / Mercury Villager Horn
- new Billet 90mm throttle body design by Rotary-Works
- Low Voltage Buzzing?
- South Florida Performance FMIC
- Help on Installing Re-Amemiya Boost Gauge
- 2 Quick questions on gauge install
- Any comments on Kouki Air Guides?
- Odometer not working
- oil suggestion please
- lowered AST won't allow me get coolant full
- Prosport Gauges Have Arrived!!
- 99+ Spec Models downpipe or precat?
- Is possible to get allot of fumes with aip pump & HF cat?
- 99 Spec Spoiler
- odd hmmmmm tone above 2k rpm
- Axiom Autosports
- Sparking when I try to ground the ignition coil harness. Cause?
- rear toe links dont fit??
- charge control valve diagnosis
- first fd vert ive ever seen
- Engine bay parts going in for powder coating - what colour?
- what could be causing this ?
- Is my air filter too small?
- Primary Turbo Oil Leak. Please help.
- Difference between jspec & usspec tranny
- Anyone know how much a rear-window Lexan conversion would cost on an FD?
- Fuel System issues: Ultimate fuel system with Denso pump
- FMIC with CX Racing Radiator Fitment?
- What does this vacuum hose do @ Primary Inlet Elbow? (pic)
- high and bouncing idle after vacuum hose job
- ACT 6-puck - A great clutch
- battery
- Help With New Rx7
- Picture Request: A-Spec Manifold/Dump
- hard time identifying connectors.
- Spark plug trailig and leading
- Rear Diff Issues.
- finally got a 93 jdm rx7 but have some work to do
- FlyRx7 Gauge Pods
- Bottom rear Engine Stud came out
- Recommendations for car parts for my 1992 fd