hi,
i am planing to fit a koyo n-flow rad. i found some complains about the n-flow setup and i would like to here your opinions or your exprience.
is it better or not?
how the air bleeding is done? is it posible or imposible? i assume that the more complicated water pasage makes imposible the right ait bleeding?
should i go for the standard without the n-flow?
thanks

 

I recommend that you look on the main page in this section before starting a redundant thread

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/koyo-n-flo-dual-pass-radiator-question-894363/