on my 93 fd I removed all emmissions using banzai block off plates and pineapple idler pulley, I used 330 ohm resistors for the plugs on the rats nest that aren't used anymore to prevent CEL, but the info I couldn't find is what do I do with the plugs that actually plugged into the air pump, AWS, etc? Do I just leave them unplugged or do I put the resistors on there as well? Ive researched extensively and can't find an answer. It's the plugs that go to the emmissions in the pics below---

 

Bump

any ideas??

 

Well, it depends what you are after. Leaving them unplugged will not hurt anything, but it will probably throw a CEL. It won't put it into limp mode or anything through. I have all my emissions stuff removed with out resistors since I had the same problem as you; I simply removed my CEL bulb in the cluster since I live in a state that doesn't test for emissions.