- Sway bar bushing replacement
- Water pump and clutch fan questions
- Need help bleeding clutch bought everything new.
- Replacing Bushings on Sway Bars, Tension Rods and Watts Link. Special tools needed?
- Brake And Axle Question
- Question on part names/Where to buy
- New carb jet organizer
- Does anyone know if RX8 subframes will work?
- Mystery Part Fell Out of Carb. What is it?
- Sticky Needle Valves. How long to wait, or is there a workaround?
- #2 choke diaphragm valve for 1980 12A
- 13B into 12A car - What motor mounts to use???
- Shopping List for 12A Engine Rebuild
- will 84 tank fit in 82
- How do I lower the rear
- Coolant leak post rebuild
- 80 ALC switch
- 1984 mazda rx7 gsl se
- Panel between headlights
- SA to FC Wheels with a Spacer.
- Headlights just stopped retracting
- Rubber Control Arm Bushings?
- Anyone know where to get a fuel tank
- 1984 rx7 gsl se air conditioner
- Nikki carb mystery vacuum connections
- Can I put 80 ignition on my 82
- GSL-SE Apex Seals NLA???
- Headlight help
- Does anyone know if a 86 floorpan will fit an 82
- Need tips on rebuilding
- Fuse box and rear hatchback plastic piece
- How do I tell if my rotary is safe to start
- anyone know the air dam and side skirt?
- 1st Gen Body Kit
- Need a floorpan
- Back on the road! HUGE thanks to those website and the people on it.
- 85 brake booster
- Check Brake warning light checker
- Brake question
- Trick to help diagnose and run experiments on flooding carb
- Is a FB a good first rotary to work with?
- Have a 1980 RX7 Convertible - Is it worth anything ?
- 13-inch tires. We are down to these...??
- Installing adjustable shocks on my SA
- 12A refuse to start: unsolved; ignition.
- Dumb question. Gas visible at float chamber with ignition on?
- VSS retrofit for 79 5 speed MT
- rear break line leaking
- Help Diagnosing rebuilt Nikki Carb
- OEM vs aftermarket needle valves and seats
- S5 Alternator Battery Drain
- What the hell is with the gap
- Beeping from dash.
- Source for Nikki main jet, and do I use the washer?
- Throttle Shaft to OMP linkage
- Did premix prices go up?
- Paging all you Nikki carb gods
- Squealing noise at 3000 rpm? Belts/water pump/clutch?
- Front spindle and brake upgrade?
- Restoring the Kenya car
- Coolant Temperature Sensor Faulty?
- 12A Stalls When Blipped. Help with Diagnostics.
- Hard to find parts
- Carburetor Tuning Issues
- Cranking but not starting
- Rear Suspension: Straight UCAs
- 83 Engine Oil Cooler
- 12a won’t start
- No Power to Fuel Pump
- Cracked pipe to cat. Still drivable?
- Temps on hot day
- weird problem bleeding brakes
- Lift support points
- Please help! (Fb Rx7 Gs 1984 automatic trans)
- Racing Beat Headers
- First gen (79) chassis power capabilities
- Weber DCOE tuning Procedure
- Fuel tank opinion
- Oil Pan. How to repair, or where to source a replacement?
- Its ALLLIIIIIIIIVVVE!!!!! Thanks to all on RX7Club.
- 12A dies after warming up (1981 FB)
- First Start of Rebuilt. Which way does idle adjust screw turn?
- queation about carb spacer on an 80, 12A
- Cooling issue/questions
- No oil pressure after rebuild. Help me avoid having to pull off front cover again!
- Radiator Express. Thread Pitch for Coolant Level Sensor?
- Clip that holds wire to pil pressure sender. How complex is it?
- 12a omp lines a lil old need new ones
- Charging System Issues
- Leaky water pump. The dreaded gland?
- Me Again! How to crank engine without having it start?
- Almost done! Last day wiring questions.
- First post - bringing a 12A back to life
- GSL-SE random misfire solved!
- Road-trip FB for <$5000?
- Question on mating different trans to 13b
- 1979 rx7
- Air pump C shaped spacer.
- In need of advice
- Left over spring from rebuild. Last cry for help / detective work.
- Hose From Air Pump to Intake
- Hose Connections to Underside of Air Cleaner
- 80 coils with updated ignition?
- Ragged idle (84 FB, M/T)
- Anyone know where this goes?
- FC oil cooler in 79?
- What is this reservoir for?
- Headlight seem very dim... need advice.
- Dome light issues
- Idle rpms dropping when going into gear
- Random low idle and loss of power (12A Weber DCOE)
- Help finding a certain Kit
- Exhaust setup help
- Can I see your dash cluster?
- Vapor Honing
- Distributer Question
- Front Cover Bolt Specs
- Assorted 'about to reinstall a rebuilt engine' questions from a newbie.
- 13b 6al won't start
- 13B 6 Port Actuators
- Heavy smoke on Decel from high rpms
- ac lines
- J-pipe on rotary reduce drone?
- Slave cylinder matching
- Mazda Rx7 Limited Edition Owners
- Gsl rear brake replacements? NLA parts solutions.
- Rebuilt Engine. Cannot be Rotated by Hand. Checking my Conclusions and Way Forward.
- Timing Needle Missing
- 12a engine on Sandrail
- Anti-after burn valve
- Replace engine mounts in a 1.gen? S5 engin mounts.
- 12A dies under electrical load
- Pretty Interesting Car on BaT
- what are the holes in the roof's side posts for?
- 1981 fuel tank issue
- Took off flywheel and found leak at rear stationary gear....
- 1985 GSL-SE Efan
- Engine rebuild. Possible to test compression and oil pressure before reinstall?
- What Gen should I buy?
- 85 Rx7 gsl swap in a S5 turbo 2 engine and gearbox. Tips? 😊
- Clarification on GSLSE ignition timing
- Leaking oil pan
- Can this Intermediate Housing be Resurfaced?
- Radio and cassette buttons turning green
- 1983 RX-7 GSL - Engine Swap Survey
- Leaking oil pan right by omp
- Searching for my old first gen
- In-Tank Surge Tank
- Rx7 euro rally car..msd??
- Help me sort out my suspension
- Racing beat springs with custom camber plates
- Need help with appraisal.
- JDM 4 port rx8 into 1985 GSL-SE
- Any damage after alternator belt snapped?
- Tow hooks with aftermarket bumpers - what are you using?
- Se and gsl axles interchangeability
- What makes a 5 letter a 5 letter?
- No spark on lead plugs
- Carburetor Tuning after rebuild
- Carb Gasket Between Throttle Body and Main Body
- Radiator Options for 79 Rx7
- Deleted heater core rear housing coolant block off solution
- Front suspension knocking after replacing struts, bushings, etc
- first start rebuild in freezing cold weather.
- Need k&n air intake for first gen
- Cleaning Irons, Housing and Rotors... Checking my Research on Cleaning Materials.
- Mazda rx7
- Torque specs?
- 13b wanted
- gracing short shifter on fb
- Carb issue and no access to manual
- Anti Afterburn valve #1 question
- Doesn’t start after engine rebuild
- Nikki carburettor flooding
- Need help boosting an 89 sp motor
- Runs bad at operating temp
- Testing oil pressure test kit
- 1987 1st generation cranks but no start, help
- Re Mags
- Rx7.com anybody ever order there ?
- Almost there...
- [REFERENCE] Ring & Pinion Pictures 4.07 / 3.93 / 3.90 / 4.77
- Fuel Leak at Exhaust
- Hookup Rat's Nest-Runs on one rotor
- Silicon Hose kit from second gen used on first gen
- GSLSEforme - may he RIP
- FB RX7 Manual Vs. Auto Intake Manifold Differences?
- Half bridge 12a carb suggestions(track car)
- Speedometer gear
- Big Brake Kit
- Restoration of courtesy light
- 5 Letter Revival
- CP Racing Rack & Pinion Conversion
- Heat riser hose
- Gsl Meaning?
- Rota RKR wheel sizes
- Car tried to start. ... with no key in ignition!!
- Trouble starting rebuilt 12a and timing
- Windshield wiper motor ain’t working ?
- revisiting coil options in 2021
- Aftermarket Tie Rod Ends
- Mysterious Battery Drain. Double check my conclusion?
- RPM Switch Help
- Cassette Player Problems
- Aftermarket wheels
- Music System
- 1980 Just showed up at Pick Your Part
- Stupid coolant flush problem - need advice
- GSL-SE 13B engine removal
- Looking for someone who is able to upgrade a nikki
- Rx7 FB idler arm sources
- LSD Clutch Pack Question - Far into the weeds
- Dif fluid level
- Major or deadly mistake?
- Difference between the GSL and GSLSE left side ebake cable?
- AC parts for S5 swapped GSL-SE
- Synthetic oil for a year then back to conventinal
- Renewable lubricants oil and premix
- 1980 wiring harness + distributor
- 20w50 vs 10w30
- Holley 450 to stock ported Nikki intake manifold.
- Driveshaft lengths compatibility
- Engine rebuild questions
- Windshield wipers won’t stop
- Capacitor looking thing on top inspection plate 12A
- Have Holley carb no intanke
- Are "SA" brake Boosters NLA >?
- Engine almost died randomly
- exhaust
- Aftermarket Temp gauge
- BWaits
- One oil line came off the Nikki carb. Should I panic?
- Help pulling the heater core
- Ignitors for 1985 RX7 GSL-SE
- Should I panic?!
- Nikki vac secondaries not opening after rebuild
- Master cylinder options
- SA tranny fill question
- Unknown connectors.
- Exhaust studs
- A Rear Bearing, The Differential, or Both?
- Clutch skeeps loosing compression and falling to floor
- 1979-1980 evap hardline from carb air lid to filler neck
- Friends 1st gen Rx7 12a streetport premixed with super tech tcw3
- FC subframe swap 2021 - revisited with pics and measurements
- OEM Watts Link Bushing Source
- FB Manual swap
- Hatch Struts
- nikki A/T M/T options
- Oil Sump: to paint or not to paint inside